Comparison of Mechanical Properties of Thin Copper Films Processed by Electrodeposition and Rolling
スポンサーリンク
概要
- 論文の詳細を見る
- Japan Institute of Metalsの論文
- 2007-09-01
著者
-
Hakamada Masataka
Materials Research Institute For Sustainable Development National Institute Of Advanced Industrial S
-
Mabuchi M
Department Of Energy Science And Technology Graduate School Of Energy Science Kyoto University
-
Hakamada Masataka
Department Of Energy Science And Technology Graduate School Of Energy Science Kyoto University
-
IWASAKI Hajime
The Materials Process Technology Center
-
NAKAMOTO Yoshiaki
Department of Energy Science and Technology, Graduate School of Energy Science, Kyoto University
-
CHEN Youqing
Department of Energy Science and Technology, Graduate School of Energy Science, Kyoto University
-
KUSUDA Hiromu
Department of Energy Science and Technology, Graduate School of Energy Science, Kyoto University
-
NAKAMOTO Yoshiaki
Graduate School of Energy Science, Kyoto University
-
MATSUMOTO Hiroshi
Graduate School of Energy Science, Kyoto University
-
IWASAKI Hajime
High Process Research Ltd. Co.
-
CHEN Youqing
Graduate School of Energy Science, Kyoto University
-
KUSUDA Hiromu
Graduate School of Energy Science, Kyoto University
-
MABUCHI Mamoru
Graduate School of Energy Science, Kyoto University
-
Chen Youqing
Department Of Energy Science And Technology Graduate School Of Energy Science Kyoto University
-
Chen Youqing
Graduate School Of Energy Science Kyoto University
-
Kusuda Hiromu
Department Of Energy Science And Technology Graduate School Of Energy Science Kyoto University
-
Mabuchi M
National Inst. Of Advanced Industrial Sci. And Technol. Nagoya Jpn
-
Nakamoto Yoshiaki
Department Of Energy Science And Technology Graduate School Of Energy Science Kyoto University
-
Hakamada Masataka
Dep. Of Energy Sci. And Technol. Graduate School Of Energy Sci. Kyoto Univ.
関連論文
- 2P2c-9 熱損傷を受けたグラナイトの非線形超音波計測(ポスターセッション)
- Tension/Compression Anisotropy in Hot Forged Mg-Al-Ca-RE Alloy
- Grain Refinement and Superplasticity Induced by Hot Compression of Continuously-Casted Mg-9Al-1Zn-1Ca and Mg-9Al-1Zn Alloys
- Effects of Homogenization Annealing on Dynamic Recrystallization in Mg-Al-Ca-RE (Rare Earth) Alloy
- Tensile Properties of Forged Mg-Al-Zn-Ca Alloy
- Effect of Annealing on Mechanical Properties and Nanoscale Lamellar Structure in Co-Cu Alloy
- New Step of Ecomaterial to Break through the Barrier between Ecomaterial-Selection and Eco-Design
- Barrier-Free Processing of Materials for Environmentally Benign Life-Cycle Design
- Preparation of Nanoporous Palladium by Dealloying : Anodic Polarization Behaviors of Pd-M (M = Fe, Co, Ni) Alloys
- Effects of Pore Characteristics Finely-Controlled by Spacer Method on Damping Capacity of Porous Aluminum
- Ferromagnetic Properties of Co-Cu Alloy with Nanoscale Lamellar Structure
- Effects of Vacancies on Deformation Behavior in Nanocrystalline Nickel
- Comparison of Mechanical Properties of Thin Copper Films Processed by Electrodeposition and Rolling
- Influence of Porosity and Pore Size on Electrical Resistivity of Porous Aluminum Produced by Spacer Method
- Fluid Conductivity of Porous Aluminum Fabricated by Powder-Metallurgical Spacer Method
- Fabrication of Porous Aluminum by Spacer Method Consisting of Spark Plasma Sintering and Sodium Chloride Dissolution
- Effect of Sintering Temperature on Compressive Properties of Porous Aluminum Produced by Spark Plasma Sintering
- Effect of Reduction Ratio of Hot-Extrusion on Microstructures of Superplastic Si_3N_4whisker/Al-Mg-Si Alloy Composites Studied by Transmission Electron Microscopy
- The Effect of Deformation Temperature on Microstructure and Superplastic Flow in Al-Cu-Mg/Si_3N_4p Composites
- Tensile Properties and Blow Forming of 5083 Aluminum Alloy Recycled by Solid-State Recycling
- Blow Forming of Mg Alloy Recycled by Solid-State Recycling
- Corrosion and Mechanical Properties of Recycled 5083 Aluminum Alloy by Solid State Recycling
- An Experimental Investigation of Effects of Specimen Size Parameters on Compressive and Tensile Properties in a Closed Cell Al Foam
- Solid Recycling of an AZ31 Mg Alloy with a Vapor Deposition Coating Layer of High Purity Mg
- Influence of Grain Size on Elongation at Elevated Temperatures in AZ31 Mg Alloy
