Compressive Deformation Behavior at Elevated Temperatures in a Closed-Cell Aluminum Foam
スポンサーリンク
概要
- 論文の詳細を見る
- 2005-07-20
著者
-
Hakamada Masataka
Materials Research Institute For Sustainable Development National Institute Of Advanced Industrial S
-
Chino Yasumasa
Materials Research Institute For Sustainable Development National Institute Of Advanced Industrial S
-
Chino Yasumasa
National Institute Of Advanced Industrial Science And Technology
-
Chino Yasumasa
Materials Res. Inst. For Sustainable Dev. National Inst. Of Advanced Industrial Sci. And Technol.
-
Mabuchi M
Department Of Energy Science And Technology Graduate School Of Energy Science Kyoto University
-
Mabuchi Mamoru
Department Of Energy Science And Technology Graduate School Of Energy Science Kyoto University
-
Hakamada Masataka
Department Of Energy Science And Technology Graduate School Of Energy Science Kyoto University
-
YAMADA Yasuo
Materials Research Institute for Sustainable Development, National Institute of Advanced Industrial
-
Chino Y
Institute For Structural And Engineering Materials National Institute Of Advanced Industrial Science
-
Mabuchi M
Department Of Energy Science And Technology Kyoto University
-
Yamada Y
Akita Univ. School Of Medicine Akita
-
Mabuchi Mamoru
Department Of Energy Science & Technology Graduate School Of Energy Science Kyoto University
-
CHEN Youqing
Department of Energy Science and Technology, Graduate School of Energy Science, Kyoto University
-
KUSUDA Hiromu
Department of Energy Science and Technology, Graduate School of Energy Science, Kyoto University
-
NOMURA Tatsuho
Department of Energy Science and Technology, Graduate School of Energy Science, Kyoto University
-
Chen Youqing
Department Of Energy Science And Technology Graduate School Of Energy Science Kyoto University
-
Kusuda Hiromu
Department Of Energy Science And Technology Graduate School Of Energy Science Kyoto University
-
Nomura Tatsuho
Department Of Energy Science And Technology Graduate School Of Energy Science Kyoto University
-
Yamada Yasuo
Institute For Structural And Engineering Materials National Institute Of Advanced Industrial Science
-
Mabuchi M
National Inst. Of Advanced Industrial Sci. And Technol. Nagoya Jpn
-
Yamada Yasuo
Materials Research Institute For Sustainable Development National Institute Of Advanced Industrial S
-
Hakamada Masataka
Dep. Of Energy Sci. And Technol. Graduate School Of Energy Sci. Kyoto Univ.
関連論文
- Texture and Mechanical Properties of Mg-3Al-1Zn-0.5Mn-1.5Ca Alloy Produced by Torsion Extrusion
- Bone formation in titanium porous scaffold with immobilization of BMP-2
- Activation of Eosinophils by Rice-Husk Dust Exposure : A Possible Mechanism for the Aggravation of Asthma during Rice Harvest
- Tension/Compression Anisotropy in Hot Forged Mg-Al-Ca-RE Alloy
- Grain Refinement and Superplasticity Induced by Hot Compression of Continuously-Casted Mg-9Al-1Zn-1Ca and Mg-9Al-1Zn Alloys
- Effects of Homogenization Annealing on Dynamic Recrystallization in Mg-Al-Ca-RE (Rare Earth) Alloy
- Tensile Properties of Forged Mg-Al-Zn-Ca Alloy
- Mechanical Properties of Mg-Al-Ca Alloy Recycled by Solid-State Recycling
- Deformation Characteristics of Recycled AZ91 Mg Alloy Containing Oxide Contaminants
- Effect of Annealing on Mechanical Properties and Nanoscale Lamellar Structure in Co-Cu Alloy
- New Step of Ecomaterial to Break through the Barrier between Ecomaterial-Selection and Eco-Design
- Barrier-Free Processing of Materials for Environmentally Benign Life-Cycle Design
