Analysis of saturated film boiling heat transfer in reflood phase of PWR-LOCA. Turbulent boundary layer model.:Turbulent Boundary Layer Model
スポンサーリンク
概要
- 論文の詳細を見る
The heat transfer regime just above the quench front during the reflood phase in PWR-LOCAs is the film boiling. A two-region model is developed for the description of saturated film boiling in this region. It is considered that the violent two-phase flow surrounds the vapor film and promotes the transition of laminar to turbulent vapor film in the reflood phase. In the model, the vapor film surrounded with the two-phase mixture core is treated with the turbulent boundary layer theory. The higher void fraction of the mixture core gives the lower heat transfer in the model. The results obtained by the model are compared with the data of the Slab Core Reflood Tests which cannot be explained with the previous laminar vapor film theory.<BR>The data fall between the curves predicted by the models assuming zero interfacial shear stress (τ<SUB>i</SUB>=0) and zero interfacial velocity (υ<SUB>i</SUB>=0) at the different elevations in the core, different core inlet velocities and different system pressures. These show the applicability of the two-region model for the reflood phase.
- 一般社団法人 日本原子力学会の論文
著者
-
Sudo Yukio
Japan Atomic Energy Research Institute
-
OSAKABE Masahiro
Japan Atomic Energy Research Institute
関連論文
- Experimental Study of Falling Water Limitation under a Counter-Current Flow in a Vertical Rectangular Channel : 1st Report, Effect of Flow Channel Configuration and Introduction of CCFL Correlation
- Heat Transfer Characteristics in Narrow Vertical Rectangular Channels Heated from Both Sides
- Improvement of Critical Heat Flux Correlation for Research Reactors using Plate-Type Fuel
- Mechanism of Falling Water Limitation under Counter-current Flow through a Vertical Flow Path
- Experimental Study of Homogeneously Dispersed Two-phase Critical Flow
- Core thermohydraulic design with 20% LEU fuel for upgraded research reactor JRR-3.
- Experimental study of incipient nucleate boiling in narrow vertical rectangular channel simulating subchannel of upgraded JRR-3.
- Simulation of PWR Turbine Trip Transient in ROSA-IV Large Scale Test Facility
- Analytical study on thermal-hydraulic behavior of transient from forced circulation to natural circulation in JRR-3.
- Experimental study of differences in DNB heat flux between upflow and downflow in vertical rectangular channel.
- Heat Transfer Calculation of Simulated Heater Rods throughout Reflood Phase in Postulated PWR-LOCA Experiments
- Estimation of average void fraction in vertical two-phase flow channel under low liquid velocity.
- Evaluation of Local Power Distribution with Fine-mesh Core Model for High Temperature Engineering Test Reactor (HTTR).
- Effects of partial flow blockage on core heat transfer in forced-feed reflood tests.
- Upper plenum dump during reflood in PWR loss-of-coolant accident.
- Prediction of Dryout Heat Flux for Particle Bed Simulating Degraded Core in LWR Severe Core Damage Accidents
- Combined forced and free convective heat transfer characteristics in narrow vertical rectangular channel heated from both sides.
- Downcomer effective water head during reflood in postulated PWR LOCA.
- Experimental study of differences in single-phase forced-convection heat transfer characteristics between upflow and downflow for narrow rectangular channel.
- Experimental study of upper core quench in PWR reflood phase.
- Parameter effects on downcomer penetration of ECC water in PWR-LOCA.
- Investigation of break orientation effect during cold leg small-break LOCA at ROSA-IV LSTF.
- Interfacial drag coefficient of air-water mixture in rod bundle.
- Characteristic of two-phase slanting flow in rod bundle.
- Two-phase flow pattern and heat transfer during core uncovery.
- Analysis of saturated film boiling heat transfer in reflood phase of PWR-LOCA. Turbulent boundary layer model.:Turbulent Boundary Layer Model
- Film boiling heat transfer during reflood phase in postulated PWR loss-of-coolant accident.