Heat Transfer Characteristics in Narrow Vertical Rectangular Channels Heated from Both Sides
スポンサーリンク
概要
- 論文の詳細を見る
The effects of gap size on heat transfer characteristics were investigated experimentally for a vertical rectangular flow channel with gaps of 2.5mm, 6mm and 18mm. As a result, the following was revealed. The flow shows a nature of forced convective heat transfer when Gr_x/Re^<(21)/18>_xPr^<1/2> is less than 2.5×10^<-4>, and a free-convective heat transfer when Gr_x/Re^<(21)/18>_xPr^<1/2> is higher than 1.8×10^<-3>, for all three gap sizes of the flow channel. As for the data for a gap of 2.5mm in the transition region between forced convection and free convection, it was confirmed that the heat transfer coefficient higher than that predicted by the heat transfer correlation for turbulent forced convection along a flat plate was due to the acceleration of the main flow through the development of the boundary layer, not to buoyancy force.
- 一般社団法人日本機械学会の論文
- 1990-11-15
著者
-
Kaminaga Masanori
Japan Atomic Energy Research Institute
-
Usui Tohru
Nkk Corporation
-
Sudo Yukio
Japan Atomic Energy Research Institute
関連論文
- ICONE11-36128 THERMAL-HYDRAULIC EXPERIMENTS AND ANALYSES FOR COLD MODERATORES
- Experimental Study of Falling Water Limitation under a Counter-Current Flow in a Vertical Rectangular Channel : 1st Report, Effect of Flow Channel Configuration and Introduction of CCFL Correlation
- Heat Transfer Characteristics in Narrow Vertical Rectangular Channels Heated from Both Sides
- Experiments on Mercury Circulation System for Spallation Neutron Target
- ICONE11-36146 WATER FLOW EXPERIMENTS AND ANALYSES ON THE CROSS-FLOW TYPE MERCURY TARGET WITH PERFORATED PLATES
- ICONE11-36101 MERCURY TARGET THERMAL HYDRAULIC DEDIGN FOR JAERI SPALLATION NEUTRON SOURCE
- ICONE11-36079 Mercury Erosion Experiments for Spallation Target System
- ICONE11-36094 STRUCTURAL INTEGRITY OF BEAM WINDOW OF MERCURY TARGET
- Improvement of Critical Heat Flux Correlation for Research Reactors using Plate-Type Fuel
- Mechanism of Falling Water Limitation under Counter-current Flow through a Vertical Flow Path
- Experimental Study of Homogeneously Dispersed Two-phase Critical Flow
- Core thermohydraulic design with 20% LEU fuel for upgraded research reactor JRR-3.
- Experimental study of incipient nucleate boiling in narrow vertical rectangular channel simulating subchannel of upgraded JRR-3.
- Analytical study on thermal-hydraulic behavior of transient from forced circulation to natural circulation in JRR-3.
- Experimental study of differences in DNB heat flux between upflow and downflow in vertical rectangular channel.
- Heat Transfer Calculation of Simulated Heater Rods throughout Reflood Phase in Postulated PWR-LOCA Experiments
- Estimation of average void fraction in vertical two-phase flow channel under low liquid velocity.
- Evaluation of Local Power Distribution with Fine-mesh Core Model for High Temperature Engineering Test Reactor (HTTR).
- Effects of partial flow blockage on core heat transfer in forced-feed reflood tests.
- Upper plenum dump during reflood in PWR loss-of-coolant accident.
- Prediction of Dryout Heat Flux for Particle Bed Simulating Degraded Core in LWR Severe Core Damage Accidents
- Combined forced and free convective heat transfer characteristics in narrow vertical rectangular channel heated from both sides.
- Downcomer effective water head during reflood in postulated PWR LOCA.
- Experimental study of differences in single-phase forced-convection heat transfer characteristics between upflow and downflow for narrow rectangular channel.
- Experimental study of upper core quench in PWR reflood phase.
- Parameter effects on downcomer penetration of ECC water in PWR-LOCA.
- Analysis of saturated film boiling heat transfer in reflood phase of PWR-LOCA. Turbulent boundary layer model.:Turbulent Boundary Layer Model
- Film boiling heat transfer during reflood phase in postulated PWR loss-of-coolant accident.