Experimental Investigation of Noise Immunity Diagnosis for Battery Drived Circuit by Bulk Current Injection Test(Special Issue on Recent Progress in in Electromagnetic Compatibility Technology)
スポンサーリンク
概要
- 論文の詳細を見る
A simple method for diagnosing noise immunity of printed circuit boards(PCBs) by the bulk current injection(BCI)test was proposed, which can contribute to the PCB trace designs for common-mode noise.A grading index, which is defined as the ratio of the stray capacitances with and without critical IC of malfunction, was introduced to distinguish the PCB susceptible to the common-mode noise.This proposed method was validated experimentally using four PCBs with the same circuit but different trace design.It was observed that the noise immunity of PCBs had a good correlation with the values of these grading indices.
- 社団法人電子情報通信学会の論文
- 2000-03-25
著者
-
YOSHIDA Kunio
Department of Mechanical Sciences and Engineering, Tokyo Institute of Technology
-
Yoshida Kunio
Department Of Electronics Information And Communication Engineering Osaka Institute Of Technology
-
Yoshida K
Renesas Technol. Corp. Itami‐shi Jpn
-
Yoshida K
Osaka Institute Of Technology
-
Fujiwara Osamu
The Department Of Computer Science And Engineering Graduate School Of Engineering Nagoya Institute O
-
Fujiwara O
Nagoya Inst. Of Technol. Nagoya Jpn
-
Konishi Yusuke
Division Of Electric Electronic And Information Engineering Graduate School Of Engineering Osaka Uni
-
Fujiwara Osamu
The Department Of Electrical And Computer Engineering Nagoya Institute Of Technology
-
Sasabe K
Matsushita Electric Works Ltd. Osaka‐shi Jpn
-
Fujiwara Osamu
The Department Of Electrical And Computer Engineering Of Nagoya Institute Of Technology
-
Fujiwara Osamu
The Faculty Of Engineering Nagoya Institute Of Technology
-
SASABE Kohji
the Corporate Quality R&D Center of Matsushita Electric Works, Ltd.
-
YOSHIDA Kazuhisa
the Corporate Quality R&D Center of Matsushita Electric Works, Ltd.
-
Yoshida Kazuhisa
The Corporate Quality R&d Center Of Matsushita Electric Works Ltd.
-
Sasabe Koji
the Corporate Quality R&D Center of Matsushita Electric Works, Ltd.
関連論文
- Laser original: Power analysis of a cw solar-pumped laser for magnesium energy cycle (「太陽光励起レーザーとその応用」特集号)
- Effect of Crystal Defects on Laser-Induced-Damage Tolerance of Organic Crystal, 4-Dimethylamino-N-methyl-4-stilbazolium Tosylate
- Removal of Diazonaphthoquinone/Novolak Resist Using UV Laser (266nm)
- Electrical Conductivity of Polymer Composites Filled with Metal
- Characterization of Two-Photon Absorption Related to the Enhanced Bulk Damage Resistance in CsLiB_6O_ Crystal
- Electrical Conductivity of Polymer Composites Filled with Carbon Black
- Removal of Positive-tone Diazonaphthoquinone/Novolak Resist Using UV Laser lrradiation
- Laser-Induced Bulk Damage of Various Types of Silica Glasses at 266nm
- Growth of Large GaN Single Crystals on High-Quality GaN Seed by Carbon-Added Na Flux Method
- 共蒸着保護層を用いたカラープラズマディスプレイの発光特性の改善とエージング特性
- Improvement of Luminous Efficiency in Barrier-Electrode Color ac Plasma Displays by Using a Double Protecting Layer
- Substrate Dependence of Laser-Induced Damage Threshold of Scandium Oxide High-Reflector Coatings for UV Pulsed Laser
- Influence of Deposition Parameters on Laser Damage Threshold of 355-nm Scandium Oxide-Magnesium Fluoride High-Reflector Coatings
- Improvement in Laser-Induced Damage Threshold of Antireflection Coatings for High-Power UV Lasers by Removing Subsurface of Large lenses
- Effect of RF Plasma Etching on Surface Damage in CsLiB_6O_ Crystal
- Enhancement of Surface-Damage Resistance by Removing Subsurface Damage in Fused Silica and Its Dependence on Wavelength
- Laser-Induced Bulk Damage of Various Types of Silica Glasses at 532 and 355nm
- Ion Etching of Fused Silica Glasses for High-Power Lasers
- Laser-Induced Bulk Damage of Various Types of Silica Glasses with Fundamental and Higher Harmonics of Nd : YAG Laser
- Bubble Characteristics in Multi-Phase Flow Systems: Bubble Sizes and Size Distributions
- Proposal and Demonstration of Laser-Driven Micro-Airplane
- 90°Phase-Matching Properties of YCa_4O(BO_3)_3 and Gd_x Y_Ca_4O(BO_3)_3