- Mechanical Properties and Blow Forming of Rolled AZ31 Mg Alloy Sheet
- Tensile Properties of Directionally Solidified AZ91 Mg Alloy
- Tensile Properties from Room Temperature to 673K of Mg-0.9mass%Ca Alloy Containing Lamella Mg_2Ca
- Mechanical Properties and Press Formability at Room Temperature of AZ31 Mg Alloy Processed by Single Roller Drive Rolling
- Superplasticity and Cavitation of Recycled AZ31 Magnesium Alloy Fabricated by Solid Recycling Process
- The Critical Stress at the Interface for Cavity Nucleation in Superplastic Aluminum Matrix Composites Reinforced with Si_3N_4 Particles
- Tensile Properties at Room Temperature to 823K of Mg-4Y-3RE Alloy
- Solid recycling process for magnesium alloys
- Effects of Temperature and Strain Rate on Elongation at Elevated Temperature in Al-4.5Mg Alloy
- Compressive Deformation Behavior at Elevated Temperatures in a Closed-Cell Aluminum Foam
- Elevated Temperature Deformation and Fracture Mechanisms in High-Strain-Rate-Superplastic Si_3 N_/Al-Cu-Mg Composite
- OBSERVATION OF CAVITATION FORMATION IN A SUPERPLASTIC Si_3N_/Al-Mg-Si COMPOSITE AT HIGH STRAIN RATES
- Stress Exponent and Activation Energy in Titanium Aluminides with Different Grain Sizes
- Surface Evolution during Focused Iron Beam Micro-Machining in (001) Plane of Single-Crystalline Ni and Amorphous Nickel Alloy
- Bending Properties of Nanocrystalline Ni-18at% W Alloy Produced by Electrodeposition
- Role of the Co Phase in Superplasticity for WC-Co Cemented Carbides
- Effects of the Density on Compressive Properties in Cellular Aluminum Produced by the Sintering Method
- Fabrication of Porous TiAl Intermetallic Compound by Self -propagating High Temperature Synthesis
- Mechanical Properties of Binder-free WC Fabricated by PCS Process
- Compressive Deformation Characteristics of Open-Cell Mg Alloys with Controlled Cell Structure
- Compression Test Simulation of Controlled Cell Shape Open Cellular Magnesium Alloy under Dynamic Loading
- The Grain Size and Texture Dependence of Tensile Properties in Extruded Mg-9Al-lZn
- Forging Characteristics of AZ31 Mg Alloy
- グリーンタフ地域の石油,ガスおよび地熱貯留岩における蛍光法による空隙と微少割れ目の観察
- Effects of the WC Grain Size on the Surface Roughness of WC-10%Co Cemented Carbide Micro-Die Machined by FIB
- Relative Reactivity of Phenols and Formation of Phenolic Co-condensed Resins
- Self-aggregates of Highly Hydrophobic Phospholipid Polymers in Aqueous Solution
- Superplasticity of a Particle-Strengthened WE43 Magnesium Alloy
- Improvement of Crashworthiness in Ultra Lightweight Metallic Foam by Heat-Treatment for Microstructural Modification of Base Material
- 砂岩・花崗岩中の微少構造観察へのイメージ解析の応用
- Effects of Heat Treatment on the Compressive Properties of AZ91 Mg Foam
- Microstructure and Tensile Properties of Rolled Mg-5.5 mass% Zn-0.6 mass% Zr Alloy
- Effects of Cell Geometry on the Compressive Properties of Nickel Foams
- Ionic Liquid Molecules (ILs) as Novel Guests for Pillar[5]arene : 1:2 Host-Guest Complexes between Pillar[5]arene and ILs in Organic Media
- Preparation of High-molecular-weight Phenolic Resins by means of a Phase-separation Reaction System
- Synthesis of Phenolic Polymer-Coated Gold Nanoparticles
- Water Soluble Single-walled Carbon Nanotubes Using Inclusion Complex of Cyclodextrin with an Adamantane Derivative
- Transparent ionic liquid-phenol resin hybrids with high ionic conductivity
- Abnormal Hydrogen Absorption/Desorption Properties of Nanoporous Pt with Large Lattice Strains
- Characterization of reactive oxygen species-involved oxidative damage in Hapalosiphon species crude extract-treated wheat and onion roots
- Crude extract of the cyanobacterium, Hapalosiphon sp., causes a cessation of root elongation and cell division in several plant species
- Amidomethylation of Vinyl Aromatic Polymers with N-Methylol-2-chloroacetamide
- 3-D Fast Imaging Method for UWB Radar in Interference-Rich Environments with Global Optimization(WSANE 2008 (Workshop for Space, Aeronautical and Navigational Electronics))
- Frequency Warped Wiener Filtering for Mel-LPC based Speech Recognition
- Fluid Conductivity of Porous Aluminum Fabricated by Powder-Metallurgical Spacer Method
- Preparation of Nanoporous Ruthenium Catalyst and Its CO Oxidation Characteristics