Lowering Reduction Temperature of Iron Ore and Carbon Composite by Using Ores with High Combined Water Content
スポンサーリンク
概要
- 論文の詳細を見る
The steel industry is facing two difficult and urgent tasks to reduce CO2 emissions and to use low-grade iron resources effectively. The utilization of an iron ore–carbon composite is one of the promising methods to solve the former. The latter is concerning to goethite ores such as Australian Marra Mamba and pisolite ores, which contain high concentration of combined water. In this study, the effect of combined water on the reduction behavior of the iron ore–coal composites at elevating temperature was examined under inert gas flow.Below 1200 K, the reduction of iron oxide in Marra Mamba ore–coal and pisolite ore–coal composites proceeded faster than that in hematite ore–coal composite. It can be attributed to the larger specific surface area of the ores after decomposition of the combined water. Metallic iron also formed at lower temperature in the composites containing Marra Mamba and pisolite ores. The generation rate of CO gas from these composites showed the maximum value at approximately 1170 K; however, that from the hematite-coal composite gave no peak, because formed metallic iron could act as a catalyst for the gasification of carbon. These results indicate that the reduction of ores with high combined water concentration can proceed at lower temperature. Above 1373 K, however, the reduction rate of these ores in the composite significantly decreased due to a drastic decrease in the specific surface area of the ores and the formation of slag.
- 社団法人 日本鉄鋼協会の論文
- 2009-11-15
著者
-
KASAI Eiki
Institute of Multidisciplinary Research for Advanced Materials (IMRAM), Tohoku University
-
Murakami Taichi
Institute of Multidisciplinary Research for Advanced Materials, Tohoku University
-
Murakami Taichi
Institute Of Multidisciplinary Research For Advanced Materials Tohoku University
-
Kasai Eiki
Institute For Advanced Materials Processing Tohoku University
-
NISHIMURA Takeshi
Institute of Multidisciplinary Research for Advanced Materials, Tohoku University
-
Kasai Eiki
Institute For Advance Materials Processing Tohoku University
-
Nishimura Takeshi
Institute Of Multidisciplinary Research For Advanced Materials Tohoku University
関連論文
- Vapor Pressure of Zinc and Zinc Chloride in the Fe_tO-CaO-SiO_2-Al_2O_3 Slag System
- Vaporization Behavior of Zinc from the FeO-CaO-SiO_2-Al_2O_3 Slag System
- Vapor Pressure Measurements for Metal Chloride Systems by the Knudsen Effusion Method
- Surface Hardening Treatment for Titanium Materials Using Ar-5%CO Gas in Combination with Post Heat Treatment under Vacuum
- Vapour Pressure Determination for PCDD/Fs by Knudsen Effusion Method
- Vapour Pressure Determination for Dibenzo-p-dioxin, Dibenzofuran, Octachlorodibenzo-p-dioxin and Octachlorodibenzofuran Using a Knudsen Effusion Method
- DIOXIN EMISSIONS IN RECYCLING PROCESSES OF METALS
- Measurement of Thermodynamic Functions of Solid Phase for DD, DF,OCDD and OCDF, and Estimation of Thermodynamic Functions of Gas Phase for PCDD/Fs Using Molecular Orbital Method with Density Functional Theory
- Determination of Vapor Pressures of PCDD/Fs by Kundsen Method
- Catalytic Performance of Several Metallic Oxides on The Elimination Reactions of NO
- Alkali Hydrothermal Synthesis of Zeolite A Using Oxide By-products
- Dynamic and Static Restoration Behaviors of Pure Lead and Tin in the Ambient Temperature Range
- Numerical Simulation of Laser Fusion Zone Profile of Lotus-Type Porous Metals
- Numerical Simulation of Laser Fusion Zone Profile of Lotus-Type Porous Metals (Special Issue on Porous and Foamed Metals--Fabrication, Characterization, Properties and Applications)
- The Effect of Solute Elements on Hardness and Grain Size in Platinum Based Binary Alloys
- Development of a New Method for Manufacturing Iron Foam Using Gases Generated by Reduction of Iron Oxide
- Hydrothermal Synthesis of Zeolite A Using Blast Furnace Slag
- Thermodynamic Analysis of Thermochemical Recovery of High Temperature Wastes
- Macroscopic Behaviors of Dioxins in the Iron Ore Sintering Plants
- Reaction Model and Reduction Behavior of Carbon Iron Ore Composite in Blast Furnace
- Alloy Design and Properties of New α+β Titanium Alloy with Excellent Cold Workability, Superplasticity and Cytocompatibility
