Corrosion Behavior of Pure Titanium and Titanium Alloys in Various Concentrations of Acidulated Phosphate Fluoride (APF) Solutions
スポンサーリンク
概要
- 論文の詳細を見る
The corrosion behaviors of Ti, Ti-6Al-7Nb and Ti-6Al-4V alloys, and an experimentally produced Ti-0.5Pt alloy in 0.05% to 2.0% concentrations of Acidulated Phosphate Fluoride (APF) solutions (corresponding to 226 to 9,050ppm fluoride at pH 3.5 or 3.6) were examined. While the corrosion of Ti, Ti-6Al-7Nb and Ti-6Al-4V alloys might occur easily even in a diluted 0.05% APF solution, dissolution of Ti from the Ti-0.5Pt alloy was observed only in test solutions with APF concentration exceeding 0.2%. When Ti-6Al-7Nb and Ti-6Al-4V alloys were immersed in 2.0% APF solution, their surfaces were entirely covered by compact corrosion products of Na_3TiF_6 due to severe corrosion. As a result, Ti dissolution was prevented and the amount of Ti dissolved decreased. However, since Ti was covered by porous, large-sized corrosion products of Na_3TiF_6 and that Ti-0.5Pt alloy was not covered with any corrosion product, the amount of Ti dissolved increased in the 2.0% APF solution.
- 日本歯科理工学会の論文
著者
-
MATSUYA Shigeki
Section of Bioengineering, Department of Dental Engineering, Fukuoka Dental College
-
Ishikawa Kunio
Department Of Biomaterials Faculty Of Dental Science Kyushu University
-
Ishikawa Kunio
九州大学 歯学部口腔機能修復学講座
-
Matsuya Shigeki
Department Of Biomaterials Faculty Of Dental Science Kyushu University
-
Matsuya Shigeki
日本歯科先端技術研究所
-
Nakagawa M
Department Of Biomaterials Faculty Of Dental Science Kyushu University
-
TERADA Yoshihiro
Department of Fixed Prosthodontics, Faculty of Dental Science, Kyushu University
-
NAKAGAWA Masaharu
Department of Biomaterials Faculty of Dental Science, Kyushu University
-
Tsukiyama Yoshihiro
Div. Of Oral Rehabilitation Fac. Of Dental Sci. Kyushu Univ.
-
Terada Yoshihiro
Department Of Fixed Prosthodontics Faculty Of Dental Science Kyushu University
-
MATONO Yoshinari
Department of Biomaterials, Faculty of Dental Science, Kyushu University
-
Nakagawa Masaharu
Department Of Biomaterials Division Of Oral Rehabilitation Faculty Of Dental Science Kyushu Universi
-
Matono Yoshinari
Department Of Fixed Prosthodontics Division Of Oral Rehabilitation Faculty Of Dental Science Kyushu
-
Ishikawa Kunio
Department Of Biomaterials
-
Tsukiyama Yoshihiro
Department Of Fixed Prosthodontics Faculty Of Dental Science Kyushu University
-
Ishikawa Kunio
Section Of Biomaterials Department Of Oral Rehabilitation School Of Dentistry Kyushu University
-
Ishikawa Kunio
Department of Applied Chemistry, Faculty of Engineering, Osaka Univeristy
関連論文
- Effects of sintering temperature on physical and compositional properties of α-tricalcium phosphate foam
- Fabrication of low crystalline B-type carbonate apatite block from low crystalline calcite block
- Effects of liquid phase on basic properties of α-tricalcium phosphate-based apatite cement
- Fabrication of carbonate apatite block based on internal dissolution-precipitation reaction of dicalcium phosphate and calcium carbonate
- Fabrication of B-type carbonate apatite blocks by the phosphorization of free-molding gypsum-calcite composite
- Fabrication of Si-substituted hydroxyapatite foam using calcium silicates( Ceramics for Biomedical Applications in Asian Countries)
- Effects of tricalcium silicate addition on basic properties of α-tricalcium phosphate cement( Ceramics for Biomedical Applications in Asian Countries)
- Effects of thermal treatment on injectability and basic properties of apatite cement containing spherical tetracalcium phosphate made with plasma melting method( Ceramics for Biomedical Applications in Asian Countries)
