PROPOSAL OF ELECTRO-MAGNETIC-SUSPENSION SYSTEM WITH TILTING CONTROL
スポンサーリンク
概要
- 論文の詳細を見る
This paper proposes a new Electro-Magnetic-Suspension (EMS) system which has the ability of self-banking in curve section. This new EMS system is able to tilt automatically corresponding to the magnitude of the centrifugal force. Four hybrid-magnets (HMs : combination of permanent and electro-magnet) are used to guide and suspend a vehicle at the same time, that is different to a conventional EMS system getting necessary force from a guidance system when running in sharp curve. The Nearly-Zero-Power control method is applied to minimize energy consumption of the HMs. Five degrees of freedom are considered in the simulation and experiment. The results of simulation and experiment show this new EMS system has the ability to tilt automatically corresponding to the magnitude of the centrifugal force, and cancel the constant disturbance forces added in five directions only with the attraction forces of the permanent magnets (PMs) in the HMs and the gravity of earth.
- 一般社団法人日本機械学会の論文
著者
-
Suda Yoshihiro
Center for Collaborative Research, The University of Tokyo
-
Iwasa Takashi
Institute of Industrial Science, The University of Tokyo
-
Komine Hisanao
Institute of Industrial Science, The University of Tokyo
-
Iwasa Takashi
Center Of Collaborative Research & Institute Of Industrial Science The University Of Tokyo
-
Iwasa Takashi
Center For Collaborative Research The University Of Tokyo
-
Komine Hisanao
Center Of Collaborative Research & Institute Of Industrial Science The University Of Tokyo
-
Suda Y
Center For Collaborative Research The University Of Tokyo
-
Suda Yoshihiro
Center Of Collaborative Research & Institute Of Industrial Science The University Of Tokyo
-
Chuang Chih
Ching-Yun Institute of Technology
-
Suda Yoshihiro
Center For Collaborative Research & Institute Of Industrial Science University Of Tokyo
-
Suda Yoshihiro
Center for Collaborative Research & Center of Institute of Industrial Science, The University of Tokyo
関連論文
- ACTIVE CONTROL OF THE MECHATRONIC VEHICLE
- A301 Evaluation of Running Motion with Simulation and Experimental Platform For Single-Axle Scale Model Vehicle
- Effect of Hypoxia on Lactate Variables during Exercise
- Anaerobic Threshold in Chronic Obstructive Pulmonary Disease
- C802 FEASIBILITY OF SELF-POWERED ACTIVE VIBRATION CONTROL APPLIED TO SUSPENSIONS OF RUBBER-TIRED VEHICLES
- Proposal of Electro-Magnetic-Suspension System with Tilting Control
- Vector Liapunov Function Approach to Longitudinal Control of Vehicles in a Platoon
- PROPOSAL OF ELECTRO-MAGNETIC-SUSPENSION SYSTEM WITH TILTING CONTROL
- A402 The Study on Control of Air Suspensions for Rail Vehicles Considering Tight Curving Performance : Experiments and Simulation Using The One-car-modeled Test Bench
- Absolutely exponential stability of a class of neural networks with unbounded delay
- T-3-2-2 Proposal of Simplified Real-Time Multibody Analysis Method for Driving Simulator
- PROPOSAL OF VIRTUAL PROVING GROUND WITH DRIVING SIMULATOR
- T-4-4-4 Contact Force Fluctuation between Rail and Wheel
- A Method to Apply Friction Modifier in Railway System(Intemational Symposium on Speed-up and Service Technology for Railway and MAGLEV Systems)
- D801 A METHOD TO APPLY ERICTION MODIFIER IN RAILWAY SYSTEM
- A603 Basic Study on Dynamic Simulator for Railway Riding Comfort Evaluation
- T-4-2-1 Curving Simulations and Comparison with Measurements for Railway Vehicles
- Development of driving simulator with full vehicle model of multibody dynamics
- Multistage and High-speed Compression Testing Machine for Obtaining Flow Stress and Microstructure Evolution in Hot Forming of Steels
- Modeling of Electromagnetic Damper for Automobile Suspension