Evaluation of Demolding Energy for Various Demolding Modes in Embossing Process
スポンサーリンク
概要
- 論文の詳細を見る
To investigate the demolding process in the UV embossing process, a three-axis controlled test rig is newly developed to realize various demolding motions. Using this test rig, the energy required for demolding is evaluated in various releasing modes and at various aspect ratios of molds. Demolding energy increases as the aspect ratio of the pattern increases. The peeling mode consumes a lower demolding energy than the newly proposed screw mode (twisting releasing) and the lift-off mode (vertical releasing) nevertheless; the screw mode is effective for an alternative pattern layout.
- 2013-06-25
著者
-
Hirai Yoshihiko
Physics And Electronics Engineering Osaka Prefecture University
-
Kawata Hiroaki
Physics and Electronics Engineering, Graduate School of Engineering, Osaka Prefecture University, Sakai 599-8531, Japan
-
Hirai Yoshihiko
Physics and Electronics Engineering, Osaka Prefecture University, Sakai 599-8531, Japan
-
Nishino Tomoki
Physics and Electronics Engineering, Osaka Prefecture University, Sakai 599-8531, Japan
-
Fujikawa Norihiro
Physics and Electronics Engineering, Osaka Prefecture University, Sakai 599-8531, Japan
-
Kawata Hiroaki
Physics and Electronics Engineering, Osaka Prefecture University, Sakai 599-8531, Japan
関連論文
- Fabrication of 3-dimensional structure by nanoimprint process
- Impact of Resist Shrinkage and Its Correction in Nanoimprint Lithography
- Numerical and Experimental Analysis of Intermittent Line-and-Space Patterns in Thermal Nanoimprint
- Novel Heterostructured Organic Photovoltaics Formed by Multilayered Direct Nanoimprinting
- Evaluation of Demolding Energy for Various Demolding Modes in Embossing Process
- Fabrication of Imprint Mold with Nanotrench Patterns by Edge Lithography