Effect of Shape Parameters on Flow Resistance of Perforated Plates and the Flow Resistance Characteristic for Design of Natural Air Cooled Electronic Equipment
スポンサーリンク
概要
- 論文の詳細を見る
This paper describes the effect of the shape parameters on the flow resistance of a perforated plate used as a vent plate or cover for electronic equipment. In this study, we focused on the effect of hole shape and presence or absence of holes near the outer edge as the shape parameters of a perforated plate. The study is about electronic equipment designed to be air-cooled by natural convection. To demonstrate the effect of hole shape as a usable parameter for design engineers, the design of experiment (DoE) method was used to design the experimental samples of perforated plate. The effect of the outer edge was evaluated by comparing the flow resistance of perforated plates with and without holes on the outer edge. In addition, the flow resistance data obtained in this study was arranged as an empirical formula.
著者
-
ISHIZUKA Masaru
Department of Mechanical Systems Engineering, Faculty of Engineering, Toyama Prefectural University
-
NAKAGAWA Shinji
Department of Mechanical Systems Engineering, Toyama Prefectural University
-
KOIZUMI Katsuhiro
Department of Design Engineering, Cosel Co., Ltd.
-
WATANABE Kazumitsu
Department of Mechanical Systems Engineering, Toyama Prefectural University
関連論文
- Effects of Wall Clearance of a Vertical Channel on Natural Air Cooling Capability
- Effect of Shape Parameters on Flow Resistance of Perforated Plates and the Flow Resistance Characteristic for Design of Natural Air Cooled Electronic Equipment
- Numerical Simulation of a Sessile Bubble beneath a Horizontal Solid Wall in Liquid : Surfaces, Interfaces, and Films
- An Improved CIP-CUP Method for Submerged Water Jet Flow Simulation
- Thermal Modeling with Transfer Function for the Transient Chip-On-Substrate Problem
- Heat Transfer Characteristics in a Channel Flow with a Rectangular Cylinder
- TED-AJ03-106 HIGH HEAT FLUX COOLING FOR ELECTRONIC DEVICES BY SUBCOOLED FLOW BOILING WITH MICROBUBBLE EMISSION
- Thermal Modeling and Experimental Verification of High-Frequency Inductors
- B15-012 APPLICATION OF THERMAL FLOW SIMULATION TO SWITCH MODE POWER SUPPLY DESIGN