Numerical Investigation of Cross Flow Phenomena in a Tight-Lattice Rod Bundle Using Advanced Interface Tracking Method
スポンサーリンク
概要
- 論文の詳細を見る
In relation to the design of an innovative FLexible-fuel-cycle Water Reactor (FLWR), investigation of thermal-hydraulic performance in tight-lattice rod bundles of the FLWR is being carried out at Japan Atomic Energy Agency (JAEA). The FLWR core adopts a tight triangular lattice arrangement with about 1 mm gap clearance between adjacent fuel rods. In view of importance of accurate prediction of cross flow between subchannels in the evaluation of the boiling transition (BT) in the FLWR core, this study presents a statistical evaluation of numerical simulation results obtained by a detailed two-phase flow simulation code, TPFIT, which employs an advanced interface tracking method. In order to clarify mechanisms of cross flow in such tight lattice rod bundles, the TPFIT is applied to simulate water-steam two-phase flow in two modeled subchannels. Attention is focused on instantaneous fluctuation characteristics of cross flow. With the calculation of correlation coefficients between differential pressure and gas/liquid mixing coefficients, time scales of cross flow are evaluated, and effects of mixing section length, flow pattern and gap spacing on correlation coefficients are investigated. Differences in mechanism between gas and liquid cross flows are pointed out.
- 一般社団法人 日本機械学会の論文
著者
-
Ohnuki Akira
Japan Atomic Energy Agency
-
Akimoto Hajime
Japan Atomic Energy Agency
-
Ose Yasuo
Yamato System Engineer
-
Hotta Akitoshi
TEPCO Systems Corporation
-
Yoshida Hiroyuki
Japan Atomic Energy Agency
-
ZHANG Weizhong
Japan Atomic Energy Agency
-
FUJIMURA Ken
Japan Atomic Power Company
関連論文
- Effect of Rod Bowing on Critical Power Based on Tight-Lattice 37-Rod Bundle Experiments
- Gap Width Effect on Critical Power based on Tight-Lattice 37-Rod Bundle Experiments
- Pressure Drop Experiments using Tight-Lattice 37-Rod Bundles
- Critical Power Experiment with a Tight-Lattice 37-Rod Bundle
- Cloning and heterologous expression of cDNAs encoding flavonoid glucosyltransferases from Dianthus caryophyllus
- Assessment of Applicability of Two-Fluid Model Code ACE-3D to Heat Transfer Test of Supercritical Water Flowing in an Annular Channel
- Critical Power Characteristics in 37-rod Tight Lattice Bundles under Transient Conditions
- An Improved Critical Power Correlation for Tight-Lattice Rod Bundles
- Critical Power Correlation for Tight-Lattice Rod Bundles
- Critical Power in 7-Rod Tight Lattice Bundle(International Conferences on Power and Energy System)
- ICONE11-36099 CRITICAL POWER CHARACTERISTICS OF TIGHT LATTICE BUNDLES
- Conceptual Design of Innovative Water Reactor for Flexible Fuel Cycle (FLWR) and its Recycle Characteristics
- Applicability of REFLA/TRAC Code to a Small-Break LOCA of PWR
- Core Liquid Level Responses Due to Secondary-Side Depressurization during PWR Small Break LOCA
- Numerical Analysis of a Water-Vapor Two-Phase Film Flow in a Narrow Coolant Channel with a Three-Dimensional Rectangular Rib(International Conferences on Power and Energy System)
- Pressure Drop Characteristics in Tight-Lattice Bundles for Reduced-Moderation Water Reactors(International Conferences on Power and Energy System)
- ICONE11-36232 NUMERICAL ANALYSIS OF A WATER-VAPOR TWO-PHASE FILM FLOW IN A NARROW COOLANT CHANNEL WITH A THREE-DIMENSIONAL RECTANGULAR RIB
