Applicability of REFLA/TRAC Code to a Small-Break LOCA of PWR
スポンサーリンク
概要
- 論文の詳細を見る
The applicability of the REFLA/TRAC code, which is one of best-estimate codes based on two-fluid model, was assessed for a typical small-break loss-of-coolant accident (SBLOCA) transient of PWR. The main assessment subject was to investigate whether the physical models in REFLA/TRAC can apply to the transient under SBLOCA condition (high pressure/low flow rate) or not. The applicability had been verified under low pressure/low flow rate condition during reflood phase in large-break LOCA transients of PWR. The assessment calculation was performed for Run SB-CL-05 (5% cold leg break SBLOCA test) in the ROSA-IV large-scale test facility. The REFLA/TRAC almost predicted the thermal-hydraulics in primary loops while the hydrau- lic models should be improved for regions at the pump side of loop seal and at the up-flow side of steam generator tube under CCFL condition. The core thermal-hydraulic models in REFLA/ TRAC give better prediction for core full-height differential pressure and the peak clad tem- perature (PCT) than those in original TRAC code. The PCT by the models in TRAC was lower about 100K than the measured one but the PCT by those in REFLA/TRAC was lower only about 40K.
- 社団法人 日本原子力学会の論文
- 1995-03-25
著者
-
Ohnuki Akira
Japan Atomic Energy Research Institute
-
Ohnuki Akira
Japan Atomic Energy Agency
-
Ohnuki A
Japan Atomic Energy Res. Inst. Ibaraki
-
Akimoto Hajime
Japan Atomic Energy Agency
-
Akimoto H
Japan Atomic Energy Res. Inst. Ibaraki
-
Akimoto Hajime
Frontier Research System For Global Change
-
MURAO Yoshio
Japan Atomic Energy Research Institute
-
Murao Y
Japan Atomic Energy Res. Inst.
-
Akimoto Hajime
Japan Atomic Energy Research Institute
関連論文
- Effect of Rod Bowing on Critical Power Based on Tight-Lattice 37-Rod Bundle Experiments
- Gap Width Effect on Critical Power based on Tight-Lattice 37-Rod Bundle Experiments
- Pressure Drop Experiments using Tight-Lattice 37-Rod Bundles
- Critical Power Experiment with a Tight-Lattice 37-Rod Bundle
- Critical Power Characteristics in 37-rod Tight Lattice Bundles under Transient Conditions
- An Improved Critical Power Correlation for Tight-Lattice Rod Bundles
- Critical Power Correlation for Tight-Lattice Rod Bundles
- Critical Power in 7-Rod Tight Lattice Bundle(International Conferences on Power and Energy System)
- ICONE11-36099 CRITICAL POWER CHARACTERISTICS OF TIGHT LATTICE BUNDLES
- A Concept of Passive Safety Pressurized Water Reactor System with Inherent Matching Nature of Core Heat Generation and Heat Removal
- Conceptual Design of Innovative Water Reactor for Flexible Fuel Cycle (FLWR) and its Recycle Characteristics
- Modeling Mixing Aerosols of Soil Dust, Sea-Salt, Black-Carbon and Sulfate over East Asia
- Intercomparison of chemical mechanisms in the Models-3 Community Multi-scale Air Quality (CMAQ) modeling system
- A MODELING STUDY OF LONG-RANGE TRANSPORT OF YELLOW SAND IN SPRING 2000
- Applicability of REFLA/TRAC Code to a Small-Break LOCA of PWR
- Core Liquid Level Responses Due to Secondary-Side Depressurization during PWR Small Break LOCA
- Pressure Drop Characteristics in Tight-Lattice Bundles for Reduced-Moderation Water Reactors(International Conferences on Power and Energy System)
- ICONE11-36172 EVALUATION OF CRITICAL HEAT FLUX OF TIGHT LATTICE CORE WITH SUBCHANNEL ANALYSIS CODE NASCA
- ICONE11-36098 PRESSURE DROP CHARACTERISTICS IN TIGHT-LATTICE ROD BUNDLES FOR REDUCED-MODERATION WATER REACTERS
- PREDICTED THREE-DIMENSIONAL BUBBLY AND LIQUID FILM FLOW BEHAVIOR IN NARROW FUEL CHANNELS(Liquid Flow)
- ICONE11-36097 DEVELOPMENT OF MECHANISTIC BOILING TRANSITION MODEL IN ROD BUNDLES
