Shear Bond Strength of Tooth-colored Indirect Restorations Bonded to Mid-coronal and Cervical Dentin

スポンサーリンク

概要

• 論文の詳細を見る

• To investigate the bonding of tooth-colored indirect restorations to cervical dentin, shear bond strengths of bonded resin inlays to cervical dentin and mid-coronal dentin were investigated and compared. Indirectly fabricated composite inlays (Estenia) were cemented with a dual-cured resin cement (Panavia Fluoro Cement II) to either cervical or mid-coronal dentin. Resin cement was cured with or without light irradiation for 20 seconds. After 24-hour or one-week storage, the bonded inlays were subjected to a micro-shear bond test. The light-cure method showed significantly higher bond strengths to both dentin regions compared with the self-cure method. Further, significant improvement in bonding after one-week storage was found in the case of light-cure method rather than the self-cure method. Although the cervical dentin tended to show lower bond strength than mid-coronal dentin, significant difference between the two dentin regions was only found when the resin cement was light-cured and stored for only one day.

• 日本歯科理工学会の論文

著者

• SADR Alireza

  Cariology and Operative Dentistry, Graduate School of Medical and Dental Sciences, Tokyo Medical and

• TAGAMI Junji

  Cariology and Operative Dentistry, Graduate School of Medical and Dental Sciences, Tokyo Medical and

• Sadr Alireza

  Cariology And Operative Dentistry Graduate School Of Medical And Dental Sciences Tokyo Medical And D

• Sadr Alireza

  Cariology And Operative Dentistry Department Of Restorative Sciences Graduate School Tokyo Medical A

• Sadr Alireza

  Global Center Of Excellence Program Tokyo Medical And Dental University

• Tagami Junji

  Cariology And Operative Dentistry Department Of Restorative Sciences Graduate School Tokyo Medical A

• Tagami Junji

  Cariology And Operative Dentistry Tokyo Medical And Dental University

• Tagami Junji

  Cariology & Operative Dentistry Department Of Restorative Dentistry Tokyo Medical And Dental Uni

• Tagami Junji

  Cariology And Operative Dentistry Department Of Restorative Sciences Graduate School Tokyo Medical A

• SHIMADA Yasushi

  Cariology and Operative Dentistry, Department of Restorative Sciences, Graduate School, Tokyo Medica

• Shimada Yasushi

  Cariology And Operative Dentistry Department Of Restorative Sciences Graduate School Tokyo Medical A

• Shimada Yasushi

  Cariology And Operative Dentistry Graduate School Tokyo Medical And Dental University

• SATTABANASUK Vanthana

  Cariology and Operative Dentistry, Department of Restorative Sciences, Graduate School, Tokyo Medica

• YUAN Yang

  Cariology and Operative Dentistry, Department of Restorative Sciences, Graduate School, Tokyo Medica

• HE Zhengdi

  Cariology and Operative Dentistry, Department of Restorative Sciences, Graduate School, Tokyo Medica

• He Zhengdi

  Cariology And Operative Dentistry Department Of Restorative Sciences Graduate School Tokyo Medical A

• Tagami Junji

  Cariology And Operative Dentistry Department Of Restorative Science Tokyo Medical And Dental Univers

• Tagami Junji

  Cariology And Operative Dentistry Department Of Restorative Sciences Tokyo Medical And Dental Univer

• Shinoda Yuko

  Cariology And Operative Dentistry Department Of Restorative Sciences Graduate School Of Medical And

• Sattabanasuk Vanthana

  Cariology And Operative Dentistry Department Of Restorative Sciences Graduate School Tokyo Medical A

• Tagami Junji

  Cariology And Operative Dentistry Department Of Restorative Sciences Graduate School Tokyo Medical A

• Yuan Yang

  Cariology And Operative Dentistry Department Of Restorative Sciences Graduate School Tokyo Medical A

• Tagami Junji

  Cariology And Operative Dentistry Department Of Restorative Sciences Graduate School Tokyo Medical A

• Shimada Yasushi

  Cariology And Operative Dentistry Department Of Restorative Sciences Graduate School Of Medical And

• Sadr Alireza

  Cariology And Operative Dentistry Department Of Restorative Sciences Graduate School Of Medical And Dental Sciences Tokyo Medical And Dental University

