1449 極細線材の静的機械的特性評価に関する研究(S20-1 材料特性評価(1),S20 実験力学的手法による材料・製品の評価)

概要

論文の詳細を見る
Recently, because the micro-machine is noticed and electronic equipments are made much lighter and smaller, the demand for micro materials is increasing. However the mechanical properties data of the micro materials obviously run short and the evaluation method of micro materials is different according to the researcher. Therefore, the establishment of the test method for the micro materials is very necessary. In this study, the tensile strength tests were carried out using the bonding wires of Cu, Al/Si 1% and Au as the material. Its diameter was 20μm. As the results, in the case of all materials, Young's modulus for gage length of 60mm agreed with that for gage length of 20mm. Therefore, it was found that Young's modulus could be measured with high accuracy. The mean of tensile strength for the bonding wires of Al/Si 1% with gage length of 60mm decreased 3% in comparison with that with gage length of 20mm. But the means of tensile strength for the bonding wires of Cu and Au were unaffected by gage length.
2005-09-18