A Study on the Dynamic Characteristics of Pump Seal : 1st Report, In case of Annular Seal with Eccentricity
スポンサーリンク
概要
- 論文の詳細を見る
The dynamic characteristics of the annular pressure seal employed in pumps have been theoretically deduced with consideration for the effect of eccentricity of rotor. Turbulent flow is assumed in both circumferential and axial directions, and effect of inertia of the fluid is considered. An equation for the pressure increment due to journal translation is derived in terms of the effective viscosities, based on the rotational and axial flow Reynolds numbers. Comparisons are made between the stiffness, damping and add mass coefficients derived herein and the previousely published theoretical and experimental results without eccentricity. It is shown that the numerically obtained value is in reasonable agreement with experiment.
- 一般社団法人日本機械学会の論文
著者
-
Yang Bo
Graduate School Of Science And Technology Kobe University
-
IWATSUBO Takuzo
Faculty of Engineering, Kobe University
-
KAWAI Ryoji
Faculty of Engineering, Kobe University
-
Iwatsubo Takuzo
Faculty Of Engineering Kobe University
-
Kawai Ryoji
Faculty Of Engineering Kobe University
関連論文
- Condition Monitoring and Diagnosis System of Rotating Machinery
- Analysis of Transient Sound Energy Flow in Impact Noise
- A Study on the Dynamic Characteristics of Pump Seal : 1st Report, In case of Annular Seal with Eccentricity
- Reliability Analysis of Structures under Seismic Excitation : Part III : Comparison of reliabilities obtained by first passage failure method and cumulative damage failure method
- Reliability Analysis of Structures under Seismic Excitation : Part II : Reliability by cumulative damage failure method
- Reliability Analysis of Structures under Seismic Excitation : Part I : Response ratio of structure having bi-linear spring behavior
- Suppression Phenomena of Resonant Oscillations in Strongly Nonlinear Systems due to Additional Asynchronous Excitations
- Asynchronous Stabilization Phenomena of Resonant Oscillations in Nonlinear Systems
- Obtaining a Model and Control for a Rigid Body Motion System : (Obtaining Inertia Parameters of a Rigid Body and Electromagnetic Characteristics for a Magnetic Levitation System)
- Energetic Evaluation of Stability in Rotor-bearing System : Contribution of Each Element to Logarithmic Decrement
- A Computer-Aided-Design Technique for Design of a Six-Section Elliptic Tire-Building Drum
- Rotordynamic Analysis of Submerged Motor Pumps : Influence of Long Seal on the Stability of Fluid Machinery
- Experimental Study of Dynamical Charateristics of a Long Annular Seal (In the Case of Concentric Rotor and Outer Cylinder)
- Coupled Lateral-torsional Vibration of Rotor System Trained by Gears : part 1. Analysis by Transfer Matrix Method
- Selection of Satisfactory Fundamental Solution in Boundary Value Inverse Analysis by B.E.M.
- Detection of the Point Where Rubbing Occurs in a Multisupported Rotor System
- Balancing of Flexible Rotors by Using Flexible Bearing Pedestals
- Balancing of Flexible Rotors
- Reliability Design of the Piping System against Earthquake Excitation
- The Study of Nonlinear Vibration Analysis of Rotor System Using Component Mode Synthesis Method(Analysis Using the Harmonic Balance Method)
- A Study of the Impact Noise of Machines (2nd Report, Formative Process of Sound Pressure) : Series C : Vibration, Control Engineering, Engineering for Industry
- Behavior of Impact Waves at the Interface of an Elastic-viscoelastic Bar