Examination of Fatigue Failure of Metals by Means of Electro-Plating Method
スポンサーリンク
概要
著者
-
Murakami Sumio
Faculty Of Engineering Nagoya University
-
Hosono Kikuo
Faculty Of Engineering Nagoya University
-
OKUBO Hajime
Faculty of Engineering, Nagoya University
-
Okubo Hajime
Faculty Of Engineering Nagoya University
関連論文
- Elasto-Plastic Bending of Thin Annular Plates
- Large Elastoplastic Deflection of Thin Annular Plate
- On the Elasto-plastic Bending of a Clamped Circular Plate under a Partial Circular Uniform Load
- Measurement of Cyclic Stresses in High Temperature Range Using Nickel Electroplating : 3rd Report, Application of a Sulfamate Bath
- Measurement of Cyclis Stresses Caused in High Temperature Range by Nickel Electroplating : 4th Report, An Application of Copper Sulfate Bath for the Basal Plating
- Basic Study on Foil Strain Gauges Made of Electrodeposited Copper or Nickel
- Fundamental Studies on the Copper and Nickel Electroplating Methods of Stress Analysis : Effects of the Ground Plating on the Proper Stress
- Examination of Fatigue Failure of Metals by Means of Electro-Plating Method
- Measurement of Stress Concentrations in Threaded Connections
- Measurement of Cyclic Stresses in High Temperature Range Using Nickel Electroplating : 2nd Report, Examination of Applicable Temperature and Accuracy of Measured Values
- Measurement of Cyclic Stresses in High Temperature Range Using Nickel Electroplating : 1st Report, Plating Conditions and Calibration Tests
- Fundamental Study on a Foil Strain Gauge of Electrodeposited Nickel
- On the Understressing Effect of the Eutectoid Steel
- Examination of the Adaptability of the Copper Electroplating Method of Stress Analysis to the Low Temperature Range
- Application of the Extended Newton Method to the Steady-State Creep Analysis of Shells of Revolution
- Steady-State Creep of Circular Cylindrical Shells
- Transient Creep Analysis of Pressurized Circular Cylindrical Shells
- Effects of Hydrostatic Pressure and Material Anisotropy on the Transient Creep of Thick-Walled Tubes (the Transactions of the Japan Society of Mechanical Engineers) : Papers published in the Bulletin of the JSME are not included here