- Enhancement of Stretch Formability at Room Temperature by Addition of Ca in Mg-Zn Alloy
- Preparation of Nanoporous Palladium by Dealloying : Anodic Polarization Behaviors of Pd-M (M = Fe, Co, Ni) Alloys
- Effects of Pore Characteristics Finely-Controlled by Spacer Method on Damping Capacity of Porous Aluminum
- Ferromagnetic Properties of Co-Cu Alloy with Nanoscale Lamellar Structure
- Effects of Vacancies on Deformation Behavior in Nanocrystalline Nickel
- Comparison of Mechanical Properties of Thin Copper Films Processed by Electrodeposition and Rolling
- Influence of Porosity and Pore Size on Electrical Resistivity of Porous Aluminum Produced by Spacer Method
- Fluid Conductivity of Porous Aluminum Fabricated by Powder-Metallurgical Spacer Method
- Fabrication of Porous Aluminum by Spacer Method Consisting of Spark Plasma Sintering and Sodium Chloride Dissolution
- Effect of Sintering Temperature on Compressive Properties of Porous Aluminum Produced by Spark Plasma Sintering
- Direction Dependence of Compressive Properties of Mg Processed by Directional Solidification
- Effect of Reduction Ratio of Hot-Extrusion on Microstructures of Superplastic Si_3N_4whisker/Al-Mg-Si Alloy Composites Studied by Transmission Electron Microscopy
- The Effect of Deformation Temperature on Microstructure and Superplastic Flow in Al-Cu-Mg/Si_3N_4p Composites
- Theoretical Analysis on Crystal Alignment of Feeble Magnetic Materials under High Magnetic Field
- Mechanical and Corrosion Properties of AZ31 Magnesium Alloy Repeatedly Recycled by Hot Extrusion
- Tensile Properties and Blow Forming of 5083 Aluminum Alloy Recycled by Solid-State Recycling
- Blow Forming of Mg Alloy Recycled by Solid-State Recycling
- Corrosion and Mechanical Properties of Recycled 5083 Aluminum Alloy by Solid State Recycling
- An Experimental Investigation of Effects of Specimen Size Parameters on Compressive and Tensile Properties in a Closed Cell Al Foam
- Solid Recycling of an AZ31 Mg Alloy with a Vapor Deposition Coating Layer of High Purity Mg
- Influence of Grain Size on Elongation at Elevated Temperatures in AZ31 Mg Alloy
- Mechanical Properties and Blow Forming of Rolled AZ31 Mg Alloy Sheet
- Tensile Properties of Directionally Solidified AZ91 Mg Alloy
- Tensile Properties from Room Temperature to 673K of Mg-0.9mass%Ca Alloy Containing Lamella Mg_2Ca
- Mechanical Properties and Press Formability at Room Temperature of AZ31 Mg Alloy Processed by Single Roller Drive Rolling
- Superplasticity and Cavitation of Recycled AZ31 Magnesium Alloy Fabricated by Solid Recycling Process
- The Critical Stress at the Interface for Cavity Nucleation in Superplastic Aluminum Matrix Composites Reinforced with Si_3N_4 Particles
- Tensile Properties at Room Temperature to 823K of Mg-4Y-3RE Alloy
- Solid recycling process for magnesium alloys
- Effects of Temperature and Strain Rate on Elongation at Elevated Temperature in Al-4.5Mg Alloy
- Emergency Abdominal Surgery for Small Bowel Perforation Secondary to Metastatic Lung Cancer
- Expression of Ki-67 by Monoclonal Antibody MIB-1 in Carcinoma of the Middle and Lower Bile Duct
- Compressive Deformation Behavior at Elevated Temperatures in a Closed-Cell Aluminum Foam
- Elevated Temperature Deformation and Fracture Mechanisms in High-Strain-Rate-Superplastic Si_3 N_/Al-Cu-Mg Composite
- OBSERVATION OF CAVITATION FORMATION IN A SUPERPLASTIC Si_3N_/Al-Mg-Si COMPOSITE AT HIGH STRAIN RATES
