Patterning Properties of Indium–Tin Oxide Layer Depending on the Irradiation Conditions of Nd:YVO4 Laser Beam

概要

論文の詳細を見る
A Q-switched Nd:YVO4 laser ($\lambda = 1064$ nm) with a galvanometric scanning system was used for the direct etching of an indium–tin oxide (ITO) film on a glass substrate. The etching properties of the ITO film depending on a pulse repetition rate were investigated. At a low pulse repetition rate of 10 kHz, the etching selectivity of ITO to soda-lime glass was poor, so that the glass substrate was also etched. In addition, the larger spot size formed at a lower repetition rate resulted in more severe ripples along the etched ITO line. In this experiment, it was shown that a pulse repetition rate higher than 40 kHz was adequate for the etching of an ITO film with a thickness of 1,200 Å on soda-lime glass. In particular, the larger spot size formed at the lower repetition rate resulted in more severe ripples along the etched ITO line. In our experiment, a 40 kHz repetition rate at a scanning speed of 500 mm/s was suitable for the formation of plasma display panel (PDP) bus electrodes.
Published by the Japan Society of Applied Physics through the Institute of Pure and Applied Physicsの論文
2008-09-25