火山の構造および噴火と地震の関係

概要

論文の詳細を見る
Volcanoes are generally classified into monogenetic and polygenetic types. Monogenetic volcanoes erupt only once to form smaller volcanoes, such as maars, pyroclastic cones and lava domes. Polygenetic volcanoes erupt repeatedly from the same general vents (summit or main crater) for up to 10^5 years to form larger volcanoes such as strato-volcanoes (composite volcanoes of Macdonald, 1972) and shield volcanoes of Hawaiian type. Monogenetic volcanoes tend to occur in clusters as flank and post-caldera cones. Some of the clusters are however, independent of polygenetic volcanoes and appear to be equivalent to them. The essential part of the conduit of a monogenetic volcano is inferred to be a simple dike, intruded into a newly formed crack, whereas a long endured pipe-shaped conduit may exist under a polygenetic volcano. The common occurrence of xenoliths in the eruptive products of monogenetic volcanoes may be related to this difference. Various lines of evidence, indicating the existence, depth, shape, volume and internal structure, of magma reservoirs are tabulated. A shallow magma reservoir appears to exist beneath polygenetic volcanoes with one to one correspondence, which is not the case for monogenetic volcanoes. Most flank volcanoes are monogenetic, thus indicating dikes within the polygenetic volcanic edifice. Dike formation is understood as a magma version of hydraulic fracturing. For the dike to intrude and propagate, would require either the increase of differential stress due to a decrease of minimum compression or increase of pore pressure over the sum of the minimum compression and the tensile strength of the rocks. Earthquakes are understood as the generation of elastic waves associated with an acute release of tectonic stress due to faulting. Accumulation of tectonic stress and strain prior to earthquakes is, then, a necessary part of earthquake phenomena in a broad sense, as well as their release after the event. Based on the above-stated understanding, possible mechanical correlations between volcanic eruptions and earthquake occurrences have been studied. Contractional strain around the magma reservoir can cause the squeezing up of magma within an open conduit causing a summit eruption on the one hand, and dike formation resulting in a flank eruption through the increase of pore pressure, on the other. Second boiling triggered by both the magmatic pressure decrease caused by dilatational strain and the dynamic excitation due to seismic waves might have the same effect as contraction. Decrease of minimum compression causing the increase of differential stress leading to dike formation will also contribute to the liklihood of flank eruptions. Both volcanic eruptions and earthquake occurrences can precede each other depending on geographical location in terms of faulting-related stress-strain changes which are calculated by the fault model of earthquakes. Actual possible examples of volcanic eruptions and earthquakes which are allegedly mechanically related are given. In order to demonstrate which mechanism is responsible for the correlation of the two phenomena, continuous strain measurement on and around volcanoes is necessary together with the observation of changes in the level of magma in crater bottoms.
1975-12-25

著者

中村一明
東京大学地震研究所

火山の構造および噴火と地震の関係

スポンサーリンク

概要

著者

関連論文

スポンサーリンク