関連論文

• Dentin bond durability and water sorption/solubility of one-step self-etch adhesives
• Relationship between fluorescence loss of QLF and depth of demineralization in an enamel erosion model
• Influence of filling technique and curing mode on the bond strengths of composite cores to pulpal floor dentin
• Effect of filler content of flowable composites on resin-cavity interface
• Influence of abrasive particle size on surface properties of flowable composites
• Effect of hybridization on bond strength and adhesive interface after acid-base challenge using 4-META/MMA-TBB resin
• Effects of coating root dentin surfaces with adhesive materials
• Microtensile Bond Strengths of Composite Cores to Pulpal Floor Dentin with Resin Coating
• Microtensile bond strengths of a dual-cure resin cement to dentin resin-coated with an all-in-one adhesive system using two curing modes
• The effect of the elastic modulus of low-viscosity resins on the microleakage of Class V resin composite restorations under occlusal loading
• Inhibition of Biofilm Formation using Newly Developed Coating Materials with Self-cleaning Properties
• Effect of Surface Characteristics on Adherence of S. mutans Biofilms to Indirect Resin Composites
• Surface Properties of Resin Composite Materials Relative to Biofilm Formation
• Effect of Resin Coating on Dentin Bonding of Resin Cement in Class II Cavities
• Dentin bond durability and water sorption/solubility of one-step self-etch adhesives
• Thin resin coating by dual-application of all-in-one adhesives improves dentin bond strength of resin cements for indirect restorations
• Influence of filling technique and curing mode on the bond strengths of composite cores to pulpal floor dentin
• Effect of PMMA filler particles addition on the physical properties of resin composite
• The acid-base resistant zone in three dentin bonding systems
• Evaluation of dentin bonding performance and acid-base resistance of the interface of two-step self-etching adhesive systems
• Effect of an internal coating technique on tensile bond strengths of resin cements to zirconia ceramics
• Effect of Pulse Duration of Er: YAG Laser on Dentin Ablation
• Dentin Bond Strengths of Three Adhesive/Composite Core Systems using Different Curing Units
• Effect of Light Irradiation Time on the Mechanical Properties of Two Flowable Composites with Different Initiation Systems in Bonded and Unbonded Cavities
• Enhancement of Adhesion between Resin Coating Materials and Resin Cements
• Enamel Bonding of Self-etch and Phosphoric Acid-etch Orthodontic Adhesive Systems
• Effect of Curing Method and Storage Condition on Fluoride Ion Release from a Fluoride-releasing Resin Cement
• Effect of Curing Method of a Dual-cure Resin Cement on Monkey Pulpal Reaction after Bonding of Tooth-colored Inlay
• Relationship between perception of difficulty and clinical experience of approximal composite restorations in final-year undergraduate students at Tokyo Medical and Dental University
• Analysis of Er:YAG Lased Dentin Using Attenuated Total Reflectance Fourier Transform Infrared and X-ray Diffraction Techniques
• Tensile Bond Strength of a Newly Developed One-bottle Self-etching Resin Bonding System to Various Dental Substrates
• Effects of One-year Storage in Water on Bond Strength of Self-etching Adhesives to Enamel and Dentin
• Shear Bond Strength of Tooth-colored Indirect Restorations Bonded to Mid-coronal and Cervical Dentin
• Effect of Pretreatment on Bonding of Resin Cements to Zirconia
• The effect of air-powder polishing on dentin adhesion of a self-etching primer bonding system
• Coronal Leakage Inhibition in Endodontically Treated Teeth Using Resin-coating Technique
• Shear Bond Strengths of Indirect Resin Composites to Hybrid Ceramic
• Influence of Curing Method and Storage Condition on Microhardness of Dual-cure Resin Cements
• Effect of various grit burs on marginal integrity of resin composite restorations
• Effects of light sources and visible light-activated titanium dioxide photocatalyst on bleaching
• Oral health status in relation to stimulated saliva buffering capacity among Japanese adults above or below 35 years of age
• Role of oral streptococci in the pH-dependent carious dentin
• In Vitro pH Analysis of Active and Arrested Dentinal Caries in Extracted Human Teeth Using a Micro pH Sensor
• Microtensile Bond Strength of Dual-cure Resin Cement to Root Canal Dentin with Different Curing Strategies
• Effects of photocuring strategy on bonding of dual-cure one-step self-etch adhesive to root canal dentin
• Regional Bond Strength of Four Self-etching Primer/Adhesive Systems to Root Canal Dentin
• Influence of Elasticity on Gap Formation in a Lining Technique with Flowable Composite
• Effect of Incremental Filling Technique on Adhesion of Light-cured Resin Composite to Cavity Floor
• Effect of Resin Coating on Adhesion of Composite Crown Restoration
• Hardness and Young's Modulus of Transparent Dentin Associated with Aging and Carious Disease
• Effect of Air-powder Polishing on Dentin Adhesion of a Self-etching Primer Bonding System
• Surface Analysis of Dentinal Caries in Primary Teeth using a pH-imaging Microscope
