多層かど継手部のラメラテア発生防止に関する研究

概要

論文の詳細を見る
Lamellar tearing of opening type occasionally occurs in multipass welded corner joints. Effects of gas cutting for the edge surface of the vertical plate and shapes of grooves on the occurrence of the lamellar tearing are investigated experimentally and theoretically. The main results obtained in this study are as follows. (1) In the cases where the edge surface of the vertical plate is prepared by gas cutting or machine, the transverse welding residual stress on the edge surface of the vertical plate reaches approximately the yield point at the position 10mm away from the toe and the lamellar tearing occurs, when the intensity of bending restraint increases. No difference between these cases is observed in the critical intensity of bending restraint for lamellar tearing. (2) In order to reduce transverse welding residual stresses and to prevent the occurrence of the lamellar tearing, it is effective to use such a groove that the edge of the vertical (web) plate is projected out of the upper surface of the flange plate or that the vertical plate is cut obliquely.
社団法人溶接学会の論文
1979-07-05