On the Vibrations of Horizontal Shaft Supported in Oil Lubricated Journal Bearings
スポンサーリンク
概要
- 論文の詳細を見る
Based on a pressure solution for an infinitely long journal bearing clarified in the previous paper, the vibrations of a rotating shaft which is supported in oil lubricated journal bearings is investigated theoretically and experimentally. The results are as follows : 1) A system in which a rigid shaft is supported in oil lubricated journal bearings has in general an angular natural frequency slightly less than ω/2 (ω is angular velocity of rotating shaft). Although the free vibration with angular frequency about ω/2 is stable at low rotational speeds, it becomes self-excited when the rotational speed increases to a high enough value. 2) In the case of a flexible shaft, the system has three angular natural frequencies, one of which is slightly less than ω/2 and the others are nearly equal to Ω (Ω is a fundamental angular frequency of flexural vibration of the shaft). Only one of the vibrations with frequency Ω becomes unstable when the rotational speed increases above about twice the critical speed of the shaft.
- 一般社団法人日本機械学会の論文
著者
-
TAMURA Akiyoshi
Tokyo Institute of Technology.
-
Ono Kyosuke
Department Of Mechanical And Control Engineering School Of Engineering Tokyo Institute Of Technology
関連論文
- Vibration of a Shaft Passing through a Critical Speed : 1st Report Experiments and Numerical Solutions
- MC-33 DESIGN OF A HIGH NATURAL FREQUENCY POSITIONING MECHANISM
- Multi-plane Balancing of Flexible Rotor Consisting of Two Disks
- Vibration of a Shaft Passing through a Critical Speed : 2nd Report, Approximate Equations
- Nonlinear Bending Vibration of a Rapidly Driven Flexible Arm
- P-HDI-07 2-DOF ANALYSIS OF FRICTION-INDUCED SLIDER VIBRATIONS IN A NEAR-CONTACT REGIME
- Stability of a System Consisting of Flexible Rotor and Flexibly Mounted Journal Bearings
- P-HDI-08 Identification of Stiffness and Damping in Collision of a Spherical Slider with a Magnetic Disk
- Vibrational Characteristics of Friction Between Gear Teeth
- Experimental Study of Whirl Instability for Externally Pressurized Air Journal Bearings
- Vibrationless Starting and Stopping Control for a Flexible Arm
- Gastric Cancer with Virchow's and Multiple Lung Metastases Showing a Remarkable Response to Preoperative Chemotherapy : Report of a Case
- Pressure Distribution of Oil Film Caused by Unbalance Whirl
- MC-25 Stability Analysis of Disk Spindle Supported by a Full Cylindrical Journal Bearing and Pivot Bearing
- T-4-3-3 Giant-swing motions of a 3-DOF Link Mechanism
- Circumferentially Grooved Hydrostatic Gas Journal Bearing
- On the Vibrations of Horizontal Shaft Supported in Oil Lubricated Journal Bearings
- Whirl Instability of Externally Pressurized Gas Journal Bearing
- Stress Analysis of a New Disk-Type Variable Torque Slipping Clutch with Skewed Rollers
- Studies on Contact Geometry and Limiting Resistant Torque Characteristics of the Variable Torque Slipping Clutch with Skewed Rollers
- Coupled Torsional-flexural Vibration of a Shaft in a Geared System of Rotors : 1st Report
- High-Speed Motion Control of Mechanisms under Average Heat Generation Restriction : Minimum-Time Trajectory Planning of Robotic Manipulator and Calculated Examples of Two Degree-of-Freedom System
- Numerical Analysis of Energy-Efficient Walking Gait with Flexed Knee for a Four-DOF Planar Biped Model(Bioengineering)
- A Study on the Propulsive Mechanism of a Double Jointed Fish Robot Utilizing Self-Excitation Control(Advances in Motion and Vibration Control Technology)
- Self-Excited Vibratory System for a Flutter Mechanism(Special Issue on Nonlinear Dynamics)
- Optimal Trajectory Planning Method Using Inequality State Constraint for a Biped Walking Robot with Upper Body Mass