- Comparison of the Effects of Added α- and β- Tricalcium Phosphate on the Basic Properties of Apatite Cement
- Fabrication of Biporous Low-crystalline Apatite Based on Mannitol Dissolution from Apatite Cement
- Fabrication of Hydroxyapatite Block from Gypsum Block Based on (NH_4)_2HPO_4 Treatment
- The Effects of Initial Hemostatic Period on the Mechanical Strength and Transformation of Apatite Cement
- Biopex^[○!R] Acquires Anti-washout Properties by Adding Sodium Alginate into its Liquid Phase
- Stress Analysis of All-on-4 System Using a 3-Dimensional Finite Element Method
- Effects of Sintering Temperature Over 1,300℃ on the Physical and Compositional Properties of Porous Hydroxyapatite Foam
- Three Dimensional Interconnected Pore Scaffold As Bone Defect Filler : The Effects of Sintering Temperatures on the Physical Properties of α-TCP
- πHydrogen Bond Between Dipeptide Side Chains as a Structural Essential for Chymotrypsin Inhibition
- Effects of Polysiloxane Coating of NaF on the Release Profile of Fluoride Ion from Bis-GMA/TEGDMA Resin Containing NaF
- Fabrication of low-crystalline carbonate apatite foam bone replacement based on phase transformation of calcite foam
- Development of Calcium Phosphate Cement for Rapid Crystallization to Apatite
- Corrosion Behavior of Pure Titanium and Titanium Alloys in Various Concentrations of Acidulated Phosphate Fluoride (APF) Solutions
- Effects of Alloying Additions on Thermal Conductivity of Ferritic Iron
- Adhesion of Restorative Resin to Teeth: Effects of Functional Groups of Dentin Primer to Collagen
- Effects of added mannitol on the setting reaction and mechanical strength of apatite cement
- Effects of Calcium Phosphate Precipitation Method on Acid Resistance to Apatite Powder and Bovine Tooth
- Comparison of the Occluding Ability of Dentinal Tubules with Different Morphology between Calcium Phosphate Precipitation Method and Potassium Oxalate Treatment
- The Development of Ti Alloys for Dental Implant with High Corrosion Resistance and Mechanical Strength
- Initial Evaluation of a Ceramic Form as a Reconstructive Material for Bone Defects
- Effect of Carboxyl Group in O-Methacryloyl-N-Acyl Tyrosines on Adhesiveness to Unteched Human Dentin
- Correlation of Dentin Bond Durability with Water Absorption of Bonding Layer
- Steric Effects of N-Acyl Group in O-Methacryloyl-N-Acyl Tyrosines on the Adhesiveness of Unetched Human Dentin
- Self-cleaning Ability of a Photocatalyst-containing Denture Base Material
- The Relationship between Masticatory Function and Dysphagia in Patients with Myotonic Dystrophy
- Characterization of Masticatory Function in Patients with Myotonic Dystrophy. Part 2 : Comparison between Patients with Myotonic Dystrophy and Healthy Individuals
- Characterization of Masticatory Function in Patients with Myotonic Dystrophy. Part 1 : Correlations among the Factors of Masticatory Function
- Distribution of Inducible Nitric Oxide Synthase, Interleukin-1β, and Interleukin-1 Receptor in the Temporomandibular Joint of Normal Rats
- Up-regulation, Enhanced Maturation, and Secretion of Cathepsin E in Mouse Macrophages Treated with Interferon-γ or Lipopolysaccharide
- Effect of Corrosion Behavior of Pure Titanium and Titanium Alloy on Fluoride Addition in Acidic Environment by Streptococcus mutans (Corrosion Behavior of Titanium by Fluoride and Streptococcus mutans)
- Effects of Added Sodium Alginate on Mechanical Strength of Apatite Cement
- The Changes in the Immunocytochemical Localization of Cathepsin L and Type I Collagen in Rat Osteoclasts Treated with E-64
- Synthesis of ZnO Bicrystals Doped with Co or Mn and Their Electrical Properties
