E310 HEAT TRANSFER CHARACHTERISTICS OF PARTICLE CONVECTION IN FLUIDIZED-BED(Boiler-2)
スポンサーリンク
概要
- 論文の詳細を見る
The particle convection can be considered as one of dominant factors of the heat transfer mechanism in fluidized-bed. But the estimation of the effect of particle convection in the actual fluidized-bed is very difficult owing to the complicated particle movement. In this investigation, thus, heat transfer experiment under controlled particle convection was conducted by using the cylinder-shaped fluidized-bed equipped with a stirrer. The cylinder diameter was 115 mm, and the stainless foil heater was attached on the inner surface of the cylinder. The bed material was the silica sand, and average particle diameter was 0.175 mm. The static bed height was 200 mm. As the results, the heat transfer characteristics were measured under arbitrary particle velocities, and showed a strong relationship with the residence time among the heating surface. The experimental result has been well explained by using the numerical calculation with the Molerus's effective thermal conductivity with the considering of the gas convection.
- 一般社団法人日本機械学会の論文
- 2009-11-16
著者
-
OZAWA Mamoru
Department of Mechanical Engineering, Kansai University
-
Ozawa Mamoru
Department Of Mechanical Engineering Kansai University
-
UMEKAWA Hisashi
Department of Mechanical Engineering, Kansai University
-
OTSUKA Mario
Department of Mechanical Engineering, Kansai University
-
AMI Takeyuki
Department of Mechanical Engineering, Kansai University
-
HAYAMA Miho
Department of Mechanical Engineering, Kansai University
-
Hayama Miho
Department Of Mechanical Engineering Kansai University
-
Otsuka Mario
Department Of Mechanical Engineering Kansai University
-
Ami Takeyuki
Department Of Mechanical Engineering Kansai University
-
Umekawa Hisashi
Department Of Mechanical Engineering Kansai University
関連論文
- Low NOx Combustion of DME by Means of Flue Gas Recirculation
- Development of Low-NOx DME Multi-Port Burner(International Conferences on Power and Energy)
- Development of Tube-Nested Combustor with Transpiration Air Supply
- Characteristics of Bed-Material Behavior and Heat Transfer around Vertical Tube Banks in a Fluidized Bed
- Characteristics of Heat Transfer and Bed Material Movement around Vertical Tube in Fluidized Bed
- B205 DISTRIBUTION OF VOID FRACTION AND HEAT TRANSFER COEFFICIENT AROUND VERTICAL TUBE BANKS IN FLUIDIZED BED
- Dryout in a Boiling Channel under Oscillatory Flow Condition
- E310 HEAT TRANSFER CHARACHTERISTICS OF PARTICLE CONVECTION IN FLUIDIZED-BED(Boiler-2)
- DME-Fired Water-Tube Boiler : A R&D Study(International Conferences on Power and Energy)
- Development of Low-NO_x Emission DME (Dimethyl Ether) Combustor(International Conferences on Power and Energy System)
- Diffusion Combustion in a Tube-Nested Combustor(International Conferences on Power and Energy System)
- D207 DEVELOPMENT OF LOW-NOx EMISSION DME (DIMETHYL ETHER) COMBUSTOR
- D201 DIFFUSION COMBUSTION IN A TUBE-NESTED COMBUSTOR
- A116 CONVECTIVE HEAT TRANSFER AND FLOW PATTERN IN A SIMULATED TUBE-NESTED COMBUSTOR(Advanced thermal system analysis-2)
- A PATTERN DYNAMICS APPROACH TO TWO-PHASE FLOW DYNAMICS
- Structure of Recirculation Flow Induced by an Annular Jet
- I101 FLOW PATTERN TRANSITION AND VOID FRACTION BEHAVIOR IN ADIABATIC OSCILLATORY TWO-PHASE FLOW(Multiphase flow dynamics/non-linearity)
- Stack Temperature Distribution in an Acoustic-Resonance Tube
- Experimental Study on Natural Convection and Heat Transfer in an Inclined Rectangular Enclosure
- C304 Mixed convection in a rectangular slender channel(Mixed convection)