- Stress Exponent and Activation Energy in Titanium Aluminides with Different Grain Sizes
- Prostaglandin D_2 and interleukin-5 reduce CRTH2 surface expression on human eosinophils
- Texture and Stretch Formability of Mg-1.5mass%Zn-0.2mass%Ce Alloy Rolled at Different Rolling Temperatures
- Tensile Properties and Stretch Formability of Mg-1.5mass%-0.2mass%Ce Sheet Rolled at 723K
- Influence of Rolling Routes on Press Formability of a Rolled AZ31 Mg Alloy Sheet
- Surface Evolution during Focused Iron Beam Micro-Machining in (001) Plane of Single-Crystalline Ni and Amorphous Nickel Alloy
- Bending Properties of Nanocrystalline Ni-18at% W Alloy Produced by Electrodeposition
- Role of the Co Phase in Superplasticity for WC-Co Cemented Carbides
- Effects of the Density on Compressive Properties in Cellular Aluminum Produced by the Sintering Method
- Fabrication of Porous TiAl Intermetallic Compound by Self -propagating High Temperature Synthesis
- Mechanical Properties of Binder-free WC Fabricated by PCS Process
- Compressive Deformation Characteristics of Open-Cell Mg Alloys with Controlled Cell Structure
- Compression Test Simulation of Controlled Cell Shape Open Cellular Magnesium Alloy under Dynamic Loading
- The Grain Size and Texture Dependence of Tensile Properties in Extruded Mg-9Al-lZn
- Forging Characteristics of AZ31 Mg Alloy
- グリーンタフ地域の石油,ガスおよび地熱貯留岩における蛍光法による空隙と微少割れ目の観察
- Signet Ring Cell Carcinoma of the Stomach : A Clinicopathological Comparison with the Other Histological Types
- Effects of the WC Grain Size on the Surface Roughness of WC-10%Co Cemented Carbide Micro-Die Machined by FIB
- Superplasticity of a Particle-Strengthened WE43 Magnesium Alloy
- Improvement of Crashworthiness in Ultra Lightweight Metallic Foam by Heat-Treatment for Microstructural Modification of Base Material
- Effects of Heat Treatment on the Compressive Properties of AZ91 Mg Foam
- Microstructure and Tensile Properties of Rolled Mg-5.5 mass% Zn-0.6 mass% Zr Alloy
- Effects of Cell Geometry on the Compressive Properties of Nickel Foams
- Solid solution softening mechanisms in Mg-Ca alloy
- Electronic Structure and Solid Solution Softening in Iron Alloys
- Effects of Hydrogen on the Mechanical Properties of Pure Magnesium
- Microstructure, Texture and Mechanical Properties of Mg-Zn-Ce Alloy Extruded at Different Temperatures
- Pancreatic division by electrocautery in pancreatoduodenectomy
- Elastic and damping properties of AZ31 magnesium alloy sheet processed by high-temperature rolling
- Mechanism of Wave Excitation on a Liquid Metal Surface Submerged in an Intermittent Alternating Magnetic Field
- Abnormal Hydrogen Absorption/Desorption Properties of Nanoporous Pt with Large Lattice Strains
- A neuroradiological study of optic neuritis using short inversion time inversion recovery (STIR) sequence of MRI
- Effects of Ca on Tensile Properties and Stretch Formability at Room Temperature in Mg-Zn and Mg-Al Alloys
- Solid Solution Softening Mechanisms in Mg-Ca Alloy
- Elastic and Damping Properties of AZ31 Magnesium Alloy Sheet Processed by High-Temperature Rolling
- Energy Absorption and Crushing Behaviour of Foam-Filled Aluminium Tubes
- First-Principles Study on Enhanced Grain Boundary Embrittlement of Iron by Phosphorus Segregation
- Fluid Conductivity of Porous Aluminum Fabricated by Powder-Metallurgical Spacer Method
- Preparation of Nanoporous Ruthenium Catalyst and Its CO Oxidation Characteristics
- Enhancement of Room Temperature Stretch Formability of Mg-1.5mass%Mn Alloy by Texture Control