Temperature Compensated Piezoresistor Fabricated by High Energy Ion Implantation
スポンサーリンク
概要
- 論文の詳細を見る
We developed piezoresistors with an intrinsic compensation of the offset temperature characteristics. High energy ion implantation was applied to fabricate this type of piezoresistor [1]. The dopant profile of the buried piezoresistor resembles to that of the junction gate field effect transistor (JFET). The buried layer corresponds to a channel of JFET, and the substrate bias corresponds to the gate voltage. Owing to the independent temperature varying parameters, i.e., width of the depletion layer and carrier mobility in the channel, the drain current of the JFET has a temperature independent point at an appropriate gate source voltage. The effect was used in the new type of buried piezoresistor which has a driving point of zero temperature coefficient of resistance at an appropriate gate source voltage.
- 社団法人電子情報通信学会の論文
- 1995-02-25
著者
-
ESASHI Masayoshi
Faculty of Engineering, Tohoku University
-
Shoji Shuichi
School of Fundamental Science and Engineering, Waseda University
-
Shoji Shuichi
School Of Fundamental Science And Engineering Waseda University
-
Minami K
Osaka Univ. Suita‐shi Jpn
-
Shoji S
Jst‐presto
-
Nishimoto Takahiro
Keihanna Research Laboratory, Shimadzu Corporation
-
Minami Kazuyuki
Faculty of Engineering, Tohoku University
-
Esashi Masayoshi
Faculty Of Engineering Tohoku University
-
Nishimoto Takahiro
Keihanna Research Laboratory Shimadzu Corporation
-
Shoji Shuichi
School of Advanced Science and Engineering, Waseda University, Shinjuku, Tokyo 169-8555, Japan
関連論文
- High Frequency Responses of YBa_2Cu_3O_ Josephson Junctions on Si Substrates Fabricated by Focused Electron Beam Irradiation
- Au-electrode-embedded cyclo-olefin polymer microchip using low-temperature direct bonding (特集 マイクロ加工および支援技術)
- Fabrication of a microchannel device by hot embossing and direct bonding of poly (methyl methacrylate)
- Au-Electrode-Embedded Cyclo-Olefin Polymer Microchip Using Low-Temperature Direct Bonding
- Low-temperature Direct Bonding of Poly(methyl methacrylate) for Polymer Microchips
- Temperature Compensated Piezoresistor Fabricated by High Energy Ion Implantation
- Simplified 20-μm Pitch Vertical Interconnection Process for 3D Chip Stacking
- Fabrication of Metallic Nanopatterns Using the Vacuum Type UV-NIL Equipment
- High-Speed Label Search Methods Considering QoS Requirements for MPLS Network
- Design of Buffer Controller for Flow-Based High Quality Communications
- Buffer Control Scheme Considering Service Class of Flows (Special Issue on Internet Technology II)
- Packet Discarding Scheme Considering Both Instantaneous and Historical Use of Network Resources (Special Issue on Internet Technology)
- Development of an Anti-Corrosive Integrated Mass Flow Controller
- An Experimental Study on Relative Displacement Sensing Using Phototransistor Array for Building Structures
- Seamless Pattern Fabrication of Large-Area Nanostructures Using Ultraviolet Nanoimprint Lithography
- Development of Lateral Displacement Sensor for Real-Time Detection of Structural Damage
- Micro Systems by Bulk Silicon Micromachining
- Fabrication of Reactive Ion Etching Systems for Deep Silicon Machining (特集:マイクロマシン加工技術)