3 チャンネル法による平板の振動インテンシティ計測に関する基礎的研究

概要

論文の詳細を見る
In determining the effective ways of machine noise control, it is important to clarify the noise sources and their contributions. However, the noise sources do not always coincide with the exciting sources in a structure. Then, it is necessary to identify the exciting sources and vibration transmission paths on the plate and beam. To satisfy this requirement, vibration intensity measurement has been used. This paper describes the detection of vibration intensity vector in flat plates using three-channel method. In this method, the amplitude and direction of vibration intensity vector are obtained by processing three output signals from accelerometers set on plates. Using this method vibration intensity vectors around the exciting point on a steel plate are measured. The measuring errors in amplitude and direction are discussed. The detection limits on vibration frequency, stiffness of plate and weight of the probe are investigated. The vibration power of bending wave was calculated by integrating the vibration intensity vectors and compared with exciting power measured by an impedance head. The result shows that three-channel method can be used to detect the vibration intensity vectors in flat plates.
山口大学の論文