Dissolution Behavior of SUS304 Stainless Steel due to General Corrosion in H2SO4-NaCl Aqueous Solution (特集 自動車用焼結部品の高性能化・高機能化および経済性)
スポンサーリンク
概要
- 論文の詳細を見る
In this experiment, three kinds of sintered SUS304 stainless steels (P/M stainless steels) whose porosity ratios were 17.06 (compressed at 392 MPa), 11.78 (compressed at 588 MPa) and 8.75% (compressed at 784 MPa) were used. The dissolution behavior of these sintered SUS304 stainless steels in the aqueous solution composed of H2SO4 and NaCl were examined compared with that of the conventionally processed SUS304 stainless steel (I/M specimen). All of the P/M SUS304 specimens showed almost linear increment of corrosion mass loss against reaction time and the specimen with higher porosity ratio showed more mass loss, while the I/M specimen showed evidently much less mass loss than any P/M specimens. The reactivation ratio for the P/M SUS304 specimen was higher than the I/M SUS304 specimen and it increased almost linearly with increasing porosity ratio. In the case of 72 ks of reaction time, the charge transfer resistance, Rct, is highest in the specimen compressed at 785 MPa, while it is lowest in the P/M specimen compressed at 392 MPa. In the longer region than 144 ks, all of the three P/M specimens show the almost constant Rct value of 200 Ω. These Rct tendencies well correspond to the time dependence curve of mass loss.
- 社団法人粉体粉末冶金協会の論文
- 2005-07-15
著者
-
Majima Kazuhiko
Department Of Material Systems Engineering And Life Science Faculty Of Engineering University Of Toy
-
Sunada Satoshi
Department Of Material Systems Engineering And Life Science Faculty Of Engineering University Of Toy
-
Matsuda Takeshi
Department Of Cardiology School Of Medicine Kanazawa Medical University
-
Majima Kazuhiko
Department Of Materials Systems Engineering And Life Science Faculty Of Engineering Toyama Universit
-
Sunada Satoshi
Department Of Materials Systems Engineering And Life Science Faculty Of Engineering Toyama Universit
関連論文
- Effect of Partical Substitution of 3d Transition Metals for Co on the Thermoelectric Properties of Na_xCo_2O_4
- Preparation of SiC Dispersed Fe_Co_Si_2 by Pressureless Sintering with Cu and Si Addition and Its Thermoelectric Performance
- 液相焼結法によるβ-FeSi_2の作製とその熱電特性
- Effects of Al and Cu Addition on Pressureless Sintering behavior and Phase Transformation of β-FeSi_2
- Effect of Si/C Ratio on thermoelectric Properties of β-FeSi_2 Mechanically Alloyed with (Si+C) Additions
- Thermoelectric Properties of β-FeSi_2 Mechanically Alloyed with Si and C
- Effects of Mechanical Alloying and Copper Addition on Thermoelectric Properties of n-Type and p-Type β-FeSi_2
- Improvement of Magnetic Properties of Mechanically Ground Sm_2Fe_N_x Powders by Vacuum Heat Treatment
- Effect of Milling Atmosphere on the Preparation of Sm_2Fe_N_x Powder by Mechanical Grinding
- Effectiveness of Iron Clusters as Pinning Centers in the YBa_2(Cu_Fe_x)_3O_y System
- -P564- ELECTRON MICROSCOPIC SYUDY OF MYOCARDITIS PATIENTS:OBSERVATIONS OF MITOCHONDRIAL CYTOCHROME OXIDASE ACTIVITY(PROCEEDINGS OF THE 59th ANNUAL SCIENTIFIC MEETING OF THE JAPANESE CIRCULATION SOCIETY)
- -398- INFLUENCE OF EACH CORONARY RISK FACTORS ON CORONARY ARTERIOGRAPHIC FEATURES IN PATIENTS WITH CORONARY STENOTIC LESIONS
- Stress engineering of the alkoxide derived ferroelectric thin film on Si wafer
- Effect of monodispersed silica nanoparticles on DNA separation by micro-capillary electrophoresis
- Pentane Isomerization over Molybdenum Oxide Prepared by H_2 Reduction of a Hydrogen Molybdenum Bronze
- Effect of the Flow Rate of H_2 in the Reduction Process on the Physical and Catalytic Properties of H_2-Reduced Pt/MoO_3
- Effect of H_2 Flow Rate in Reduction Process on the Catalytic Properties of Reduced MoO_3
- Dehydration of 2-Propanol over Molybdenum Oxide Treated with Hydrogen
- Catalytic Properties of Ni-MoO_3 for the Isomerization of Heptane
- Effect of Temporal Subtraction Technique on the Diagnosis of Primary Lung Cancer with Chest Radiography
- Effect of Ga on Stress Corrosion Cracking Characteristics of Al-9 mass%Mg Alloys
- Characteristics of MoO_3 Reduced with H_2 at the Different Flow Rates of H_2
- The Conventional Transport Properties of Primary Solid Solutions. : I. Indium Rich Alloys.
