Laser Welding of 422 Stainless Steel with Inconel 625 Filler Metal
スポンサーリンク
概要
- 論文の詳細を見る
Laser welding of Type 422 stainless steel (SS) with Inconel 625 filler metal additions was investigated. Tensile, impact, and fatigue crack growth tests were performed on laser welds and 422 SS base plates as well. The soft zone, consisting of ferrite with extensive M23C6 carbides at grain boundaries, was observed in the heat-affected zone (HAZ) adjacent to the weld interface of 700°C/2 h tempered welds. The existence of soft zone in the weld was detrimental to impact toughness and caused brittle fracture at room temperature. Nevertheless, such a deteriorated effect was less severe at elevated temperatures. Either the soft zone or the weld metal (Inconel 625) did not affect the strength of welds in tensile tests. Consequently, the fracture location of laser-welded specimens was in the base metal at both 25 and 540°C. The fatigue crack growth rates (da/dN) in the weld metal and HAZ of the weld after tempering were less than those of the 422 SS base material for similar ΔK ranges. The retardation in da/dN was obvious at low ΔKs for the weld tempered at 700°C/2 h. Such retardation became very significant and an accelerated da/dN in the HAZ was resulted if the tempering treatment was not performed on the weld.
- 社団法人 日本鉄鋼協会の論文
- 2004-05-15
著者
-
Chen C.
Department Of Aeronautics And Astronautics National Cheng-kung University
-
YANG T.
Department of Mechanical Engineering, National Pingtung University of Science and Technology
-
Chen C
Department Of Materials Science And Engineering National Taiwan University
関連論文
- Interaction of a Steady Plasma Stream with a Rotating Dipole Magnetic Field
- Rotational Injection of the Plasma into the TBS Magnetic Field
- On the Region of Adiabatic Confinement of Plasma in the TBS Type Magnetic Field
- The Stability of the High-β Plasma in the TBS-Field about the Cusp-Axis
- Confinement of Plasma by Means of T. B. S. Type Magnetic Field
- Some New Evidence for Polymorphism in Cold-Crystallized and Melt-Crystallized Poly(ether ether ketone)
- Reducing flow induced building vibration by streamlining
- The wind features of Taipei 101 Financial Building
- Confining Region of Plasmas in a TBS-Field on the Cusp-Plane
- Turbulent Heating of Plasma in a TBS-Field
- High Performance Sub-0.1μm Dynamic Threshold MOSFET Using Indium Channel Implantation
- 表面に近い三次元き裂の応力拡大係数におけるVライン応力外挿法の有効範囲(機械工学科,工学部創設40周年記念号)
- The novel method to improve electrical characteristics of p-type GaN by using Ni catalysis
- Nitride-based light emitting diode and photodetector dual function Devices with InGaN/GaN multiple quantum well structures
- Low Temperature Magnetic Study in NiFe-Al-NiFe and Co-Al-NiFe Double Tunneling Junction Devices
- OE-278 Role of SHP2 in Homocystein-induced Epidermal Growth Factor Receptor Transactivation and Endothelin-1 Expression in Aortic Smooth Muscle Cells(Hypertension, basic-1, The 71st Annual Scientific Meeting of the Japanese Circulation Society)
- Stability of UV-Type Two-Domain Wide-Viewing-Angle Liquid Crystal Display
- TED-AJ03-104 A PARALLEL DOMAIN DECOMPOSITION APPROACH FOR SOLVING DIFFUSSION EQUATIONS USING THE METHOD OF FUNDAMENTAL SOLUTIONS
- New Mechanisms and the Characterization of Plasma Charging Enhanced Hot Carrier Effect in Deep-Submicron N-MOSFET's
- STUDYING THE UNSTEADY, THREE-DIMENSIONAL CHARACTERISTICS OF FLOW REATTACHMENT(Separation and Reattachment)
- Selective deposition of gold nanoparticles on the oxide surface of Si nanowire
- Systolic Realization of Cyclic Wavelet Transforms and Cyclic Wavelet Packet Transforms (Special Section on Digital Signal Processing)
- Frequency Dependence of Current Relaxation Time in an Electron-Impurity System
- The Development of Oligonucleotide Micro Array Detecting System
- The 1/f^2 Noise Spectrum Derived from Electromigration-Induced Resistance Change
- Laser Beam Welding of 2205 Duplex Stainless Steel with Metal Powder Additions
- Simultaneous determination of imipramine, desipramine and their 2- and 10-hydroxylated metabolites in human plasma and urine by high-performance liquid chromatography
- Determination of naringenin and its glucuronide conjugate in rat plasma and brain tissue by high-performance liquid chromatography
- Flow patterns and wall stresses in a moving granular filter bed with a curved symmetric louvered wall
- The effect of a flow corrective insert upon flow patterns and wall stresses in a two-dimensional bin-hopper
- AC Power Loss and Signal Coupling in Very Large Scale Integration Backend Interconnects
- Growth of III-V epitaxial material on Si Substrates for high-speed electronic applications
- Laser Welding of 422 Stainless Steel with Inconel 625 Filler Metal
- Modeling of Complex Flows and Heat Transfer
- Long-distance propagation of ionospheric disturbance generated by the 2011 off the Pacific coast of Tohoku Earthquake
- Acoustic resonance and plasma depletion detected by GPS total electron content observation after the 2011 off the Pacific coast of Tohoku Earthquake
- Notched Tensile Fracture of Ti-6Al-4V Laser Welds at Elevated Temperatures
- Experimental and Theoretical Demonstration on the Transport Properties of Fused Ring Host Materials for Organic Light-Emitting Diodes
- HISTOCHEMICAL STUDY ON RIBOFLAVIN
- Excess Fluoride Interferes with Chloride-channel-dependent Endocytosis in Ameloblasts
- Effect of Sn on the Superconductivity of the DyBa2Cu3O7-δ System