- Differential Thermal Analysis of Assimilation and Melt-formation Phenomena in the Sintering Process of Iron Ores
- Rate of Methane-steam Reforming Reaction on the Surface of Molten BF Slag-for Heat Racovery from Molten Slag by Using a Chemical Reaction-
- Reduction in Dioxin Emissions by the Addition of Urea as Aqueous Solution to High-temperature Combustion Gas
- Evaluation of Sliding Wear Resistant Property of C. P. Titanium and SP-700 Titanium Alloy Surface-hardened by Ar-5%CO Gas
- Variations in the Microstructure and Hardness with Solution Treating and Aging Conditions in New α+β Titanium Alloy Ti-4.5%Al-6%Nb-2%Fe-2%Mo
- β Grain Refinement due to Small Amounts of Yttrium Addition in α+β Type Titanium Alloy, SP-700
- Effect of Cr_2O_3 and WO_3 Addition on Pore Formation and Microstructure in Iron Foam
- Lowering Reduction Temperature of Iron Ore and Carbon Composite by Using Ores with High Combined Water Content
- Reduction Behavior of Hematite Composite Containing Polyethylene and Graphite with Different Structures with Increasing Temperature
- Feasibility of Rotary Cup Atomizer for Slag Granulation
- Effect of Raw Materials Bed Segregation on the Structural Change of Iron Ore Sintering Bed
- GRINDING OF EP DUST AND ITS EFFECT ON SOLUBILITY OF METAL COMPOUNDS IN WATER
- EFFECT OF DRY MIXED GRINDING OF TALC, KAOLINITE AND GIBBSITE ON PREPARATION OF CORDIERITE CERAMICS
- Observation of Behavior of Dioxins and Some Relating Elements in Iron Ore Sintering Bed by Quenching Pot Test
- A New Drying Process of Dusts and Sludge by Employing Heat Storage Materials
- Recent trends in the decomposition of chlorinated aromatic hydrocarbons by ultrasound irradiation and Fenton's reagent
- Effect of Additives on the Dioxins Emissions in the Iron Ore Sintering Process
- Carbothermic Reduction in the Combustion Bed Packed with Composite Pelles of Iron Oxide and Coal
- Suppression of the Formation of Large Pores in the Assimilated Parts of Sinter Produced Using Pisolitic Ores
- Formation of Dioxins and their Transfer in the Combustion Bed of Coke and Soil Containing PVC
- Remediation Technologies of Ash and Soil Contaminated by Dioxins and Relating Hazardous Compounds
- (1) REMOVAL OF IRON BEARING MINERALS FROM BAUXITE BY HIGH GRADIENT MAGNETIC SEPARATOR (One-day Symposium on Separation Technology) (Miscellany)
- Heat Transfer Analysis of the Mosaic Embedding Iron Ore Sintering (MEBIOS) Process
- Process Analysis of the Effective Utilization of Molten Slag Heat by Direct Blast Furnace Cement Production System
- Analysis of Granules Behavior in Continuous Drum Mixer by DEM
- Numerical Simulation Model for Granulation Kinetics of Iron Ores
- Effect of Chlorine on the Vaporization Behavior of Zinc and Lead during High Temperature Treatment of Dust and Fly Ash
- Utilization of Ores with High Combined Water Content for Ore–carbon Composite and Iron Coke
- Effect of Mixed-grinding on Reduction Process of Carbonaceous Material and Iron Oxide Composite
- Design of Bed Structure Aiming the Control of Void Structure Formed in the Sinter Cake
- Numerical Simulation Model of the Iron Ore Sintering Process Directly Describing the Agglomeration Phenomenon of Granules in the Packed Bed
- Modeling of Iron Ore Sintering Process by Combining Discrete Element Method and Gas-solid Heat Transfer Equiations
- Effect of Heat Wave Propagation on the Structural Changes in the Iron Ore Sintering Bed
- EFFECT OF MIXED DRINDING OF POWDERS ON SUPERCONDUCTING PROPERTIES OF YBa_2 Cu_3 O_ CERAMICS
- Alkali Hydrothermal Synthesis of Zeolite A Using Oxide By-products
- Effects of Slag Compositions on the Rate of Methane-Steam Reaction
- Theoretical Design of Cup Atomizer for Heat Recovery of Molten Slag by Chemical Quench
- Effect of Slag Basicity on the Rate of Methane-steam Reaction
- Essential Factors Governing Strength of Sintered Iron Ore Particles
- Reduction Mechanism of Iron Oxide-Carbon Composite with Polyethylene at Lower Temperature
- Preface to the Special Issue on "Recent Progress of the Research on the Iron Ore Agglomeration Process"
- Influence of Properties of Fluxing Materials on the Flow of Melt Formed in the Sintering Process
- EFFECT OF WATER CONTENT ON GRINDABILITY OF DOLOMITE AND ITS STRUCTURAL CHANGE
- Recovery of Calcium from BF Slag and Synthesis of Zeolite A Using Its Residue