水冷法による円周多層突合せ溶接の残留応力とその生成機構

概要

論文の詳細を見る
Many pipes of stainless steel such as SUS 304 are used for various facilities including nuclear energy plants. In some specific conditions, stress corrosion cracking may occur on the inner surface of these pipes in the weld zone. In order to mechanically prevent the stress corrosion cracking from occurring, welding residual stresses on this surface should be converted into compressive ones. In the previous report, the authors showed effectiveness of the heat-sink welding (water cooling) to accomplish this end by conducting theoretical analysis and an experiment on residual stresses in the 4B pipe of SUS 304 by the conventional welding and the heat-sink welding at a certain standard heat-input condition. In this research, different pipe sizes and varied heat-input are applied. The welding residual stresses by the conventional welding and the heat-sink welding are obtained by the theoretical analysis and their production mechanisms are clarified. Hence the influence of the above changes of conditions on effectiveness of the heat-sink welding is investigated. The main results are summarized as follow. (1) In case of thin pipes such as 2B and 4B pipes, it is important to minimize heat-input per one pass (especially for latter half passes) in order to improve the effectiveness of the heat-sink welding. The effectiveness can be predicted either by theoretical analysis of the temperature distribution history with consideration of the characteristic of heat transfer under spray-watering or by experimental measurement. (2) In case of 24B pipes, thick pipes, it is desirable to minimize heat-input for the first half passes, by which the heat-sink welding becomes more effective. In addition, no matter whether the conventional welding or the heat-sink welding, it is important to prevent angular distorsion which produces tensile axial stresses on the inner surface of the pipe in the weld zone. Possible measures to meet these requirements are to apply restraining jigs, to minimize the section area of the groove (ex. application of the narrow gap arc welding), and to change continuous welding to skip one.
社団法人溶接学会の論文
1983-02-05

水冷法による円周多層突合せ溶接の残留応力とその生成機構

スポンサーリンク

概要

著者

関連論文

スポンサーリンク