Effect of Hydrofluoric Acid Etching on Shear Bond Strength of an Indirect Resin Composite to an Adhesive Cement
スポンサーリンク
概要
- 論文の詳細を見る
This study evaluated the effect of 1% hydrofluoric acid (HF) treatment on the bonding of an adhesive cement (Panavia F 2.0) to an indirect resin composite (Estenia C&B). Pairs of composite disks (10 and 8 mm in diameter by 3 mm thickness) were prepared. Adhesive surfaces were pretreated with either airborne particle abrasion or HF etching before being soaked for 30 seconds, five minutes or 10 minutes, with or without application of silane coupling agent. Adhesive specimens were fabricated by cementing a pair of treated disks. Shear bond strength was determined before and after 50,000 times of thermocycling (4 and 60℃). All data were statistically analyzed using two-way ANOVA and Bonferroni's test (α=0.05). Bond strength achieved with five minutes of HF etching (18.3±1.1 MPa) was significantly higher (P=0.0025) than that obtained with airborne particle abrasion followed by application of silane coupling agent (14.3±1.8 MPa) after thermocycling.
- 日本歯科理工学会の論文
著者
-
MATSUMURA Hideo
Department of Fixed Prosthodontics, Nihon University School of Dentistry
-
MINAMI Hiroyuki
Fixed Prosthetic Clinic, Kagoshima University Medical and Dental Hospital
-
TANAKA Takuo
Department of Fixed Prosthetic Dentistry, Kagoshima University Graduate School of Medical and Dental
-
MINAMI Hiroyuki
Department of Fixed Prosthodontics, Graduate School of Medical and Dental Sciences, Kagoshima Univer
-
Minami Hiroyuki
Kagoshima Univ. Medical And Dental Hospital Kagoshima Jpn
-
Minami Hiroyuki
Fixed Prosthetic Clinic Kagoshima University Medical And Dental Hospital
-
MINESAKI Yoshito
Fixed Prosthetic Clinic, Kagoshima University Medical and Dental Hospital
-
HORI Sayaka
Department of Fixed Prosthetic Dentistry, Advanced Therapeutic Course, Kagoshima University Graduate
-
MINESAKI Yoshito
Department of Fixed Prosthetic Dentistry, Advanced Therapeutic Course, Kagoshima University Graduate
-
Matsumura Hideo
Department Of Fixed Prosthodontics And Division Of Advanced Dental Treatment Dental Research Center
-
Matsumura Hideo
Department Of Crown And Bridge Prosthodontics Nihon University School Of Dentistry
-
Hori Sayaka
Department Of Fixed Prosthetic Dentistry Advanced Therapeutic Course Kagoshima University Graduate S
-
Tanaka T
Department Of Fixed Prosthetic Dentistry Kagoshima University Graduate School Of Medical And Dental
-
Minesaki Yoshito
Kagoshima Univ. Kagoshima Jpn
-
Minesaki Yoshito
Department Of Fixed Prosthetic Dentistry Graduate School Of Medical And Dental Sciences Kagoshima Un
-
TANAKA Takuo
Department of Fixed Prosthetic Dentistry, Advanced Therapeutic Course, Kagoshima University Graduate School of Medical and Dental Sciences
関連論文
- Effect of preliminary irradiation on the bond strength between a veneering composite and alloy
- Evaluation of single liquid primers with organic sulfur compound for bonding between indirect composite material and silver-palladium-copper-gold alloy
- Effects of Monomer Composition and Original Filler Content on Filler Loading in the Resulting Centrifuged Composites
- Effect of fiber-premixed indirect resin composite substructure on fracture resistance of MOD composite inlays adhered with two different adhesive resin cements
- Effects of metal primers on bonding of adhesive resin cement to noble alloys for porcelain fusing
- Effect of alumina air-abrasion on mechanical bonding between an acrylic resin and casting alloys
- Bond Strength to Primed Ti-6Al-7Nb Alloy of Two Acrylic Resin Adhesives
- Color Stability of Acrylic Resin Adhesives with Different Initiation Modes
- Marginal and Internal Adaptation of Zirconium Dioxide Ceramic Copings and Crowns with Different Finish Line Designs
- Effects of metal primers on bonding of adhesive resin cement to noble alloys for porcelain fusing
- Mechanical Properties and Bond Strength of Silicone-based Resilient Denture Liners
- Bonding Strength and Durability of Alkaline-Treated Titanium to Veneering Resin
- Effect of preliminary irradiation on depth of cure and hardness of a veneering composite
- Comparative Evaluation of Thione and Phosphate Monomers on Bonding Gold Alloy and Ti-6Al-7Nb Alloy with Tri-n-butylborane initiated Resin
- Bond strength to bovine dentin of a composite core build-up material combined with four different bonding agents
- Effect of Metal Priming Agents on Bond Strength of Resin-modified Glass Ionomers Joined to Gold Alloy
- Effect of single-liquid priming agents on adhesive bonding to aluminum oxide of a methacrylic resin.
