Core thermohydraulic design with 20% LEU fuel for upgraded research reactor JRR-3.

概要

論文の詳細を見る
This paper presents the outline of the core thermohydraulic design and analysis of the research reactor JRR-3, which is to be upgraded to a 20 MWt pool-type, light water-cooled reactor with 20% low enriched uranium (LEU) plate-type fuel. For the condition of normal operation, the upgraded JRR-3 core is planned to be cooled by two cooling modes of forced-convection at high power and natural-convection at low power. The major feature of core thermohydraulics is that at the forced-convection cooling mode the core flow is a downflow, under which fuel plates are exposed to a severer condition than an upflow in cases of operational transients and accidents. The core thermohydraulic design was, therefore, done for the condition of normal operation so that fuel plates may have enough safety margins both against the onset of nucleate boiling (ONB) not to allow the nucleate boiling anywhere in the core and against the departure from nucleate boiling (DNB). The safety margins against ONB and DNB were evaluated. The core velocity thus designed is at the optimum condition where fuel plates have the maximum margin against the ONB, and the minimum DNB ratio (ratio of DNB heat flux to the maximum heat flux) was evaluated to be about 2.1, which gives a sufficient margin against the DNB. The core thermohydraulic characteristics were also clarified for the natural-convection cooling mode.
一般社団法人日本原子力学会の論文