Optimal Trajectory Planning Method Using Inequality State Constraint for a Biped Walking Robot with Upper Body Mass
スポンサーリンク
概要
- 論文の詳細を見る
For studies of biped walking robots, energy-efficiency is an important issue. We have proposed an optimal-trajectory planning method based on a function approximation method, and applied it to a 2D biped walking model. With this method, we obtained the solution of minimal square integration value of the input torque. Previously in the literature, this method included only an equality state constraint. However, in this paper, we include an inequality state constraint to restrict the joint-angle range. In addition, walking experiments were performed to verify the effectiveness of this method. Results showed that stable walking of a 0.6 s period and 0.3 m/s speed was realized. Finally, we evaluated the robot's energy-efficiency using Specific Cost analysis.
- 一般社団法人 日本機械学会の論文
著者
-
Ono Kyosuke
Department Of Mechanical And Control Engineering School Of Engineering Tokyo Institute Of Technology
-
Huang Qingjiu
Department Of Mechanical And Control Engineering Tokyo Institute Of Technology
-
ONO Kyosuke
Department of Mechanical and Control Engineering, Tokyo Institute of Technology
-
HASE Takamasa
Department of Mechanical and Control Engineering, Tokyo Institute of Technology
関連論文
- MC-33 DESIGN OF A HIGH NATURAL FREQUENCY POSITIONING MECHANISM
- Nonlinear Bending Vibration of a Rapidly Driven Flexible Arm
- P-HDI-07 2-DOF ANALYSIS OF FRICTION-INDUCED SLIDER VIBRATIONS IN A NEAR-CONTACT REGIME
- P-HDI-08 Identification of Stiffness and Damping in Collision of a Spherical Slider with a Magnetic Disk
- Vibrationless Starting and Stopping Control for a Flexible Arm
- Gastric Cancer with Virchow's and Multiple Lung Metastases Showing a Remarkable Response to Preoperative Chemotherapy : Report of a Case
- Pressure Distribution of Oil Film Caused by Unbalance Whirl
- MC-25 Stability Analysis of Disk Spindle Supported by a Full Cylindrical Journal Bearing and Pivot Bearing
- T-4-3-3 Giant-swing motions of a 3-DOF Link Mechanism
- Circumferentially Grooved Hydrostatic Gas Journal Bearing
- On the Vibrations of Horizontal Shaft Supported in Oil Lubricated Journal Bearings
- Whirl Instability of Externally Pressurized Gas Journal Bearing
- Stress Analysis of a New Disk-Type Variable Torque Slipping Clutch with Skewed Rollers
- Studies on Contact Geometry and Limiting Resistant Torque Characteristics of the Variable Torque Slipping Clutch with Skewed Rollers
- High-Speed Motion Control of Mechanisms under Average Heat Generation Restriction : Minimum-Time Trajectory Planning of Robotic Manipulator and Calculated Examples of Two Degree-of-Freedom System
- Proposal of a Six-Legged Mini-Shovel and Its Mechanism Design and Walking Analysis Based on Static Analysis and a Computer-Aided Design Dynamic Model
- Numerical Analysis of Energy-Efficient Walking Gait with Flexed Knee for a Four-DOF Planar Biped Model(Bioengineering)
- A Study on the Propulsive Mechanism of a Double Jointed Fish Robot Utilizing Self-Excitation Control(Advances in Motion and Vibration Control Technology)
- Self-Excited Vibratory System for a Flutter Mechanism(Special Issue on Nonlinear Dynamics)
- Development of Multi-Legged Walking Robot Using Reconfigurable Modular Design and Biomimetic Control Architecture
- Optimal Trajectory Planning Method Using Inequality State Constraint for a Biped Walking Robot with Upper Body Mass