Fabrication of Porous TiAl Intermetallic Compound by Self -propagating High Temperature Synthesis
スポンサーリンク
概要
- 論文の詳細を見る
- 粉体粉末冶金協会の論文
- 2003-11-15
著者
-
Mabuchi M
Department Of Energy Science And Technology Graduate School Of Energy Science Kyoto University
-
Mabuchi M
Department Of Energy Science And Technology Kyoto University
-
Yamada Y
Akita Univ. School Of Medicine Akita
-
Wen C
Institute For Structural And Engineering Materials National Institute Of Advanced Industrial Science
-
Mabuchi Mamoru
Institute For Structural And Engineering Materials National Institute Of Advanced Industrial Science
-
YAMADA Yasuo
Institute for Structural and Engineering Materials, National Institute of Advanced Industrial Scienc
-
Yamada Yasuo
Institute For Structural And Engineering Materials National Institute Of Advanced Industrial Science
-
Mabuchi M
National Inst. Of Advanced Industrial Sci. And Technol. Nagoya Jpn
-
Yamada Yasuo
Institute For Advanced Materidls Processing Tohoku University
関連論文
- Activation of Eosinophils by Rice-Husk Dust Exposure : A Possible Mechanism for the Aggravation of Asthma during Rice Harvest
- Effect of Annealing on Mechanical Properties and Nanoscale Lamellar Structure in Co-Cu Alloy
- New Step of Ecomaterial to Break through the Barrier between Ecomaterial-Selection and Eco-Design
- Barrier-Free Processing of Materials for Environmentally Benign Life-Cycle Design
- Effects of Pore Characteristics Finely-Controlled by Spacer Method on Damping Capacity of Porous Aluminum
- Ferromagnetic Properties of Co-Cu Alloy with Nanoscale Lamellar Structure
- Effects of Vacancies on Deformation Behavior in Nanocrystalline Nickel
- Comparison of Mechanical Properties of Thin Copper Films Processed by Electrodeposition and Rolling
- Influence of Porosity and Pore Size on Electrical Resistivity of Porous Aluminum Produced by Spacer Method
- Fluid Conductivity of Porous Aluminum Fabricated by Powder-Metallurgical Spacer Method
- Fabrication of Porous Aluminum by Spacer Method Consisting of Spark Plasma Sintering and Sodium Chloride Dissolution
- Effect of Sintering Temperature on Compressive Properties of Porous Aluminum Produced by Spark Plasma Sintering
- Effect of Reduction Ratio of Hot-Extrusion on Microstructures of Superplastic Si_3N_4whisker/Al-Mg-Si Alloy Composites Studied by Transmission Electron Microscopy
- The Effect of Deformation Temperature on Microstructure and Superplastic Flow in Al-Cu-Mg/Si_3N_4p Composites
- Corrosion Resistance and Adhesion Properties of the Chromium-Free Coating Using an Urethane-Base Resin for AZ91E Magnesium Alloy
- Tensile Properties and Blow Forming of 5083 Aluminum Alloy Recycled by Solid-State Recycling
- Blow Forming of Mg Alloy Recycled by Solid-State Recycling
- Corrosion and Mechanical Properties of Recycled 5083 Aluminum Alloy by Solid State Recycling
- An Experimental Investigation of Effects of Specimen Size Parameters on Compressive and Tensile Properties in a Closed Cell Al Foam
- Solid Recycling of an AZ31 Mg Alloy with a Vapor Deposition Coating Layer of High Purity Mg
- Influence of Grain Size on Elongation at Elevated Temperatures in AZ31 Mg Alloy
- Mechanical Properties and Blow Forming of Rolled AZ31 Mg Alloy Sheet
- Tensile Properties of Directionally Solidified AZ91 Mg Alloy
- Tensile Properties from Room Temperature to 673K of Mg-0.9mass%Ca Alloy Containing Lamella Mg_2Ca
- Mechanical Properties and Press Formability at Room Temperature of AZ31 Mg Alloy Processed by Single Roller Drive Rolling
- Superplasticity and Cavitation of Recycled AZ31 Magnesium Alloy Fabricated by Solid Recycling Process
- The Critical Stress at the Interface for Cavity Nucleation in Superplastic Aluminum Matrix Composites Reinforced with Si_3N_4 Particles
- Tensile Properties at Room Temperature to 823K of Mg-4Y-3RE Alloy
- Solid recycling process for magnesium alloys
- Effects of Temperature and Strain Rate on Elongation at Elevated Temperature in Al-4.5Mg Alloy
- Emergency Abdominal Surgery for Small Bowel Perforation Secondary to Metastatic Lung Cancer
- Expression of Ki-67 by Monoclonal Antibody MIB-1 in Carcinoma of the Middle and Lower Bile Duct
- Compressive Deformation Behavior at Elevated Temperatures in a Closed-Cell Aluminum Foam
- Elevated Temperature Deformation and Fracture Mechanisms in High-Strain-Rate-Superplastic Si_3 N_/Al-Cu-Mg Composite
- OBSERVATION OF CAVITATION FORMATION IN A SUPERPLASTIC Si_3N_/Al-Mg-Si COMPOSITE AT HIGH STRAIN RATES
- Stress Exponent and Activation Energy in Titanium Aluminides with Different Grain Sizes
- Prostaglandin D_2 and interleukin-5 reduce CRTH2 surface expression on human eosinophils
- Surface Evolution during Focused Iron Beam Micro-Machining in (001) Plane of Single-Crystalline Ni and Amorphous Nickel Alloy
- Bending Properties of Nanocrystalline Ni-18at% W Alloy Produced by Electrodeposition
- Role of the Co Phase in Superplasticity for WC-Co Cemented Carbides
- Effects of the Density on Compressive Properties in Cellular Aluminum Produced by the Sintering Method
- Fabrication of Porous TiAl Intermetallic Compound by Self -propagating High Temperature Synthesis
- Mechanical Properties of Binder-free WC Fabricated by PCS Process
- Compressive Deformation Characteristics of Open-Cell Mg Alloys with Controlled Cell Structure
- Compression Test Simulation of Controlled Cell Shape Open Cellular Magnesium Alloy under Dynamic Loading
- The Grain Size and Texture Dependence of Tensile Properties in Extruded Mg-9Al-lZn
- Forging Characteristics of AZ31 Mg Alloy
- Signet Ring Cell Carcinoma of the Stomach : A Clinicopathological Comparison with the Other Histological Types
- Effects of the WC Grain Size on the Surface Roughness of WC-10%Co Cemented Carbide Micro-Die Machined by FIB
- Superplasticity of a Particle-Strengthened WE43 Magnesium Alloy
- Improvement of Crashworthiness in Ultra Lightweight Metallic Foam by Heat-Treatment for Microstructural Modification of Base Material
- Effects of Heat Treatment on the Compressive Properties of AZ91 Mg Foam
- Microstructure and Tensile Properties of Rolled Mg-5.5 mass% Zn-0.6 mass% Zr Alloy
- Effects of Cell Geometry on the Compressive Properties of Nickel Foams
- Pancreatic division by electrocautery in pancreatoduodenectomy
- A neuroradiological study of optic neuritis using short inversion time inversion recovery (STIR) sequence of MRI
- Mechanical Properties of Microporous Aluminum Fabricated by Powder Metallurgy