Steady-State Creep of Circular Cylindrical Shells

スポンサーリンク

概要

• 論文の詳細を見る

• Steady-state creep of simply supported circular cylindrical shells with open ends under internal pressure is analysed numerically by the extended Newton method combined with the method of finite-difference. Creep theory of Mises type and power creep law are assumed. Numerical calculation is carried out for long and short shells with creep exponents n=1 through 5. the effect of shell geometry and that o f non-linearity of creep law are elucidated in detail. The numerical results are compared with those of a semi-infinite sandwich shell. The present method of analysis was found to be quite stable, and accurate results were obtained by a few times of iteration.

• 一般社団法人日本機械学会の論文

著者

• Murakami Sumio

  Faculty Of Engineering Nagoya University

• IWATSUKI Shuhei

  Toyota Motor Company.

関連論文

• Elasto-Plastic Bending of Thin Annular Plates
• Large Elastoplastic Deflection of Thin Annular Plate
• On the Elasto-plastic Bending of a Clamped Circular Plate under a Partial Circular Uniform Load
• Examination of Fatigue Failure of Metals by Means of Electro-Plating Method
• Application of the Extended Newton Method to the Steady-State Creep Analysis of Shells of Revolution
• Steady-State Creep of Circular Cylindrical Shells
• Transient Creep Analysis of Pressurized Circular Cylindrical Shells
• Effects of Hydrostatic Pressure and Material Anisotropy on the Transient Creep of Thick-Walled Tubes (the Transactions of the Japan Society of Mechanical Engineers) : Papers published in the Bulletin of the JSME are not included here

スポンサーリンク