• Effect of composite post placement on bonding to root canal dentin using 1-step self-etch dual-cure adhesive with chemical activation mode
• Ultrastructural observation of the acid-base resistant zone of all-in-one adhesives using three different acid-base challenges
• Effects of water-storage on the physical and ultramorphological features of adhesives and primer/adhesive mixtures
• Effects of Enterococcus faecium on Streptococcus mutans Biofilm Formation Using Flow Cell System
• Human Papillomavirus in Oral Cancer from Sri Lanka : Prevalence and relationship with clinico-pathological parameters
• Retrospective Study of Five-year Clinical Performance of Direct Composite Restorations Using a Self-etching Primer Adhesive System
• The Effect of Thermal Stress on Bonding Durability of Resin Composite Adaptation to the Cavity Wall
• The Effect of Bonding System and Composite Type on Adaptation of Different C-factor Restorations
• Micro-shear Bond Strength of Two All-in-one Adhesive Systems to Unground Fluorosed Enamel
• Evaluation of Antibacterial and Fluoride-releasing Adhesive System on Dentin : Microtensile Bond Strength and Acid-base Challenge
• Microhardness and Young's Modulus of a Bonding Resin Cured with Different Curing Units
• Effect of Fluoride in Phosphate Buffer Solution on Bonding to Artificially Carious Enamel
• Pulpal Response to a Hybrid Composite Resin Inlay Bonded with a Newly Developed Resin-modified Glass Ionomer Luting Cement
• Reduced Irradiation Time in Slow-curing of Resin Composite Using an Intensity-changeable Light Source
• Effects of Smear Layer and Surface Moisture on Dentin Bond Strength of a Waterless All-in-one Adhesive
• Bonding of Resin to Carious-liked Demineralized Dentin
• The Effects on Puip Tissue of Microleakage in Resin Composite Restorations
• New strategy to create "Super Dentin" using adhesive technology : Reinforcement of adhesive-dentin interface and protection of tooth structures
• Studies on the Management of Patients with Xerostomia : Clinical Classification and the Caries Susceptibility of Patients with Xerostomia
• Effect of curing depth of composites on four curing light sources.
• In vivo Dentin Caries Model using Rat Molars
• The influence of light intensities irradiated directly and indirectly through resin composite to self-etch adhesives on dentin bonding
• Roughness and pH changes of enamel surface induced by soft drinks in vitro-applications of stylus profilometry, focus variation 3D scanning microscopy and micro pH sensor
• Effect of smear layer characteristics on dentin bonding durability of HEMA-free and HEMA-containing one-step self-etch adhesives
• Ten-year observation of dentin bonding durability of 4-META/MMA-TBB resin cement-a SEM and TEM study
• Non-destructive assessment of cavity wall adaptation of class V composite restoration using swept-source optical coherence tomography
• Effect of light units on tooth bleaching with visible-light activating titanium dioxide photocatalyst
• Long-term regional bond strength of three MMA-based adhesive resins in simulated vertical root fracture
• Effect of functional monomers in all-in-one adhesive systems on formation of enamel/dentin acid-base resistant zone
• Bonding to caries-affected dentin
• Influence of etching ability of one-step self-etch adhesives on bonding to sound and non-carious cervical sclerotic dentin
• Morphological categorization of acid-base resistant zones with self-etching primer adhesive systems
• 3D evaluation of composite resin restoration at practical training using swept-source optical coherence tomography SS-OCT)
• In vitro effect of hesperidin on root dentin collagen and de/re-mineralization
• Pre-etching vs. grinding in promotion of adhesion to intact enamel using self-etch adhesives
• Effect of lining with a flowable composite on internal adaptation of direct composite restorations using all-in-one adhesive systems
• Effect of air-drying dentin surfaces on dentin bond strength of a solvent-free one-step adhesive
• An approach to normalizing micro-CT depth profiles of mineral density for monitoring enamel remineralization progress
• Effect of remaining dentin thickness on bond strength of various adhesive systems to dentin
• Effect of smear layer treatment on dentin bond of self-adhesive cements
• Development and evaluation of a low-erosive apple juice drink with Phosphoryl-Oligosaccharides of Calcium
• Cariotester, a new device for assessment of dentin lesion remineralization in vitro
• Effect of fluoride concentration in adhesives on morphology of acid-base resistant zones
• Effect of a calcium-phosphate based desensitizer on dentin surface characteristics
• Mineral density, morphology and bond strength of natural versus artificial caries-affected dentin
• Casein phosphopeptide-amorphous calcium phosphate and glass ionomer show distinct effects in the remineralization of proximal artificial caries lesion in situ
• Polymerization behavior within adhesive layer of one- and two-step self-etch adhesives: A micro-Raman spectroscopic study
• Acceleration of curing of resin composite at the bottom surface using slow-start curing methods

もっと見る 閉じる

スポンサーリンク