Electrolysis Free Micro EDM in Water Using Electrostatic Induction Feeding Method
スポンサーリンク
概要
- 論文の詳細を見る
This paper describes the machining characteristics of electrolysis-free micro EDM in water using the electrostatic induction feeding method. With the electrostatic induction feeding method, if deionized water is used for the working liquid, electrolysis can be prevented because bipolar voltage is applied to the working gap. Results of micro-holes drilling showed that the material removal rate with deionized water is higher than that with oil, and the oversize of holes machined in deionized water is smaller. Moreover, micro-holes could be drilled successfully even in a tap water with the oversize of several micrometers using this method.
著者
-
Kunieda Masanori
Department Of Mechanical System Engineering Tokyo University Of Agriculture And Technology
-
Koyano Tomohiro
Department Of Applied Chemistry Faculty Of Engineering Kanagawa University
関連論文
- EDM Using Combined Pulse Lines
- Development of parallel spark electrical discharge machining
- Study on Influence of Stray Capacitance on Micro EDM Using Electrostatic Induction Feeding
- Study on Influence of Stray Capacitance on Micro EDM using Electrostatic Induction Feeding
- D32 Effect of Anisotropy on Shape Measurement Accuracy of Silicon Wafer Using Three-Point-Support Inverting Method(Nano/micro measurement and intelligent instruments)
- Accuracy Estimation of Shape Measurement of Thin-Large Panel with Three-Point-Support Inverting Method
- Accuracy estimation of shape measurement of thin-large panel with three-point-support inverting method(Nano/micro measurement and intelligent instrument)
- リチウム二次電池用正極活物質としてのLiMyNi1-yO2(M=Ca,In,Nb)の充電過程における構造変化
- Study on Expansion Process of EDM Arc Plasma
- Observation of Temporal Changes of Arc Plasma in EDM(Electrical machining)
- Simulation of Wear of Tool Electrode with Sharp Edges in EDM(Electrical machining)
- Temperature Distribution Measurement in EDM Arc Plasma Using Spectroscopy
- Analysis of electromagnetic force in wire-EDM
- Simulation of Wire EDM under Rough Cutting Conditions(Electrical machining)
- Study on Self-excited Vibration of Wire Electrode in Wire-EDM
- Analysis of Electromagnetic Force in Rough Cutting of Wire-EDM
- Study on thermal equilibrium in EDM arc plasma by spectroscopic analysis
- Generating complicated surface with electrolyte jet machining
- Electrolyte Jet Machining Using Multiple Nozzles
- Effects of support method and mechanical property of 300mm silicon wafer on sori measurement
- Clarifying EDM Gap Phenomena by Gas Chromatography Analysis of Bubbles
- Analysis of Electromagnetic Force in Rough Cutting of Wire-EDM
- Time Variation and Mechanism of Determining Power Distribution in Electrodes during EDM Process
- Study on Dry WEDMed Surface Layer of Cold Tool Steel SKD11
- Reaction Forces Observed in Pulse Discharges of EDM
- Simulation of Die-Sinking EDM by Discharge Location Searching Algorithm
- Factors Determining Discharge Location in EDM
- Challenges in EDM Technology
- Study on the Distribution of Scattered Debris Generated by a Single Pulse Discharge in EDM Process
- Reduction of Tool Wear in Non-contact Electrostatic Induction Feeding EDM
- Study on Debris Movement in EDM Gap
- Clarification of EDM Phenomena by Spectroscopic Analysis
- Electrolysis Free Micro EDM in Water Using Electrostatic Induction Feeding Method