Steam Reforming of Ethanol Using Silica-Coated Alumite Catalysts on Aluminum Plates (JIS A3003)
スポンサーリンク
概要
- 論文の詳細を見る
The aim of this work is to develop a high performance heat exchanger type reactor with plate catalysts for proton exchange membrane fuel cell (PEMFC) systems and other applications. Steam reforming of ethanol using silica-coated alumite catalysts on aluminum plates (JIS A3003) was performed in a preliminary study at atmospheric pressure in a temperature range of 300–600°C using a plug flow reactor. Alumite catalysts, prepared by anodic oxidation of aluminum plates, are advantageous for the endothermic reaction of steam reforming because of their good thermal conductivity. However, in an ethanol steam reforming test performed with an alumite support (γ-Al2O3/Al plate) or an alumite catalyst (Ni/γ-Al2O3/Al plate), ethylene was produced as the main byproduct because of the dehydration reaction of ethanol. In order to inhibit ethylene formation, silica-coated alumite supports (Silica/Al2O3/Al plate) and silica-coated alumite catalysts (Ni/Silica/Al2O3/Al plate) were prepared using two types of silica sols with different particle size. As a result, the formation of ethylene (C2H4) under a condition of the same apparent support/catalyst surface area was reduced dramatically with both the silica-coated alumite supports and the silica-coated alumite catalysts. For example, with the silica-coated alumite catalyst (Ni/Silica/Al2O3/Al plate) prepared with a silica sol having a smaller particle size (particle diameter: 8–11 nm), C2H4 was reduced by 88% at 450°C, by 45% at 500°C and by 57% at 550°C compared with the levels seen for the alumite catalyst (Ni/γ-Al2O3/Al plate). A temperature programmed desorption analysis with ammonia desorption showed that the number of acidic sites per apparent surface area of the silica-coated alumite supports and the silica-coated alumite catalysts was smaller than that of the alumite support and that of the alumite catalyst without any silica coating. These results suggest that the low level of ethylene formation seen for both the silica-coated alumite supports and silica-coated alumite catalysts can be attributed to the smaller number of acidic sites. It is concluded that the silica-coating method is preferable for improving the properties of alumite supports and alumite catalysts for ethanol steam reforming.
- 社団法人 化学工学会の論文
- 2006-05-01
著者
-
亀山 秀雄
東京農工大学
-
SAKURAI Makoto
Department of Chemical Engineering, Tokyo University of Agriculture and Technology
-
KAMEYAMA Hideo
Department of Chemical Engineering, Tokyo University of Agriculture and Technology
-
Kameyama Hideo
Department Of Chemical Engineering Faculty Of Engineering Tokyo University Of Agriculture And Techno
-
KITAJIMA Teiji
Department of Chemical Engineering, Faculty of Engineering, Tokyo University of Agriculture and Tech
-
Hasan Ariful
Department Of Chemical Engineering Faculty Of Engineering Tokyo University Of Agriculture And Techno
-
Kitajima Teiji
Department Of Chemical Engineering Faculty Of Engineering Tokyo University Of Agriculture And Techno
-
Sakurai Makoto
Department Of Cardiovascular Surgery Osaka Medical Center For Cancer And Cardiovascular Diseases
-
Sakurai Makoto
Department Of Chemical Engineering Faculty Of Engineering Tokyo University Of Agriculture And Techno
-
CHAUDHURY Sharif
Department of Chemical Engineering, Faculty of Engineering, Tokyo University of Agriculture and Tech
-
IWASAKI Yasukazu
Technology Research Laboratory No. 3, Nissan Research Center, Nissan Motor Co., Ltd.
-
Chaudhury Sharif
Department Of Chemical Engineering Faculty Of Engineering Tokyo University Of Agriculture And Techno
-
Kameyama Hideo
Dep. Of Chemical Engineering Tokyo Univ. Of Agriculture And Technol.
-
Sakurai Makoto
Department Of Applied Chemistry College Of Engineering Chubu University
-
Iwasaki Yasukazu
Society And Frontier Laboratory Nissan Research Center Nissan Motor Co. Ltd.
関連論文
- 4-324 標準化教育に関する国際共同研究 : オランダ・エラスムス大学,中国計量学院,東京農工大学の3大学による共同研究(口頭発表論文,(19)国際化時代における工学教育-II)
- 集団活動でのロジックモデル利用の模擬実験と研究支援システムの発展性検討
- ベンチャー企業家による新春座談会
- ロジックモデルとバランススコカードの有効性について
- A-9 ロジックモデルとバランススコカードの有効性について(PMコンセプト,日本発信の仕組みP2Mコンセプト明確化と発展的展開-イノベーションを促進し、競争力再生と人材育成に貢献する-)
- 放電光触媒反応器による有機塩素化合物の分解に関する研究
- B-3 大学におけるロジックモデルの効用評価と研究支援システムの発展性検討(モデル化、システム化/活性化と組織,経済危機を突破するイノベーション経営の仕組みと仕掛け-新たなものづくり、ことづくり、絆づくり-)
- 資源・エネルギー
- 水素製造技術
- 産学官連携に向けて大学の試み : 東京農工大学の取り組み