- Observation of Intrinsic Josephson Junction Propertieson (Bi,Pb)SrCaCu0 Thin Films
- Uncertainty of the One-Gram Averaged Spatial Peak SAR in Human Head for Portable Telephones due to Average Procedures
- Localized Specific Absorption Rate in the Human Head in Metal-Framed Spectacles for 1.5 GHz hand-Held Mobile Telephones
- Multi-Grid FDTD Calculation of Electromagnetic Absorption in the Human Head for 5 GHz Band Portable Terminals
- Layer Thickness Error Dependence of the Laser-Induced Damage Threshold of Multilayer Mirrors for High-Power Lasers
- Compact Coating Machine for Large Laser Optics with a New Thickness-Distribution Equalization Method
- Analysis of Transient Electromagnetic Fields Radiated by Electrostatic Discharges
- A Low-Power Microcontroller with Body-Tied SOI Technology(Low-Power System LSI, IP and Related Technologies)
- Effect of Overcoat Layer on Highly Reflective Coating for High-Average-Power Lasers
- Development of Newly Designed Polarizer for High-Power Laser
- Design and Performance of High T_c Superconducting Coplanar Waveguide Matching Circuit for RF-CMOS LNA(Special Issue on Superconductor Digital/Analog Circuit Technologies)
- Design and Performance of Miniaturized HTS Coplanar Waveguide Bandpass Filters with Highly Packed Meanderlines(Special Issue on Superconductive Electronics)
- Micromagnetic Simulation of Recording Media and Magnetoresistive Heads
- Macroscopic Flow Structure of Solid Particles in Circulating Liquid-Solid Fluidized Bed Riser
- FDTD Simulation of Shielding Effectiveness of Metal-Coated Plastics for Pulsed Electromagnetic Fields(Electromagnetic Compatibility(EMC))
- Special Issue on Measurements and Control of Electromagnetic interference
- Realizing Highly Localized Exposure in Small Animals with Absorbing Material Covered Holder to Test Biological Effects of 1.5 GHz Cellular Telephones (Electromagnetic Compatibility (EMC))
- Ion Temperature of Laser-Produced Plasma
- Properties of Plasma Produced by High Power Laser
- Generation and Amplification of Laser Pulse with a Variable Pulsewidth Using PTM Method
- A Simple Method for Predicting Common-Mode Radiation from a Cable Attached to a Conducting Enclosure
- A Novel Setup for Small Animal Exposure to Near Fields to Test Biological Effects of Cellular Telephones
- An Analytical Approach to Model Indirect Effect Caused by Electrostatic Discharge (Special Issue on Discharge and Electromagnetic Interference)
- Modeling of High-T_c Superconducting Transmission Lines with Anisotropic Complex Conductivity(Special Issue on Superconductive Devices and Systems)
- 86. Pathophysiological Studies on the Tenesmus(1st report)
- FDTD Analysis of Dosimetry in Human Head Model for a Helical Antenna Portable Telephone(Special Issue on Recent Progress in Electromagnetic Compatibility Technology)
- Experimental Investigation of Noise Immunity Diagnosis for Battery Drived Circuit by Bulk Current Injection Test(Special Issue on Recent Progress in in Electromagnetic Compatibility Technology)
- Head Tissue Heterogeneity Required in Compurtational Dosimetry for Portable Telephones
- Computation of Potential Attenuation Process for Charged Human Body Using Numerical Inverse Laplace Transform
- Approximation of Surface-SAR in a Realistic Head Model for Microwave Exposure Using External Magnetic Near-Field
- Usefulness of Spherical Model of Human Head in SAR Calculation for UHF Plane-Wave Exposure
- Correlation between Spatial Distributions of Surface-SAR and Magnetic Near-Field in Realistic Head Model for Microwave Exposure (Special Section of Letters Selected from the '92 Fall Conference and the '93 Spring Conference)
- Reduction of Electromagnetic Absorption in the Human Head for Portable Telephones by a Ferrite Sheet Attachment
- Computation of SAR Inside Eyeball for 1.5-GHz Microwave Exposure Using Finite-Difference Time-Domain Technique (Special Issue on Biological Effects of Electromagnetic Fields)
- New Approaches for Measurement of Static Electricity toward Preventing ESD
- Growth of Prismatic GaN Single Crystals with High Transparency on Small GaN Seed Crystals by Ca-Li-Added Na Flux Method