Detection of the Point Where Rubbing Occurs in a Multisupported Rotor System
スポンサーリンク
概要
- 論文の詳細を見る
This paper describes a new method that detects directly the point where rubbing occurs during operation using data of vibrations. This method is based on the analysis of the nonlinear vibration caused by rubbing. A particular feature of the nonlinear vibration is that the amplitude of higher harmonics in the response becomes large in the vicinity of the point where rubbing occurs. The point where rubbing occurs can, thus, be detected by investigating the distribution of the amplitude of higher harmonics included in the response along the rotor. In the case of a rotor system having an overhanging disk or excited by internal resonance, the distribution of the amplitude occasionally shows another large peak in addition to the peak at the point where rubbing occurs. Even in this case, the presented method can be used to detect the point where rubbing occurs by investigating the eigenvalues and the mode of the rotor system and taking the influence of the overhanging disk into consideration, because the influence of internal resonance on the amplitude of higher harmonics is not great and, furthermore, the influence of the overhanging disk appears only in the vicinity of the overhanging disk.
- 一般社団法人日本機械学会の論文
- 1993-09-15
著者
-
Iwatsubo Takuzo
Faculty Of Engineering Kobe University
-
Arii Shiro
Faculty Of Engineering Kobe University
-
Oks Borisovitch
Laboratory Of Machine Dynamics Riga Technical University
関連論文
- Condition Monitoring and Diagnosis System of Rotating Machinery
- Analysis of Transient Sound Energy Flow in Impact Noise
- A Study on the Dynamic Characteristics of Pump Seal : 1st Report, In case of Annular Seal with Eccentricity
- Reliability Analysis of Structures under Seismic Excitation : Part III : Comparison of reliabilities obtained by first passage failure method and cumulative damage failure method
- Reliability Analysis of Structures under Seismic Excitation : Part II : Reliability by cumulative damage failure method
- Reliability Analysis of Structures under Seismic Excitation : Part I : Response ratio of structure having bi-linear spring behavior
- Suppression Phenomena of Resonant Oscillations in Strongly Nonlinear Systems due to Additional Asynchronous Excitations
- Asynchronous Stabilization Phenomena of Resonant Oscillations in Nonlinear Systems
- Obtaining a Model and Control for a Rigid Body Motion System : (Obtaining Inertia Parameters of a Rigid Body and Electromagnetic Characteristics for a Magnetic Levitation System)
- A Computer-Aided-Design Technique for Design of a Six-Section Elliptic Tire-Building Drum
- Rotordynamic Analysis of Submerged Motor Pumps : Influence of Long Seal on the Stability of Fluid Machinery
- Experimental Study of Dynamical Charateristics of a Long Annular Seal (In the Case of Concentric Rotor and Outer Cylinder)
- Coupled Lateral-torsional Vibration of Rotor System Trained by Gears : part 1. Analysis by Transfer Matrix Method
- Selection of Satisfactory Fundamental Solution in Boundary Value Inverse Analysis by B.E.M.
- Detection of the Point Where Rubbing Occurs in a Multisupported Rotor System
- Balancing of Flexible Rotors by Using Flexible Bearing Pedestals
- Balancing of Flexible Rotors
- Reliability Design of the Piping System against Earthquake Excitation
- The Study of Nonlinear Vibration Analysis of Rotor System Using Component Mode Synthesis Method(Analysis Using the Harmonic Balance Method)