- Evaluation of Dislocation Density in a Mg-Al-Mn-Ca Alloy Determined by X-ray Diffractometry and Transmission Electron Microscopy
- Psuedo-binary Phase Diagram of AuCu-Sn
- Histological Evaluation of Apatite Cement Containing Atelocollagen
- Proliferation and Differentiation of Cultured MC3T3-E1 Osteoblasts on Surface-layer Modified Hydroxyapatite Ceramic with Acid and Heat Treatments
- Content and Release of Bisphenol A from Polycarbonate Dental Products
- Effects of Apatite Foam Combined with Platelet-rich Plasma on Regeneration of Bone Defects
- Fabrication of low-crystalline carbonate apatite foam bone replacement based on phase transformation of calcite foam
- Creep Behavior of Hypoeutectic Mg-Ca Binary Alloys
- Role of Eutectic Intermetallic Phase on Creep Strength in a Die-Cast Mg-Al-Ca Alloy : Evaluation by Internal Stress Measurement
- Internal Stress during Creep in a Die-Cast AM50 Magnesium Alloy at 473K
- Eutectic Phase Investigation in a Ca-added AM50 Magnesium Alloy Produced by Die Casting
- Reinforcement of carbonate apatite bone substitutes with carbonate apatite by Ca salt introduction
- Effect of Calcium Additions on Creep Properties of a Die-Cast AM50 Magnesium Alloy
- Effects of CaF_2 Addition on the Structure of CaO-Al_2O_3-SiO_2 Glasses
- Structure of Bioactive Glass and its Application to Glass Ionomer Cement
- Formulation of Glutaraldehyde Disinfectant for Alginate Impressions
- Creep Parameters in a Die-Cast Mg-Al-Ca Alloy
- In vitro osteoconductivity evaluation of alumina treated hydrothermally in CaCl2 solution
- Influence of Different Elastic Moduli of Dowel and Core on Stress Distribution in Root
- Effect of Hydrogenation on Zn0 Luminescence
- Effect of Prior Deformation on Creep Behavior of a Die-Cast Mg-Al-Ca Alloy
- Relationship between Minimum Creep Rate and Rupture Life for a Die-Cast Mg-Al-Mn Alloy
- Comparison of apatite-coated titanium prepared by blast coating and flame spray methods : Evaluation using simulated body fluid and initial histological study
- Hydrothermal calcium modification of 316L stainless steel and its apatite forming ability in simulated body fluid
- Assessment of Creep Rupture Life of Die-Cast Mg-Al-Mn Alloy
- Preparation of Sr-containing carbonate apatite as a bone substitute and its properties
- Fabrication of microporous calcite block from calcium hydroxide compact under carbon dioxide atmosphere at high temperature
- Fabrication of solid and hollow carbonate apatite microspheres as bone substitutes using calcite microspheres as a precursor
- Assessment of Vickers hardness, microstructure, and surface roughness of dentin after initial dissolution by acidulated phosphate-fluoride
- Measurement of vaporization cavity after CO_2 laser irradiation on bovine dentin
- The effects of treated time of acidulated phosphate fluoride solutions on enamel erosion
- HYDROTHERMAL ALTERATION AT THE DENBEKOBA DEPOSIT OF AMAKUSA POTTERY STONE
- Creep Properties of Binary Mg-Ca Cast Alloys at 473K
- Effect of precursor's solubility on the mechanical property of hydroxyapatite formed by dissolution-precipitation reaction of tricalcium phosphate
- SB-10-5(116) Change in Feature of Transient Creep with Decreasing Stress(Creep Deformation and Fracture of Superalloys)
- Influence of PLGA concentrations on structural and mechanical properties of carbonate apatite foam
- Redox reactions of cis-dialkylcobalt(III) complexes with benzyl and allyl bromides, induced by thermal cleavage of the cobalt-carbon bond.
- A Study Using the Interdental Thickness Discrimination Test at Three Different Degrees of Mouth Opening: Reproducibility and Gender Differences in Young Adults
- Field Trial with a Further Attenuated Live Measles Virus Vaccine