3次元熱弾塑性問題の平面変形問題への置換の可能性の検討 : 厚板補修接溶部の力学的特性(その2)(昭和63年度春季全国大会論文発表講演論文)

概要

論文の詳細を見る
In this paper, a model of repair welds is assumed for three-dimensional thermal elasto-plastic and two-dimensional plane-deformation thermal elasto-plastic analyses. The results of the analyses are compared in order to clear and to consider the mechanism necessary for replacing three-dimensional problems with plane-deformation problems. The summary of the main conclusions is as follows : From the results of three-dimensional thermal elasto-plastic analyses ; 1) In the portion which undergoes a quasi-steady state temperature history, whether there is temperature gradient along the weld line or not, the producing residual stresses and plastic strains are same at each cross section along weld line if the rigidity to thermal shrinkage is uniform. 2) The shorter of the length of repair weld and the slower of travel speed, the more stress component of perpendicular to weld line, σ_y increases. Moreover, the plastification is delayed by slow travel speed, so that plastic strain component of welding direction, ε^p_x decreases. From the comparison between the results of two-dimensional plane-deformation and three-dimensional analyses ; 3) Only when the weld length is long and there is no temperature gradient along the weld, three-dimensional problems can, in the strict sense of production mechanism, be replaced plane-deformation problems including the distribution and magnitude of transient and residual stresses and plastic strains. However, as residual stresses are controlled by the yield condition of a material, replacement of the three-dimensional problems with plane-deformation problems leads to estimation of the distribution and magnitude without large difference in the results. If the travel speed is decreased, it needs to be paid attention to underestimate σ_y in plane-deformation analysis. Whereas, since the distribution and magnitude of plastic strains are largely affected by the mechanical boundary conditions, the estimation of plastic strains are less accurate than that of residual stresses in plane-deformation analysis. 4) The temperature distribution for thermal elasto-plastic stress analysis of plane-deformation can be given from two-dimensional analysis which assumes no thermal conduction from the cross section. 5) According to the model, if the travel speed is ν≥0.0055 m/s in the portion which undergoes quasi-steady state until it cools down to 400℃ (the weld length ; l≥0.2 m, at least the middle parts of model undergoes quasi-steady state), the distribution and magnitude of residual stresses and plastic strains can be estimated from plane-deformation analysis. When only residual stresses are needed to be known, ν≥0.0017 m/s may be enough for the plane-deformation analysis to work out.
社団法人溶接学会の論文
1988-02-05

3次元熱弾塑性問題の平面変形問題への置換の可能性の検討 : 厚板補修接溶部の力学的特性(その2)(昭和63年度春季全国大会論文発表講演論文)

スポンサーリンク

概要

著者

関連論文

スポンサーリンク