Refining of Intermediate Transformation Microstructure by Relaxation Processing
スポンサーリンク
概要
- 論文の詳細を見る
The influence of RPC (relaxation-precipitation-controlling phase transformation) processing parameters on the microstructure was studied by thermo-simulation for a low carbon Nb and Ti containing microalloyed steel. The semi-quantitative statistic work of the packet size was carried out by the aid of optical microscope. TEM, EBSD and SEM were applied to investigate the microstructure refinement, precipitation, the evolution of crystal defects configuration and their interaction during the relaxation. The results demonstrate that the steel is composed of ultra-fine bainite/martensite composite microstructure, and the microstructure could be refined markedly by RPC processing. The best thermo-simulation process for refinement in this experiment is deformation by 30% at 850°C, and then relaxing at this temperature for 60 to 200 s. Increasing the reduction ratio from 30 to 60% or decreasing the deformation temperature to 800°C would cause the optimized relaxation time to become shorter, and increasing the deformation temperature to 900°C would cause the refinement effect to be weaker. It is also indicated that the nucleation, growing and coarsening of precipitates, and the dislocations polygonizing occur during the relaxation. Both two processes could be helpful to refine the intermediate transformation microstructure, and when these two processes corporate and promote each other, the optimized processing is obtained.
- The Iron and Steel Institute of Japanの論文
- 2002-12-15
著者
-
YANG S.
Department of Biomedical Engineering, University of Iowa
-
HE X.
Department of Human and Information Science, School of Information Technology and Electronics, Tokai
-
Wang X.
Department Of Biomedical Sciences Baylor College Of Dentistry Texas A&m Health Science Center
-
Shang C.
Department Of Materials Physics University Of Science And Technology Beijing
-
Wu H.
Department Of Prosthodontics Peking University School And Hospital Of Stomatology
関連論文
- Comparative Biomechanical Analysis of a Cervical Cage Made of an Unsintered Hydroxyapatite Particle and Poly-L-Lactide Composite in a Cadaver Model
- High Pressure Raman Study and Phase Transitions of KIO_3 Non-Linear Optical Single Crystals
- Pressure-Induced Phase Transitions of KTiOAsO_4 by Raman Spectroscopy
- Fabrication of Hierarchically Structured Zeolites through Layer-by-Layer Assembly of Zeolite Nanocrystals on Diatom Templates
- Fabrication of Hollow Zeolite Fibers through Layer-by-Layer Adsorption Method
- Evaluation of Adding Fluoride in Restorative Composite Materials
- Key Proteolytic Cleavage Site and Full-length Form of DSPP
- Effect of Process Temperature on SiC MOS Properties
- Flow Visualization and Laser Measurement on Particle Modulation to Gas-Phase Turbulence
- Interface Formation and Electrical Properties of TiO_xN_y/HfO_2/Si Structure
- Fabrication Technique of High Density Quantum-Wire Arrays by Photolithography and Metalorganic Chemical Vapor Deposition
- Glycosaminoglycan Chain of Dentin Sialoprotein Proteoglycan
- W02-1-(3) PRECONDITIONING OF LINEAR SYSTEMS IN FLUID FLOW SIMULATIONS(International Minisymposium on Challenger and Advances in Flow Simulation and Modeling,Mechanical Engineering Congress, 2005 Japan (MECJ-05))
- Estimation of True Growth Yield and Maintenance Parameters for Methanol Utilizing Organisms
- EFFECT OF ETHANOL ON VOLTAGE-OPERATED Ca^ CHANNELS IN HEPATIC STELLATE CELLS
- EDA Gene Mutations Underlie Non-syndromic Oligodontia
- Derivation of a Practical Experimental Formula for the ABR and its Consideration of Ergonomic Estimate Factor(SCHOOL OF INFORMATION TECHNOLOGY AND ELECTRONICS)
- Laser Beam Welding of 2205 Duplex Stainless Steel with Metal Powder Additions
- IL-1α Stimulates Cathepsin K Expression in Osteoclasts via the Tyrosine Kinase-NF-κB Pathway
- Numerical study of gas fluidization under increased 'gravity'
- Activation of GABAergic Neurons following Tooth Pulp Stimulation
- Eclogites of southern Henan and northern Hubei Provinces, central China
- Nitric Oxide in Pulp Cell Growth, Differentiation, and Mineralization
- Be Effect on Glass-Forming Ability and Mechanical Properties of Ti-Cu-Co-Zr-Sn Bulk Metallic Glasses
- Analysis of DC Characteristics and Small Signal Equivalent Circuit Parameters of GaAs Metal–Semiconductor Field Effect Transistors with Different Gate Lengths and Different Gate Contours by Two-Dimensional Device Simulations
- Refining of Intermediate Transformation Microstructure by Relaxation Processing