Effects of Wall Clearance of a Vertical Channel on Natural Air Cooling Capability
スポンサーリンク
概要
- 論文の詳細を見る
The cooling capability in compact electronic equipment of natural convective flow fields was investigated. A relationship between air passage width in the channel and natural cooling capability was obtained. Temperature and velocity measurements were carried out using a channel model of electronic equipment comprising a vertical duct with a rectangular cross-section. The channel model comprised two copper walls and two transparent acrylic walls. The clearance between the copper walls was used as a parameter in the channel model. Velocity profiles of natural cooling flow in the channel were quantitatively measured using particle image velocimetry (PIV). The temperature and velocity results demonstrated that changes in the velocity profiles closely depend on the wall clearances. Our studies indicate that a clearance of 8 to 10 mm is optimal for natural cooling in a channel of this type with the 56 mm channel depth.
著者
-
ISHIZUKA Masaru
Department of Mechanical Systems Engineering, Faculty of Engineering, Toyama Prefectural University
-
NISHINO Yasushi
Department of Mechanical Systems Engineering, Toyama Prefectural University
-
NAKAGAWA Shinji
Department of Mechanical Systems Engineering, Toyama Prefectural University
-
HATAKEYAMA Tomoyuki
Department of Mechanical Systems Engineering, Toyama Prefectural University
-
Ishizuka Masaru
Department Of Mechanical System Engineering Toyama Prefectural University
-
Nakagawa Shinji
Department Of Mechanical Engineering Doshisha University
-
HATAKEYAMA Tomoyuki
Department of Mechanical and Control Engineering, Tokyo Institute of Technology
関連論文
- Effects of Wall Clearance of a Vertical Channel on Natural Air Cooling Capability
- Effect of Shape Parameters on Flow Resistance of Perforated Plates and the Flow Resistance Characteristic for Design of Natural Air Cooled Electronic Equipment
- Numerical Simulation of a Sessile Bubble beneath a Horizontal Solid Wall in Liquid : Surfaces, Interfaces, and Films
- An Improved CIP-CUP Method for Submerged Water Jet Flow Simulation
- Thermal Modeling with Transfer Function for the Transient Chip-On-Substrate Problem
- Heat Transfer Characteristics in a Channel Flow with a Rectangular Cylinder
- TED-AJ03-106 HIGH HEAT FLUX COOLING FOR ELECTRONIC DEVICES BY SUBCOOLED FLOW BOILING WITH MICROBUBBLE EMISSION
- Development of Micro Channel Heat Exchanging
- Thermal Modeling and Experimental Verification of High-Frequency Inductors
- B15-012 APPLICATION OF THERMAL FLOW SIMULATION TO SWITCH MODE POWER SUPPLY DESIGN
- Noninvasive In-vivo Measurements of Microvessels by Reflection-Type Micro Multipoint Laser Doppler Velocimeter
- Electro-Thermal Analysis of Submicron Si MOSFET with Zoned Mesh Based on Semiconductor Physics Theory