8. The Continuous Flow Production System which has Applied to Hull Works in Shipbuilding Industry
スポンサーリンク
概要
- 論文の詳細を見る
It has been so far said that the continuous flow production system might be applied mainly to the mass production industry, while the application of this system is difficult to the one-off production industry in view of the diversity of products. Accordingly, the continuous flow production system has been adopted in the shipbuilding industry, in such limited cases as in the prefabrication stage of hull assemblies which compose parallel part of tanker and has failed to contribute to the improvement of general production system of shipbuilding industry. Through the study on the intrinsic nature of continuous flow production system, however, the authors have developed a new system of control technique so that a group of techniques fostered in the mass production can be applied to shipbuilding industry which is typical in diversified products production. This new control system has been applied to shipbuilding industry, characteristically utilizing the continuous flow production system. Accordingly ,this system can be applied in a similar manner to the other territory of diversified products production, e.g., machine industry. The promotion of this new production system in shipbuilding industry has thus marked an epoch-marking development through the introduction of electronic computers into the planning and control system of production and thereby maximum efficiency is realized in shipyard management including not only hull works but also outfitting works.
- 社団法人日本船舶海洋工学会の論文
著者
-
Terai Kiyoshi
Kawasaki Dockyard Co
-
Yamamoto Noboru
Kawasaki Heavy Industries
-
KURIOKA Tatsumi
Kawasaki Heavy Industries, Ltd., Welding Research Dept.
-
Kurioka Tatsumi
Kawasaki Heavy Industries
関連論文
- Correlation of the Implant test with the RRC and the TRC tests
- Study on Characteristics of Weld Defect and its Prevention in Electron Beam Welding (Report IV) : Relationship between Weld Defect and its Formation Phenomenon
- Merkmale Des Elektronenstrahlsschweissverfahrens MIT Wechselstromsablenkung
- Study on Characteristics of Weld Defect and its Prevention in Electron Beam Welding (Report III) : Characteristics of Cold Shut
- Study on Characteristics of Weld Defect and Its Prevention in Electron Beam Welding (Report II) : Some Metallurgical Features of Weld Porosities
- Study on Characteristics of Weld Defect and Its Prevention in Electron Beam Welding (Report I) : Characteristics of Weld Porosities
- 6. Some Characteristics of the Fracture Stress Curve in Steel
- A Proposal Concerning the Automatic Submerged Welding Procedures of Assemblies for Ship's Hull
- Observation about the Application of Arc-Air Gouging Process in Shipyard
- 5. One side Automatic Welding Applied in Japanese Shipyards
- Prevention of End Cracking in One-Side Automatic Welding
- Welding and Fabrication of New High Tensile Steels for Submarine in Japan
- Economic Aspects of Automation of Welding in Shipbuilding
- One Side Automatic Welding of Curved Panel of Ship's Hull
- 8. The Continuous Flow Production System which has Applied to Hull Works in Shipbuilding Industry
- Effect of Peritectic Reaction on the Toughness of As-Solidified Steel
- A Transient Elastic-Plastic Thermal Stress Analysis of Flame Forming
- Development of One-Run One-Side Automatic Welding Process
- 9. Prevention of End Cracking in One-Side Automatic Welding : Numerical Analysis of Transient Phenomena in Welding
- Effects of Process Parameter on the Penetration Depth in High Voltage Electron Beam Welding
- The Forecasting of Welding Processes in Future by the Delphi Method
- 8. Computer System in a Shipyard Production Management