気液二相流を考慮した底吹きガス攪拌取鍋内溶鋼流動の数値解析
スポンサーリンク
概要
- 論文の詳細を見る
The numerical simulation of the fluid flow in the bottom-gas blowing ladle was conducted by the use of the two phase model. In the model not only the balances of mass, momentum and turbulent characteristics κ and ε in metal phase but also those of mass and momentum in gas phase are taken into account. The accuracy of the calculation was confirmed by the comparison of the flow velocities and turbulent kinetic energies between the calculation and the measurement in a water model test using the laser doppler anemometer. The mean velocities in the plume zone where both metal and gas went up were expressed as a function of Froude number and the aspect ratio of molten bath.
- 社団法人日本鉄鋼協会の論文
- 1987-04-01
著者
-
大橋 徹郎
新日本製鉄(株)広畑製鉄所
-
沢田 郁夫
新日本製鐵(株)先端技術研究所
-
沢田 郁夫
新日本製鉄(株)先端技術研究所
-
沢田 郁夫
新日本製鉄
-
沢田 郁夫
新日本製鉄(株)未来領域研究センター
-
大橋 徹郎
新日本製鉄(株)中央研究本部
関連論文
- 連鋳鋳片におけるバルジングのクリープモデルによる解析(鋼の連続)
- 凝固点直下における鋼の脆化挙動について
- アルミナ付着におよぼす浸漬ノズル中カーボン, シリカの影響
- カーボンレス高アルミナ質浸漬ノズルの開発
- 連続鋳造スラブの内部割れ発生限界歪みの推定
- 200 鋳片変形挙動のシミュレーション解析 : ローヘッド連鋳法の矯正理論第 2 報(新連鋳, バルジング, 製鋼, 日本鉄鋼協会第 112 回(秋季)講演大会)
- タンディッシュ内の非金属介在物の凝集および分離
- ラージエディシミュレーションによる鋳型内溶鋼流動の数値解析
- 159 溶鋼脱 S 反応の理論解析(製精錬基礎 (II), 製銑・製鋼共通, 日本鉄鋼協会第 112 回(秋季)講演大会)
- 連続鋳造浸漬ノズルの介在物付着に及ぼす耐火物材質の影響と介在物付着モデルに基づく考察