Effect of Sintering on the Marginal and Internal Fit of CAD/CAM-fabricated Zirconia Frameworks

概要

論文の詳細を見る
The aim of this study was to investigate the effect of post-machining sintering on marginal and internal fit of CAD/CAM-fabricated zirconia frameworks. Single crown copings (A: abutment), three-unit bridge frameworks (APA, P: pontic), four-unit bridge frameworks (APPA), and five-unit bridge frameworks (A_1P_1A_2P_2A_3) were fabricated with raw-stage zirconia blanks using a commercial CAD/CAM system (KATANA[○!R], Noritake Dental Supply Co. Ltd., Aichi, Japan). Crown copings and frameworks were cemented to their respective master abutment models, and thickness of the cement layer was measured at specific measuring points. Marginal and internal fit of both APA and APPA were within clinical acceptance. However, the marginal gap and thickness of the cement layer on the axial surface of the pontic side of APA and APPA were slightly higher than those of the non-pontic side. As for the marginal gap of A_1P_1A_2P_2A_3 framework, it was superior to those of APA and APPA because the center abutment supported the framework to prevent distortion.
日本歯科理工学会の論文