Observation of Temporal Changes of Arc Plasma in EDM(Electrical machining)
スポンサーリンク
概要
- 論文の詳細を見る
In order to understand electrical discharge machining (EDM) phenomena, the characteristics of transition arc plasma in EDM were investigated. The arc plasma was directly observed with a high speed video camera. In addition, to learn more about arc plasma expansion, plasma temperature was measured by spectroscopy. The arc plasma temperature was obtained by measuring the radiant fluxes of two different wavelengths from the arc plasma and applying the line pair method. Furthermore, a new expansion model for EDM arc plasma was proposed based on the observations, and validated by comparing experimental and computed results of the discharge crater.
- 2005-10-18
著者
-
Kunieda Masanori
Department Of Mechanical System Engineering Tokyo University Of Agriculture And Technology
-
Shimoyamada Mayumi
Department Of Mechanical Systems Engineering Tokyo University Of Agriculture & Technology
-
Natsu Wataru
Department Of Mechanical Engineering Tokyo University Of Agriculture And Technology
関連論文
- EDM Using Combined Pulse Lines
- Development of parallel spark electrical discharge machining
- Study on Influence of Stray Capacitance on Micro EDM Using Electrostatic Induction Feeding
- Study on Influence of Stray Capacitance on Micro EDM using Electrostatic Induction Feeding
- D32 Effect of Anisotropy on Shape Measurement Accuracy of Silicon Wafer Using Three-Point-Support Inverting Method(Nano/micro measurement and intelligent instruments)
- Accuracy Estimation of Shape Measurement of Thin-Large Panel with Three-Point-Support Inverting Method
- Accuracy estimation of shape measurement of thin-large panel with three-point-support inverting method(Nano/micro measurement and intelligent instrument)
- Study on Expansion Process of EDM Arc Plasma
- Observation of Temporal Changes of Arc Plasma in EDM(Electrical machining)
- Simulation of Wear of Tool Electrode with Sharp Edges in EDM(Electrical machining)
- Temperature Distribution Measurement in EDM Arc Plasma Using Spectroscopy
- Analysis of electromagnetic force in wire-EDM
- Simulation of Wire EDM under Rough Cutting Conditions(Electrical machining)
- Study on Self-excited Vibration of Wire Electrode in Wire-EDM
- Analysis of Electromagnetic Force in Rough Cutting of Wire-EDM
- Study on thermal equilibrium in EDM arc plasma by spectroscopic analysis
- Generating complicated surface with electrolyte jet machining
- Electrolyte Jet Machining Using Multiple Nozzles
- Effects of support method and mechanical property of 300mm silicon wafer on sori measurement
- Clarifying EDM Gap Phenomena by Gas Chromatography Analysis of Bubbles
- Analysis of Electromagnetic Force in Rough Cutting of Wire-EDM
- Time Variation and Mechanism of Determining Power Distribution in Electrodes during EDM Process
- Study on Dry WEDMed Surface Layer of Cold Tool Steel SKD11
- Reaction Forces Observed in Pulse Discharges of EDM
- Simulation of Die-Sinking EDM by Discharge Location Searching Algorithm
- Factors Determining Discharge Location in EDM
- Challenges in EDM Technology
- Study on the Distribution of Scattered Debris Generated by a Single Pulse Discharge in EDM Process
- Fabrication of Tungsten Carbide Alloy Micro-pin with Environment-Responsive ECM Using Ultra-low Concentration Electrolyte
- Reduction of Tool Wear in Non-contact Electrostatic Induction Feeding EDM
- Study on Debris Movement in EDM Gap
- Clarification of EDM Phenomena by Spectroscopic Analysis
- Electrolysis Free Micro EDM in Water Using Electrostatic Induction Feeding Method
- Investigation of Machining Characteristics of Micro-EDM with Ultrasonically Vibrated Machining Fluid under Ultra-small Discharge Energy