Detection of 8 nm Diameter Superparamagnetic Beads by Magnetically-Induced Manipulation of Micrometer-Sized Magnetic Beads: A Novel Protocol for Magnetically-Labeled Biosensing
スポンサーリンク
概要
- 論文の詳細を見る
Biosensing platforms based on functionalized superparamagnetic beads acting as “magnetic-labels” show tremendous potential for rapid and highly-sensitive point of care medical diagnosis. Recently, for greater quantification, there are increasing demands for the use of magnetic labels with diameters of 8–150 nm, which are comparable in size to actual biomolecules. However, detection of small numbers of sub-150 nm sized magnetic beads by magnetoresistive device-based platforms is extremely challenging due to the intrinsic noise of these electronic devices. Here, we describe an easy and economical detection method of low areal densities of 8-nm-diameter superparamagnetic “target beads” immobilized over millimeter-sized substrates by optically monitoring the magnetically induced “capture” of easily visible, micrometer sized superparamagnetic “columnar beads” by the targets in less than a few tens of seconds.
- 2010-04-25
著者
-
Park Sang
Department Of Anatomy Seoul National University College Of Medicine
-
Morimoto Yoshitaka
Department Of Applied Chemistry Faculty Of Engineering Osaka Institute Of Technology
-
Adarsh Sandhu
Department of Electrical and Electric Engineering, Tokyo Institute of Technology, 2-12-1 O-okayama, Meguro, Tokyo 152-8552, Japan
-
Hiroshi Handa
Integrated Research Institute, Tokyo Institute of Technology, 2-12-1 O-okayama, Meguro, Tokyo 152-8552, Japan
-
Takamura Tsukasa
Department of Electrical and Electric Engineering, Tokyo Institute of Technology, 2-12-1 O-okayama, Meguro, Tokyo 152-8552, Japan
-
Satoshi Sakamoto
Graduate School of Bioscience and Biotechnology, Tokyo Institute of Technology, 4259 Nagatsuta-cho, Midori-ku, Yokohama 226-8501, Japan
-
Shintaro Kawata
Graduate School of Bioscience and Biotechnology, Tokyo Institute of Technology, 4259 Nagatsuta-cho, Midori-ku, Yokohama 226-8501, Japan
-
Yoshitaka Morimoto
Department of Electrical and Electric Engineering, Tokyo Institute of Technology, 2-12-1 O-okayama, Meguro, Tokyo 152-8552, Japan
-
Tsukasa Takamura
Department of Electrical and Electric Engineering, Tokyo Institute of Technology, 2-12-1 O-okayama, Meguro, Tokyo 152-8552, Japan
関連論文
- The expression of transferrin binding protein in the turtle nervous system
- B15 UI Trend forecast of the Korean home appliances : An analysis of dynamic changing Korean home appliances UI with Road map and research about future trend foreast
- Expression of Perilipin and Adipophilin in Nonalcoholic Fatty Liver Disease ; Relevance to Oxidative Injury and Hepatocyte Ballooning
- B-4-3 ANALYSIS OF CROSSTALK BETWEEN MICROSTRIP LINES IN ARBITRARY DIRECTIONS ON DIFFERENT LAYERS
- B-4-67 COUPLING ANALYSIS FOR PARTIALLY PARALLEL LINES OF A STRAIGHT AND BENT LINES
- Inhibition of Lipopolysaccharide-Induced Expression of Inducible Nitric Oxide and Cyclooxygenase-2 by Chiisanoside via Suppression of Nuclear Factor-κB Activation in RAW 264.7 Macrophage Cells(Pharmacognosy)
- Nuclear Magnetic Resonance Study of Complexes between CRP and Its 22-and 28-Base-Pair Operators^1
- B-4-33 EXPERIMENTAL ANALYSIS OF TRANSMISSION CHACTERISTICS OF BENT LINE
- Change of glutathione S-transferases in the skin by ultraviolet B irradiation
- Analysis of Crosstalk between Finite-Length Multiconductor Transmission Lines on a PCB by Using Circuit-Concept Approach(Printed Circuit Boards, 2004 International Symposium on Electromagnetic Compatibility)
- Comparative evaluation of segmentation methods for bronchial tree in the lung parenchyma
- MUTATIONS OF THE TYROSINASE GENE IN THREE KOREAN PATIENTS WITH TYPE I OCULOCUTANEOUS ALBINISM
- Speculative Branch Folding for Pipelined Processors(Computer Systems)
- B14 A Study on Developing Form for UI Roadmap : UI Roadmap for Eight Korean Home Electrical Appliances