- Application of PSA Methodology to Design Improvement of JAERI Passive Safety Reactor(JPSR)
- Transient Analysis for Design of Primary Coolant Pump Adopted to JAERI Passive Safety Reactor JPSR
- Possibility of a Pressurized Water Reactor Concept with Highly Inherent Heat Removal Following Capability
- Evaluation on Driving Force of Natural Circulation in Downcomer for Passive Residual Heat Removal System in JAERI Passive Safety Reactor JPSR
- FLOW VISUALIZATION OF A WAKE STRUCTURE AROUND THIN PLATE BY USING DYNAMIC PIV SYSTEM(Measurement)
- Model Development for Bubble Turbulent Diffusion and Bubble Diameter in Large Vertical Pipes
- Numerical Investigation of Heat Transfer Enhancement Phenomenon during the Reflood Phase of PWR-LOCA
- Mechanism of Falling Water Limitation under Counter-current Flow through a Vertical Flow Path
- Development of Design Technology on Thermal-Hydraulic Performance in Tight-Lattice Rod Bundles: III - Numerical Evaluation of Fluid Mixing Phenomena using Advanced Interface-Tracking Method -
- Development of Design Technology on Thermal-hydraulic Performance in Tight-lattice Rod Bundles: V-Estimation of Void Fraction
- Development of Design Technology on Thermal-Hydraulic Performance in Tight-Lattice Rod Bundle: IV Large Paralleled Simulation by the Advanced Two-fluid Model Code
- Numerical Investigation of Cross Flow Phenomena in a Tight-Lattice Rod Bundle Using Advanced Interface Tracking Method
- Downcomer effective water head during reflood in postulated PWR LOCA.
- Assessment of current safety evaluation analysis on reflood behavior during PWR-LOCA by using CCTF data.
- Experimental study of ECC water injection rate effects on reflood phase of PWR-LOCA.
- Experimental study of initial downcomer water accumulation velocity effects on reflood phase of PWR-LOCA.
- Assessment of core thermo-hydrodynamic models of REFLA-1D code with CCTF data for reflood phase of PWR-LOCA.
- Experimental study of system behavior during reflood phase of PWR-LOCA using CCTF.
- Effect of loop seal on reflood phenomena in PWR.
- CHF Experiments under Steady-State and Transient Conditions for Tight Lattice Core with Non-Uniform Axial Power Distribution.
- Experimental Study on Difference in Reflood Core Heat Transfer among CCTF, FLECHT-SET and Predicted with FLECHT Correlation.
- Oscillatory flows induced by direct contact condensation of flowing steam with injectes water.
- Core radial power profile effect on system and core cooling behavior during reflood phase of PWR-LOCA with CCTF data.
- System pressure effect on system and core cooling behavior during reflood phase of PWR LOCA.
- Development of Design Technology on Thermal-Hydraulic Performance in Tight-Lattice Rod Bundles: I-Master Plan and Executive Summary
- Development of Design Technology on Thermal-Hydraulic Performance in Tight-Lattice Rod Bundles: II - Rod Bowing Effect on Boiling Transition under Transient Conditions
- Water accumulation phenomena in upper plenum during reflood phase of PWR-LOCA by using CCTF data.
- Experimental study on reflood behavior in PWR with upper plenum injection type ECCS by using CCTF.
- Visual study of flow behavior in upper plenum during simulated reflood phase of PWR-LOCA.
- Effect of decay heat level on reflood phenomena during PWR-LOCA.
- Assessment of core radial power profile effect model for REFLA code by using CCTF data.
- Pressure drop through broken cold leg during reflood phase of loss-of-coolant accident of pressurized water reactor.
- Applicability of Core Thermal-Hydraulic Models in REFLA Code to 17*17 Type Fuel Assembly of PWR.
- Elimination of Numerical Pressure Spikes Induced by Two-Fluid Model.