Evaluation on Driving Force of Natural Circulation in Downcomer for Passive Residual Heat Removal System in JAERI Passive Safety Reactor JPSR
スポンサーリンク
概要
- 論文の詳細を見る
<BR>The driving-force of the natural circulation in the residual heat removal (RHR) system for the JPSR (JAERI Passive Safety Reactor) is given as a gravity force of the density difference between hotter coolant in core and upper plenum and cooler coolant in downcomer. The amount of density difference and time to achieve the enough density difference for the RHR system change directly dependent on the thermal fluid flow pattern in downcomer of annulus flow pass. The purposes of the present study are to investigate the possibilities of the followings by evaluating the three-dimensional thermal fluid flow in downcomer by numerical analysis using the STREAM code; 1) promotion of making the flow pattern uniform in downcomer by installing a baffle, 2) achievement of an enough driving-force of the natural circulation, 3) validity of one-point assumption, that is, complete mixing down-flow assumption for the three-dimensional thermal fluid flow in downcomer to evaluate the function of the passive RHR system. <BR>The following conclusions were obtained: (1) The effect of baffle on the thermal fluid flow and driving-force is little, (2) The driving-force required for natural circulation cooling can be obtained in wide range of inlet velocity even if the flow is multi-dimensional, (3) Both in initial transient stage and in steady-state, the one-point assumption can be applied to evaluate the driving-force of natural circulation in the passive RHR system.
- 社団法人 日本原子力学会の論文
- 1997-01-25
著者
-
IWAMURA Takamichi
Japan Atomic Energy Research Institute
-
MURAO Yoshio
Japan Atomic Energy Research Institute
-
KUNII Katsuhiko
Japan Atomic Energy Research Institute
-
Iwamura Takamichi
Japan Atomic Energy Agency
関連論文
- Transport Mechanism of Thermohydraulic Instability in Natural Circulation Boiling Water Reactors during Startup
- ICONE11-36099 CRITICAL POWER CHARACTERISTICS OF TIGHT LATTICE BUNDLES
- A Concept of Passive Safety Pressurized Water Reactor System with Inherent Matching Nature of Core Heat Generation and Heat Removal
- ICONE11-36176 CONTAINMENT PRESSURE SUPPRESSION SYSTEM WITH FUNCTIONS OF WATER INJECTION AND NONCONDENSABLE GAS CONFINEMENT
- Conceptual Design of Innovative Water Reactor for Flexible Fuel Cycle (FLWR) and its Recycle Characteristics
- Applicability of REFLA/TRAC Code to a Small-Break LOCA of PWR
- Application of PSA Methodology to Design Improvement of JAERI Passive Safety Reactor(JPSR)
- Transient Analysis for Design of Primary Coolant Pump Adopted to JAERI Passive Safety Reactor JPSR
- Possibility of a Pressurized Water Reactor Concept with Highly Inherent Heat Removal Following Capability
- Evaluation on Driving Force of Natural Circulation in Downcomer for Passive Residual Heat Removal System in JAERI Passive Safety Reactor JPSR
- Assessment of current safety evaluation analysis on reflood behavior during PWR-LOCA by using CCTF data.
- Experimental study of ECC water injection rate effects on reflood phase of PWR-LOCA.
- Experimental study of initial downcomer water accumulation velocity effects on reflood phase of PWR-LOCA.
- Assessment of core thermo-hydrodynamic models of REFLA-1D code with CCTF data for reflood phase of PWR-LOCA.
- Experimental study of system behavior during reflood phase of PWR-LOCA using CCTF.
- Effect of loop seal on reflood phenomena in PWR.
- CHF Experiments under Steady-State and Transient Conditions for Tight Lattice Core with Non-Uniform Axial Power Distribution.
- Experimental Study on Difference in Reflood Core Heat Transfer among CCTF, FLECHT-SET and Predicted with FLECHT Correlation.
- Burnout characteristics under flow reduction condition.
- Core radial power profile effect on system and core cooling behavior during reflood phase of PWR-LOCA with CCTF data.
- System pressure effect on system and core cooling behavior during reflood phase of PWR LOCA.
- Initial thermal-hydraulic behaviors under simultaneous ECC water injection into cold leg and upper plenum in a PWR-LOCA.
- Air-Water Two-Phase Cross Flow Resistance in Rod Bundle
- Experimental study of two-dimensional thermal-hydraulic behavior in core during reflood phase of PWR LOCA.
- Water accumulation phenomena in upper plenum during reflood phase of PWR-LOCA by using CCTF data.
- Experimental study on reflood behavior in PWR with upper plenum injection type ECCS by using CCTF.
- Visual study of flow behavior in upper plenum during simulated reflood phase of PWR-LOCA.
- Effect of decay heat level on reflood phenomena during PWR-LOCA.
- Assessment of core radial power profile effect model for REFLA code by using CCTF data.
- Pressure drop through broken cold leg during reflood phase of loss-of-coolant accident of pressurized water reactor.
- Applicability of Core Thermal-Hydraulic Models in REFLA Code to 17*17 Type Fuel Assembly of PWR.
- Elimination of Numerical Pressure Spikes Induced by Two-Fluid Model.