- Relation between Attractive Force and Keeper Surface Characteristics of Iron-neodymium-boron Magnetic Attachment Systems
- Effect of a Metal Priming Agent on Wear Resistance of Gold Alloy-indirect Composite Joint
- Depth of cure and hardness of an indirect composite polymerized with three laboratory curing units
- Effects of alumina air-abrasion and acidic priming agents on bonding between SUS XM27 steel and auto-polymerizing acrylic resin
- Effect of metal priming agents on bonding characteristics of an acrylic resin joined to SUS XM27 steel
- Effect of Acidic Primers on Bonding Three Magnetic Steel Alloys with Tri-n-butylborane Initiated Methacrylic Resin
- Properties of an Indirect Composite Material Polymerized with Two Different Laboratory Polymerizing Systems
- A New Laboratory Polymerizing Apparatus Equipped with Halogen and Metal Halide Light Sources
- Effect of metal halide light source on hardness, water sorption and solubility of indirect composite material
- Effect of noble metal adhesive systems on bonding between an indirect composite material and a gold alloy
- Fabrication of a maxillary posterior fixed partial denture with a type 4 gold alloy and a dual-polymerizing indirect composite
- A Nine-year Follow-up of a Porcelain Laminate Veneer Restoration Applied to an Adolescent with Traumatized Dentition : A Clinical Report
- International telephone code used for citizenship identification in a denture
- Application of a pre-impregnated fiber-reinforced composite in the fabrication of an indirect dowel-core
- Influence of Centrifugal Force on Filler Loading of Resin Composites
- Porcelain laminate veneer restorations bonded with a three-liquid silane bonding agent and a dual-activated luting composite
- Twenty-four Hour Bond Strength Between Layers of a Highly Loaded Indirect Composite
- Effect of Single-liquid Acidic Primers on Bonding of a Composite Luting Agent Joined to a Prefabricated Alumina Coping Material
- Effect of acidic primers on adhesive bonding of tri-n-butylborane initiated adhesive resin to alumina
- Evaluation of thiouracil-based adhesive systems for bonding cast silver-palladium-copper-gold alloy
- Effectiveness of Bonding Systems on Bonding Durability of a Prefabricated Porcelain Material
- Correlation between Angiogenesis and p53 Expression in Lung Adenocarcinoma of Young Patients
- Effect of Hydrofluoric Acid Etching on Shear Bond Strength of an Indirect Resin Composite to an Adhesive Cement
- Effects of Thermal Cycling on Surface Texture of Restorative Composite Materials
- In Vitro Evaluation of Bond Strength and Surface Roughness of a Resin-Paint Material
- Bending Property of Super-Elastic Ti-Ni Alloy Dental Castings with Different Heat Treatments
- Influence of Laboratory Light-curing Unit Variation on Properties of Prosthetic Composites
- ANALYSIS OF MOLECULAR BASIS OF ASSOCIATIVE VISUAL LEARNING IN THE HONEYBEE APIS MELLIFERA L.(Physiology,Abstracts of papers presented at the 75^ Annual Meeting of the Zoological Society of Japan)
- ASSOCIATIVE VISUAL LEARNING IN HONEYBEES APIS MELLIFERA L.(Physiology,Abstracts of papers presented at the 74^ Annual Meeting of the Zoological Society of Japan)
- Marginal Fit and Microgaps of Implant-abutment Interface with Internal Anti-rotation Configuration
- A study of self-adhesive resin cements for bonding to silver-palladium-copper-gold alloy — Effect of including primer components in cement base
- Effects of IL-6 and Soluble IL-6 Receptor on the Expression of Cartilage Matrix Proteins in Human Chondrocytes
- Research Projects on Materials and Devices Published in 2005 by Members of the Japan Prosthodontic Society : A Review
- Influence of Abutment Materials on the Resultant Color of Heat-pressed Lithium Disilicate Ceramics
- Improvement of Bonding to Bleached Bovine Tooth Surfaces by Ascorbic Acid Treatment
- Evaluation of two dual-functional primers and a tribochemical surface modification system applied to the bonding of an indirect composite resin to metals
- Surface damages of zirconia by Nd:YAG dental laser irradiation
- Effect of Resin Coating as a Means of Preventing Marginal Leakage beneath Full Cast Crowns
- Current bonding systems for resin-bonded restorations and fixed partial dentures made of silver-palladium-copper-gold alloy
- A study of self-adhesive resin cements for bonding to silver-palladium-copper-gold alloy-Effect of including primer components in cement base
- A method for improving the light intensity distribution in dental light-curing units
- Influence of laboratory light sources on the wear characteristics of indirect composites
- Current status of zirconia-based fixed restorations
- Shear bond strength between an indirect composite veneering material and zirconia ceramics after thermocycling
- Effect of Single-liquid Acidic Primers on Bonding of a Composite Luting Agent Joined to a Prefabricated Alumina Coping Material
- Effect of surface treatment on bond strength between an indirect composite material and a zirconia framework
- Properties of indirect composites reinforced with monomer-impregnated glass fiber
- Bonding between layering materials and zirconia frameworks
- The influence of polymerization conditions on color stability of three indirect composite materials
- Effect of adherend temperature on bond strengths of resin bonding systems to denture base resin and a semi-precious alloy
- Effect of adhesion promoting monomer addition to MMA-TBBO resin on bonding to pure palladium
- Evaluation of fracture resistance of indirect composite resin crowns by cyclic impact test: Influence of crown and abutment materials
- History and current state of metal adhesion systems used in prosthesis fabrication and placement
- PARTIAL LIVER TRANSPLANTATION WITH PRIMARY REVASCULARIZATION IN DOGS:Preliminary Report On New Method And Its Theoretical Background
- Effect of adhesion promoting monomer addition to MMA-TBBO resin on bonding to pure palladium
- A nine-year clinical case study of a resin-bonded fixed partial denture seated on the maxillary anterior teeth.
- Evaluation of fracture resistance of indirect composite resin crowns by cyclic impact test : Influence of crown and abutment materials
- Effect of adherend temperature on bond strengths of resin bonding systems to denture base resin and a semi-precious alloy