Dryout in a Boiling Channel under Oscillatory Flow Condition
スポンサーリンク
概要
- 論文の詳細を見る
Premature dryout due to flow oscillation is a very important factor in designing boiling systems. The flow oscillation depends, in general, on system size and/or configuration, and therefore the relationship between the premature dryout and the flow oscillation has not been fully understood so far. In this investigation, a CHF experiment in a forced flow boiling channel under the oscillatory flow condition has been conducted. Numerical simulation has also been conducted based on the lumped-parameter model of the boiling channel. The simulation well represents the transient behavior of the dryout under the oscillatory flow condition.
- 一般社団法人日本機械学会の論文
- 1996-05-15
著者
-
Hibiki Takashi
Research Reactor Institute Kyoto University
-
MISHIMA Kaichiro
Research Reactor Institute, Kyoto University
-
Miyazaki Akira
熊本大学 薬 生体機能化学
-
OZAWA Mamoru
Department of Mechanical Engineering, Kansai University
-
Ozawa Mamoru
Department Of Mechanical Engineering Kansai University
-
Ozawa M
Kansai Univ. Osaka Jpn
-
UMEKAWA Hisashi
Department of Mechanical Engineering, Kansai University
-
MIYAZAKI Akira
Hirakawa Guidom Co.
-
Umekawa Hisashi
Department Of Mechanical Engineering Kansai University
-
Mishima K
Kyoto Univ. Res. Reactor Inst. Osaka Jpn
-
Mishima Kaichiro
Research Reactor Institute Kyoto University
-
MIYAZAKI Akira
Department of Biochemistry, Kumamoto University School of Medicine
関連論文
- Acyl Coenzyme A : Cholesterol Acyltransferase(ACAT)in Macrophage-Derived Foam Cells and Its Distribution in Human Organs
- Localization of Acyl Coenzyme A : Cholesterol Acyltransferase-1(ACAT-1)in Human Tissues and Macrophages
- Interfacial Area Transport of Bubbly Flow in a Small Diameter Pipe
- Influence of Scattered Neutrons on Void Fraction Measurement of Two-Phase Flow Using Thermal Neutron Radioscopy
- Low NOx Combustion of DME by Means of Flue Gas Recirculation
- Research Project on Accelerator-driven Subcritical System Using FFAG Accelerator and Kyoto University Critical Assembly
- Development of Low-NOx DME Multi-Port Burner(International Conferences on Power and Energy)
- Development of Tube-Nested Combustor with Transpiration Air Supply
- Experimental Study on Transient Boiling Heat Transfer in an Annulus with a Narrow Gap
- ICONE11-36177 EXPERIMENTAL STUDY ON TRANSIENT BOILING HEAT TRANSFER IN AN ANNULUS WITH A NARROW GAP
- Heat Transfer Study for Thermal-Hydraulic Design of the Soild-Target of Spallation Neutron Source
- 画像処理による細管内気液二相流界面輸送の計測(FR2 計測制御の最先端)
- ICONE11-36391 INTERFACIAL AREA TRANSPORT OF BUBBLY FLOW AT LOW LIQUID REYNOLDS NUMBER UNDER MICROGRAVITY ENVIRONMENT
- TED-AJ03-389 IMPROVED MEASUREMENT METHOD FOR INTERFACIAL AREA CONCENTRATION IN A LARGE DIAMETER TUBE
- Orientation Effects on Critical Heat Flux due to Flooding in Thin Rectangular Channel
- Characteristics of Bed-Material Behavior and Heat Transfer around Vertical Tube Banks in a Fluidized Bed
- Characteristics of Heat Transfer and Bed Material Movement around Vertical Tube in Fluidized Bed
- B205 DISTRIBUTION OF VOID FRACTION AND HEAT TRANSFER COEFFICIENT AROUND VERTICAL TUBE BANKS IN FLUIDIZED BED
- Dryout in a Boiling Channel under Oscillatory Flow Condition
- Two-phase Flow Patterns in a Four by Four Rod Bundle
- Surface Wettability Caused by Radiation Induced Surface Activation
- Effect of Surface Wettability Caused by Radiation Induced Surface Activation on Leidenfrost Condition
- ICONE11-36523 SURFACE WETTABILITY AND LEIDENFROST CONDITION ON OXIDIZED METALS CAUSED BY RADIATION INDUCED SURFACE ACTIVATION
- ICONE11-36015 ONE-DIMENSIONAL DRIFT-FLUX MODEL FOR DOWNWARD TWO-PHASE FLOW
- E310 HEAT TRANSFER CHARACHTERISTICS OF PARTICLE CONVECTION IN FLUIDIZED-BED(Boiler-2)
- DME-Fired Water-Tube Boiler : A R&D Study(International Conferences on Power and Energy)
- Development of Low-NO_x Emission DME (Dimethyl Ether) Combustor(International Conferences on Power and Energy System)
- Diffusion Combustion in a Tube-Nested Combustor(International Conferences on Power and Energy System)
- D207 DEVELOPMENT OF LOW-NOx EMISSION DME (DIMETHYL ETHER) COMBUSTOR
- D201 DIFFUSION COMBUSTION IN A TUBE-NESTED COMBUSTOR
- A116 CONVECTIVE HEAT TRANSFER AND FLOW PATTERN IN A SIMULATED TUBE-NESTED COMBUSTOR(Advanced thermal system analysis-2)
- Post-Dryout Heat Transfer Analysis Model with Droplet Lagrangian Simulation(International Conferences on Power and Energy)
- ICONE11-36016 MECHANISTIC MODELING OF ACTIVE NUCLEATION SITE DENSITY IN BOILING SYSTEMS
- A PATTERN DYNAMICS APPROACH TO TWO-PHASE FLOW DYNAMICS
- Structure of Recirculation Flow Induced by an Annular Jet
- I101 FLOW PATTERN TRANSITION AND VOID FRACTION BEHAVIOR IN ADIABATIC OSCILLATORY TWO-PHASE FLOW(Multiphase flow dynamics/non-linearity)
- Stack Temperature Distribution in an Acoustic-Resonance Tube
- ICONE11-36062 A STUDY ON THE CHARACTERISTICS OF UPWARD AIR-WATER TWO-PHASE FLOW ALONG A LARGE PIPE
- E110 EVALUATION OF CRITICAL HEAT FLUX FOR LATERALLY HALF-HEATED TUBE USING RIVULET FORMATION MODEL(Critical heat flux)
- H208 A NON-EQUILIBRIUM MECHANISTIC MEAT TRANSFER MODEL FOR POST-DRYOUT DISPERSED FLOW REGION(BWR thermal hydraulics)
- Experimental Study on Natural Convection and Heat Transfer in an Inclined Rectangular Enclosure
- C304 Mixed convection in a rectangular slender channel(Mixed convection)
- Acetylated Low Density Lipoprotein Reduces its Ligand Activity for the Scavenger Receptor After Interaction with Reconstituted High density Lipoprotein
- Application of Neutron Radiography to Visualization and Void Fraction Measurement of Air-Water Two-Phase Flow in a Small Diameter Tube.