Model Development for Bubble Turbulent Diffusion and Bubble Diameter in Large Vertical Pipes
スポンサーリンク
概要
- 論文の詳細を見る
Multi-dimensional analyses have been expected recently with expanding computation resources for gas-liquid two-phase flow analyses of advanced nuclear systems such as passive safety systems and natural-circulation-type reactors. However, the applicability of previous constitutive equations for multi-dimensional analyses has not been fully investigated especially for the effects of flow path scale because the equations have been assessed for small-scale experiments. In this study, we analyzed the scale effects by the multi-dimensional two-fluid model code using data in 38 mm and 200 mm diameter pipes. We clarified a key-parameter to model the scale effects and developed models for the effects on phase distribution. The scale effects can be classified by the relative relationship between bubble diameter db and turbulent length scale lT. Bubble-induced turbulence is increased under that db is smaller than lT and bubble coalescence is predominated rather than breakup under that lT is about three times larger than db and under higher void fraction. Based on these findings, we established new models for bubble turbulent diffusion and bubble diameter. The applicability was promising through assessments against the 38 mm and 200 mm pipes under different flow rates and against databases for 60 mm, 100 mm and 480 mm pipes.
- 一般社団法人 日本原子力学会の論文
- 2001-12-25
著者
関連論文
- Effect of Rod Bowing on Critical Power Based on Tight-Lattice 37-Rod Bundle Experiments
- Gap Width Effect on Critical Power based on Tight-Lattice 37-Rod Bundle Experiments
- Pressure Drop Experiments using Tight-Lattice 37-Rod Bundles
- Critical Power Experiment with a Tight-Lattice 37-Rod Bundle
- Critical Power Characteristics in 37-rod Tight Lattice Bundles under Transient Conditions
- An Improved Critical Power Correlation for Tight-Lattice Rod Bundles
- Critical Power Correlation for Tight-Lattice Rod Bundles
- Critical Power in 7-Rod Tight Lattice Bundle(International Conferences on Power and Energy System)
- ICONE11-36099 CRITICAL POWER CHARACTERISTICS OF TIGHT LATTICE BUNDLES
- Conceptual Design of Innovative Water Reactor for Flexible Fuel Cycle (FLWR) and its Recycle Characteristics
- Applicability of REFLA/TRAC Code to a Small-Break LOCA of PWR
- Core Liquid Level Responses Due to Secondary-Side Depressurization during PWR Small Break LOCA
- Pressure Drop Characteristics in Tight-Lattice Bundles for Reduced-Moderation Water Reactors(International Conferences on Power and Energy System)
- ICONE11-36172 EVALUATION OF CRITICAL HEAT FLUX OF TIGHT LATTICE CORE WITH SUBCHANNEL ANALYSIS CODE NASCA
- ICONE11-36098 PRESSURE DROP CHARACTERISTICS IN TIGHT-LATTICE ROD BUNDLES FOR REDUCED-MODERATION WATER REACTERS
- PREDICTED THREE-DIMENSIONAL BUBBLY AND LIQUID FILM FLOW BEHAVIOR IN NARROW FUEL CHANNELS(Liquid Flow)
- ICONE11-36097 DEVELOPMENT OF MECHANISTIC BOILING TRANSITION MODEL IN ROD BUNDLES
- FLOW VISUALIZATION OF A WAKE STRUCTURE AROUND THIN PLATE BY USING DYNAMIC PIV SYSTEM(Measurement)
- Model Development for Bubble Turbulent Diffusion and Bubble Diameter in Large Vertical Pipes
- Numerical Investigation of Heat Transfer Enhancement Phenomenon during the Reflood Phase of PWR-LOCA
- Mechanism of Falling Water Limitation under Counter-current Flow through a Vertical Flow Path
- Development of Design Technology on Thermal-Hydraulic Performance in Tight-Lattice Rod Bundles: III - Numerical Evaluation of Fluid Mixing Phenomena using Advanced Interface-Tracking Method -
- Development of Design Technology on Thermal-hydraulic Performance in Tight-lattice Rod Bundles: V-Estimation of Void Fraction
- Development of Design Technology on Thermal-Hydraulic Performance in Tight-Lattice Rod Bundle: IV Large Paralleled Simulation by the Advanced Two-fluid Model Code
- Numerical Investigation of Cross Flow Phenomena in a Tight-Lattice Rod Bundle Using Advanced Interface Tracking Method
- Downcomer effective water head during reflood in postulated PWR LOCA.
- Assessment of current safety evaluation analysis on reflood behavior during PWR-LOCA by using CCTF data.
- Experimental study of system behavior during reflood phase of PWR-LOCA using CCTF.
- Oscillatory flows induced by direct contact condensation of flowing steam with injectes water.
- Core radial power profile effect on system and core cooling behavior during reflood phase of PWR-LOCA with CCTF data.
- System pressure effect on system and core cooling behavior during reflood phase of PWR LOCA.
- Development of Design Technology on Thermal-Hydraulic Performance in Tight-Lattice Rod Bundles: I-Master Plan and Executive Summary
- Development of Design Technology on Thermal-Hydraulic Performance in Tight-Lattice Rod Bundles: II - Rod Bowing Effect on Boiling Transition under Transient Conditions
- Assessment of core radial power profile effect model for REFLA code by using CCTF data.
- Pressure drop through broken cold leg during reflood phase of loss-of-coolant accident of pressurized water reactor.
- Applicability of Core Thermal-Hydraulic Models in REFLA Code to 17*17 Type Fuel Assembly of PWR.
- Elimination of Numerical Pressure Spikes Induced by Two-Fluid Model.