- Efficient Quenching of the Fluorescence of Aromatic Guests by β-Cyclodextrin-Tethered Viologens via Inclusion Complexation
- Comparison of corpus callosotomy and vagus nerve stimulation in children with Lennox-Gastaut syndrome
- Surgical treatment of two patients with infantile spasms in early infancy
- Improving Accuracy of Airway Wall Thickness in MDCT Using a Deconvolution Technique : A Swine Phantom Study(International Forum on Medical Imaging in Asia 2009 (IFMIA 2009))
- The hair growth promoting effect of ascorbic acid 2-phosphate, a long-acting Vitamin C derivative
- Cloning and Identification of a New Antimicrobial Protein, Salvic, from Human Salivary Gland(International Symposium of Maxillofacial and Oral Regenerative Biology in Okayama 2005)
- Evidence of a Novel Dipeptidyl Aminopeptidase in Mammalian GH_3 Cells: New Insights into the Processing of Peptide Hormone Precursors
- Immunocytochemical Analysis of Peptide Hormone Processing: Importance of the Positively Charged N-terminal Domain of Signal Peptide in Correct ER Targeting in Yeast Cells
- Topogenic Effect of Positively Charged N-terminal Amino Acid in ER Translocation of Yeast α-Factor Precursor
- Effects of Tin Concentration on the Electrical Properties of Room-Temperature Ion-Beam-Assisted-Evaporation-Deposited Indium Oxide Thin Films : Surfaces, Interfaces, and Files
- New Oleanene Glycosides from the Leaves of Acanthopanax japonicus
- EARLY GONADOGENESIS AND SEX DIFFERENTITION OF BAGRID CATFISH, Leiocassis ussuriensis
- P-11 The Effect of Combined Exercise on Health related Fitness, Resistin Concentration in Middle Aged Obese Women(Proceedings of the 55th Meeting of Japan Society of Physiological Anthropology)
- P-10 The Effects of Combined Exercise on Abdominal Fat, Adiponectin and TNF-a Concentration in Middle Aged Obese Women(Proceedings of the 55th Meeting of Japan Society of Physiological Anthropology)
- Effect of combined exercise training on bone, body balance, and gait ability : a randomized controlled study in community-dwelling elderly women
- Preparation of Highly Ordered Mesoporous TiO_2 Materials with Crystalline Framework from Different Mesostructured Silica Templates via Nanoreplication
- In vivo kneeling biomechanics after posterior stabilized total knee arthroplasty
- Closed Loop Quasi-Orthogonal STBC Using Code Selection with Single-Phase Feedback
- 4-1) CHARACTERIZATION AND EXPRESSION OF RAD_4 GENE INVOLVED IN NUCLEOTIDE EXCISION REPAIR OF UV-DAMAGED Saccharomyces cerevisiae
- Maximum Likelihood Estimation of Integer Frequency Offset in OFDM Systems(Wireless Communication Technologies)
- TED-AJ03-187 TURBULENT HEAT TRANSFER IN A SYMMETRIC EXPANSION PLANE CHANNEL
- Pilot Patterns for OFDM Communication Systems in a Fast Time-Varying Channel(Wireless Communication Technologies)
- Characterization of Wheel Surface Topography in cBN Grinding(Advanced Manufacturing Technology [I])
- Characterization of Wheel Surface Topography in CBN Grinding(CBN grinding technology)
- Cloning and Sequencing of pel Gene Responsible for CMCase Activity from Erwinia chrysanthemi PY35
- Establishment of SV40T-transformed human dermal papilla cells and identification of dihydrotestosterone-regulated genes by cDNA microarray
- Cell Adhesion Scaffold Using Self-assemble β-strand Peptides
- Effect of different anesthetic agents on oculocardiac reflex in pediatric strabismus surgery
- Unilateral Xanthelasma Forming a Kissing-Like Lesion
- REGULATION OF DNA DAMAGE INDUCIBLE RHP51^+ GENE, A rec A HOMOLOG FROM SCHIZOSACCHAROMYCES POMBE
- Built up os Stimulus-responsive Hydrogels using Self-assembling β-hairpin Peptides
- Evaluation of Thermally Responsive De Novo Peptides
- Cellulose Production by Acetobacter xylinum BRC5 under Agitated Condition
- Frequency Detuning and Stabilization of a Diode Laser Using the Zeeman Shift of the Saturated Absorption Signal of Rubidium Atoms