- Chaos and Multi-Attractors in Fully Chaotic 2D Microcavity Lasers(Quantum Mechanics and Chaos)
- The Pressure Effect of the Hall Coefficient of Indium and Indium Rich Alloys
- Influences of Concentrations of H_2SO_4 and NaCl on Stress Corrosion Cracking of SUS304 Stainless Steel in H_2SO_4-NaCl Aqueous Solutions
- Anomalous Electrical Resistivity of Bi-Sr-Ca-Cu-O System at High Temperature
- Evaluation of Pitting Corrosion Behavior of Sintered SUS444 Stainless Steel in MgCl2 Solution (特集 粉末プロセスの制御と製品の評価)
- Microstructures and Hydrogen Permeability of Nb-Ti-Ni Alloys with High Resistance to Hydrogen Embrittlement
- Solar Energetic Particles Studied from Yohkoh Gamma-Ray Observations
- Preparation of Al-Pd-Mn Quasicrystal Films by Laser Ablation Method
- Complete Cure of Malignant Lymphoma of the Stomach with a Huge Adrenal Lesion Achieved by Preoperative Chemotherapy and Surgery : Report of a Case
- Effect of Stress Engineering on the Electrical Properties of BaTiO3 Thin Film
- Low-Temperature Specific Heat and Electrical Resistivity Measurements of Hydrogen-Absorbed Pd-Zr and Ni-Zr Metallic Glasses
- Magnetic Properties of Sm_2Fe_N_x Powders Prepared by Mechanical Grinding
- Hall Coefficient of Aluminium Rich Alloys
- Two-Dimensional Weak Localization Effect in Amorphous Cu-Mg Alloys
- Control of the coating layer thickness of TiO_2-SiO_2 core-shell hybrid particles by liquid phase deposition
- Dissolution Behavior of SUS304 Stainless Steel due to General Corrosion in H2SO4-NaCl Aqueous Solution (特集 自動車用焼結部品の高性能化・高機能化および経済性)
- Strain-Induced Electrical Properties of Lead Zirconate Titanate Thin Films on a Si wafer with Controlled Oxide Electrode Structure (Special Issue : Ferroelectric Materials and Their Applications)
- Preparation and Characterization of Alkoxide-Derived Lead-Free Piezoelectric Barium Zirconate Titanate Thin Films with Different Compositions
- Origin of Compressive Residual Stress in Alkoxide Derived PbTiO3 Thin Film on Si Wafer
- Thickness Dependence of Residual Stress in Alkoxide-Derived Pb(Zr0.3Ti0.7)O3 Thin Film by Chemical Solution Deposition
- A method for preparing a large sized, uniform and stable built-up film of 109Cd icosanoate as a radioactive source by utilization of an extremely small amount of substrate solution.
- Stability of $\alpha$ and $\beta$ Phases of Noble Metal Alloys