Core radial power profile effect on system and core cooling behavior during reflood phase of PWR-LOCA with CCTF data.
スポンサーリンク
概要
- 論文の詳細を見る
In the reactor safety assessment during reflood phase of a PWR-LOCA, it is assumed implicitly that the core thermal hydraulic behavior is evaluated by the one-dimensional model with an average power rod. In order to assess the applicability of the one-dimensional treatment, integral tests were performed with various core radial power profiles using the Cylindrical Core Test Facility (CCTF) whose core includes about 2, 000 heater rods. The CCTF results confirm that the core radial power profile has weak effect on the thermal hydraulic behavior in the primary system except core. It is also confirmed that the core differential pressure in the axial direction is predicted by the one-dimensional core model with an average power rod even in the case with a steep radial power profile in the core. Even though the core heat transfer coefficient is dependent on the core radial power profile, it is found that the error of the peak clad surface temperature calculation is less than 15 K using the one-dimensional model in the CCTF tests. The CCTF results support the one-dimensional treatment assumed in the reactor safety assessment.
- 一般社団法人 日本原子力学会の論文
著者
-
Akimoto Hajime
Japan Atomic Energy Agency
-
MURAO Yoshio
Japan Atomic Energy Research Institute
-
Iguchi Tadashi
Japan Atomic Energy Research Institute Department Of Reactor Safety Research
-
IGUCHI Tadashi
Japan Atomic Energy Research Institute
関連論文
- ICONE11-36298 SYSTEM PRESSURE EFFECT ON DENSITTY-WAVE INSTABILITY : SIMPLIFIED MODEL ANALYSIS AND EXPERIMENTS
- Effect of Rod Bowing on Critical Power Based on Tight-Lattice 37-Rod Bundle Experiments
- Gap Width Effect on Critical Power based on Tight-Lattice 37-Rod Bundle Experiments
- Pressure Drop Experiments using Tight-Lattice 37-Rod Bundles
- Critical Power Experiment with a Tight-Lattice 37-Rod Bundle
- Critical Power Characteristics in 37-rod Tight Lattice Bundles under Transient Conditions
- An Improved Critical Power Correlation for Tight-Lattice Rod Bundles
- Critical Power Correlation for Tight-Lattice Rod Bundles
- Critical Power in 7-Rod Tight Lattice Bundle(International Conferences on Power and Energy System)
- ICONE11-36099 CRITICAL POWER CHARACTERISTICS OF TIGHT LATTICE BUNDLES
- A Concept of Passive Safety Pressurized Water Reactor System with Inherent Matching Nature of Core Heat Generation and Heat Removal
- Applicability of REFLA/TRAC Code to a Small-Break LOCA of PWR
- Pressure Drop Characteristics in Tight-Lattice Bundles for Reduced-Moderation Water Reactors(International Conferences on Power and Energy System)
- ICONE11-36172 EVALUATION OF CRITICAL HEAT FLUX OF TIGHT LATTICE CORE WITH SUBCHANNEL ANALYSIS CODE NASCA
- ICONE11-36098 PRESSURE DROP CHARACTERISTICS IN TIGHT-LATTICE ROD BUNDLES FOR REDUCED-MODERATION WATER REACTERS
- PREDICTED THREE-DIMENSIONAL BUBBLY AND LIQUID FILM FLOW BEHAVIOR IN NARROW FUEL CHANNELS(Liquid Flow)
- ICONE11-36097 DEVELOPMENT OF MECHANISTIC BOILING TRANSITION MODEL IN ROD BUNDLES
- ICONE11-36452 EXPERIMENTAL STUDY ON COOLING LIMIT UNDER FLOW INSTABILITY IN BOILING FLOW CHANNEL
- Application of PSA Methodology to Design Improvement of JAERI Passive Safety Reactor(JPSR)
- Transient Analysis for Design of Primary Coolant Pump Adopted to JAERI Passive Safety Reactor JPSR
- Possibility of a Pressurized Water Reactor Concept with Highly Inherent Heat Removal Following Capability
- Evaluation on Driving Force of Natural Circulation in Downcomer for Passive Residual Heat Removal System in JAERI Passive Safety Reactor JPSR
- FLOW VISUALIZATION OF A WAKE STRUCTURE AROUND THIN PLATE BY USING DYNAMIC PIV SYSTEM(Measurement)
- Model Development for Bubble Turbulent Diffusion and Bubble Diameter in Large Vertical Pipes
- Numerical Investigation of Heat Transfer Enhancement Phenomenon during the Reflood Phase of PWR-LOCA
- Development of Design Technology on Thermal-Hydraulic Performance in Tight-Lattice Rod Bundles: III - Numerical Evaluation of Fluid Mixing Phenomena using Advanced Interface-Tracking Method -
- Development of Design Technology on Thermal-hydraulic Performance in Tight-lattice Rod Bundles: V-Estimation of Void Fraction
- Development of Design Technology on Thermal-Hydraulic Performance in Tight-Lattice Rod Bundle: IV Large Paralleled Simulation by the Advanced Two-fluid Model Code
- Numerical Investigation of Cross Flow Phenomena in a Tight-Lattice Rod Bundle Using Advanced Interface Tracking Method
- Downcomer effective water head during reflood in postulated PWR LOCA.
- Assessment of current safety evaluation analysis on reflood behavior during PWR-LOCA by using CCTF data.
- Experimental study of ECC water injection rate effects on reflood phase of PWR-LOCA.
- Experimental study of initial downcomer water accumulation velocity effects on reflood phase of PWR-LOCA.
- Assessment of core thermo-hydrodynamic models of REFLA-1D code with CCTF data for reflood phase of PWR-LOCA.
- Experimental study of system behavior during reflood phase of PWR-LOCA using CCTF.
- Effect of loop seal on reflood phenomena in PWR.
- CHF Experiments under Steady-State and Transient Conditions for Tight Lattice Core with Non-Uniform Axial Power Distribution.
- Experimental Study on Difference in Reflood Core Heat Transfer among CCTF, FLECHT-SET and Predicted with FLECHT Correlation.
- Oscillatory flows induced by direct contact condensation of flowing steam with injectes water.
- Core radial power profile effect on system and core cooling behavior during reflood phase of PWR-LOCA with CCTF data.
- System pressure effect on system and core cooling behavior during reflood phase of PWR LOCA.
- Development of Design Technology on Thermal-Hydraulic Performance in Tight-Lattice Rod Bundles: I-Master Plan and Executive Summary
- Development of Design Technology on Thermal-Hydraulic Performance in Tight-Lattice Rod Bundles: II - Rod Bowing Effect on Boiling Transition under Transient Conditions
- Water accumulation phenomena in upper plenum during reflood phase of PWR-LOCA by using CCTF data.
- Experimental study on reflood behavior in PWR with upper plenum injection type ECCS by using CCTF.
- Visual study of flow behavior in upper plenum during simulated reflood phase of PWR-LOCA.
- Effect of decay heat level on reflood phenomena during PWR-LOCA.
- Void fraction in simulated PWR fuel bundle during reflood phase.
- Assessment of core radial power profile effect model for REFLA code by using CCTF data.
- Pressure drop through broken cold leg during reflood phase of loss-of-coolant accident of pressurized water reactor.
- Applicability of Core Thermal-Hydraulic Models in REFLA Code to 17*17 Type Fuel Assembly of PWR.
- Elimination of Numerical Pressure Spikes Induced by Two-Fluid Model.