- Planar Microfluidic System Based on Electrophoresis for Detection of 130-nm Magnetic Labels for Biosensing
- Formation Mechanism of Finished Surface in Ultrahigh-Speed Grinding with cubic Boron Nitride (cBN) Wheels(Advanced Manufacturing Technology [I])
- Profile Grinding of Superalloys with Ultrafine-Crystalline cBN Wheels(Advanced Manufacturing Technology [I])
- Profile Grinding of Superalloys with Ultrafine-Crystalline CBN Wheels(CBN grinding technology)
- Formation Mechanism of Finished Surface in Ultra-High Speed Grinding with CBN Wheels(CBN grinding technology)
- Effects of Uniformity in Wheel Structure on Grinding Characteristics of Vitrified CBN Wheels(CBN grinding technology)
- Photoluminescence Properties of Eu3+ Activated CaMoSiO4 Red Phosphor by Combustion Method
- A Biometrical Study on the Growth Factors in Gerris (Aquarius) elongatus (U.) (Hemiptera, Gerridae)
- Proactive Time-Rearrangement Scheme for Multi-Radio Collocated Platform
- Effects of Molybdenum Doping on the Layered Li [Ni_Mn_Mo_x] O_2 Cathode Materials for Lithium Secondary Batteries
- Analysis and Contfol of a Flexible Robot Arm by Using Experimental Modal Analysis
- Trends in the incidence of benign pathological lesions at partial nephrectomy for presumed renal cell carcinoma in renal masses on preoperative computed tomography imaging : A single institute experience with 290 consecutive patients
- Detection of 8 nm Diameter Superparamagnetic Beads by Magnetically-Induced Manipulation of Micrometer-Sized Magnetic Beads: A Novel Protocol for Magnetically-Labeled Biosensing
- Preparation of ZnSe Nanocrystals Using Water-in-Oil Microemulsions
- Isolation and Characterization of the Promoter Region of the Rat DNA Topoisomerase IIα Gene
- B1 Study on Accuracy Compensation of Machining Center Based on Measurement Results of Machined Workpiece : Evaluation of Accuracy of 5-axis Controlled Machining Center(Advanced machine tool)
- A Survey of the Subjective Quality of Life of Clinical Physical Therapists and Factors Affecting Their Work Satisfaction Factors
- Effect of EDTA treatment on the hybrid layer durability in total-etch dentin adhesives
- Presence of Ideomotor Apraxia in Stroke Patients with Pusher Syndrome
- Adaptive changes in cellualar redox potential and glutathione status by chronic ethanol feeding
- A-15-7 A Study of Rapid Prototyping of Facial Makeup Styles
- Activation of Vasculogenic Progenitor Cells by ent-16.ALPHA.,17-Dihydroxy-kauran-19-oic Acid
- Control of Ga Distribution in Cu(In,Ga)Se2 Photovoltaic Absorber by Solid-State Selenizatoin of CuGa/In/Se/In/CuGa Stack
- Correlation between Assessments of Arm and Leg Ideomotor Apraxia in Hemiplegic Stroke Patients
- Optical Properties of Silica-Encapsulated ZnSe Nanocrystals Prepared with Water-in-Oil Microemulsions
- Ultrasonically Enhanced Effectiveness of Various Surfactants on Diesel Removal from Contaminated Soil
- Patterning of Two-Dimensional Graphene Oxide on Silicon Substrates
- A Computational Study on the Separation of Acetonitrile and Water Azeotropic Mixture Using Pressure Swing Distillation
- 2P4-10 各種界面活性剤を用いた汚染土壌の浄化に対する超音波照射増強効果(ポスターセッション)
- Enhanced Readout Signal of Elliptic-Bubble Super Resolution Near Field Structure by Temperature-Dependent Complex Refractive Index of Phase-Change Medium
- Cerebral Cavernous Malformations:Serial Magnetic Resonance Imaging Findings in Patients with and without Gamma Knife Surgery
- Dielectric Relaxation of Al-Doped BaTiO3
- Chemical Mechanical Polishing for Oxygen Free Copper with Manganese Oxide Abrasives
- Ultrasonically Enhanced Effectiveness of Various Surfactants on Diesel Removal from Contaminated Soil (Special Issue : Ultrasonic Electronics) -- (Nonlinear acoustics, high power ultrasound, sonochemistry)
- Metabolomics for the Quality Assessment of Lycium chinense Fruits
- Determination of diffusion coefficients of metals dissolved in mercury by double potential step chronoamperometry at hanging mercury drop electrodes.