- ICONE11-36172 EVALUATION OF CRITICAL HEAT FLUX OF TIGHT LATTICE CORE WITH SUBCHANNEL ANALYSIS CODE NASCA
- ICONE11-36098 PRESSURE DROP CHARACTERISTICS IN TIGHT-LATTICE ROD BUNDLES FOR REDUCED-MODERATION WATER REACTERS
- Excision of Transposable Elements from the Chalcone Isomerase and Dihydroflavonol 4-Reductase Genes May Contribute to the Variegation of the Yellow-Flowered Carnation (Dianthus caryophyllus)
- PREDICTED THREE-DIMENSIONAL BUBBLY AND LIQUID FILM FLOW BEHAVIOR IN NARROW FUEL CHANNELS(Liquid Flow)
- ICONE11-36097 DEVELOPMENT OF MECHANISTIC BOILING TRANSITION MODEL IN ROD BUNDLES
- Breeding of Red-flowering Delphiniums using Interspecific Hybrids Produced by in Vitro Germination
- FLOW VISUALIZATION OF A WAKE STRUCTURE AROUND THIN PLATE BY USING DYNAMIC PIV SYSTEM(Measurement)
- Model Development for Bubble Turbulent Diffusion and Bubble Diameter in Large Vertical Pipes
- Numerical Investigation of Heat Transfer Enhancement Phenomenon during the Reflood Phase of PWR-LOCA
- Mechanism of Falling Water Limitation under Counter-current Flow through a Vertical Flow Path
- Numerical Evaluation of Fluid Mixing Phenomena in Boiling Water Reactor Using Advanced Interface Tracking Method
- Development of Design Technology on Thermal-Hydraulic Performance in Tight-Lattice Rod Bundles: III - Numerical Evaluation of Fluid Mixing Phenomena using Advanced Interface-Tracking Method -
- Development of Design Technology on Thermal-hydraulic Performance in Tight-lattice Rod Bundles: V-Estimation of Void Fraction
- Development of Design Technology on Thermal-Hydraulic Performance in Tight-Lattice Rod Bundle: IV Large Paralleled Simulation by the Advanced Two-fluid Model Code
- Numerical Analysis of Heat Transfer Test of Supercritical Water in a Tube Using the Three-Dimensional Two-Fluid Model Code
- Numerical Investigation of Cross Flow Phenomena in a Tight-Lattice Rod Bundle Using Advanced Interface Tracking Method
- Downcomer effective water head during reflood in postulated PWR LOCA.
- Assessment of current safety evaluation analysis on reflood behavior during PWR-LOCA by using CCTF data.
- Experimental study of system behavior during reflood phase of PWR-LOCA using CCTF.
- Oscillatory flows induced by direct contact condensation of flowing steam with injectes water.
- Core radial power profile effect on system and core cooling behavior during reflood phase of PWR-LOCA with CCTF data.
- System pressure effect on system and core cooling behavior during reflood phase of PWR LOCA.
- Development of Design Technology on Thermal-Hydraulic Performance in Tight-Lattice Rod Bundles: I-Master Plan and Executive Summary
- Development of Design Technology on Thermal-Hydraulic Performance in Tight-Lattice Rod Bundles: II - Rod Bowing Effect on Boiling Transition under Transient Conditions
- Assessment of core radial power profile effect model for REFLA code by using CCTF data.
- Pressure drop through broken cold leg during reflood phase of loss-of-coolant accident of pressurized water reactor.
- Applicability of Core Thermal-Hydraulic Models in REFLA Code to 17*17 Type Fuel Assembly of PWR.
- Build-up and decay of actinide nuclides in fuel cycle of nuclear reactors.
- Elimination of Numerical Pressure Spikes Induced by Two-Fluid Model.
- Experimental study on behavior of horizontal bubbly flow under structure vibration
- Progress in Research on Laser Transmission Systems, Atmospheric Influence on Laser Transmission, and Laser Photovoltaics in Laser Space Solar Power System