階段漸増荷重法による硬鋼線の曲げ疲労限度の迅速測定

概要

論文の詳細を見る
The present writers have investigated the accelerated testing for predicting the fatigue limit of hard drawn steel wire by means of stepwise load increase test with Haigh-Robertson wire fatigue testing machine, and have cleared the simplified method for predicting the fatigue limit with only one loading rate. The principal results of this investigation can be summarized as follows : 1) The modified Prot method that takes the exponent n=0.40 in equation σ_R=σ_W+k・α^n, produces better agreement with conventional Wohler fatigue limit than does the original Prot method based n=0.50. 2) Stepwise load increase test using four loading rates with three specimens can reduce the fatigue testing time to one third as compared with conventional Wohler procedure. 3) Simplified method for predicting the fatigue limit with only one loading rate can be performed by increasing the division plate reading of head stock by 0.1 degree to every 50 000 cycles until the specimen (l=150d) breaks down. the starting stress is taken about 10% lower than the experientialy expected fatigue limit. for 0.6% carbon hard drawn steel wire, if the mean value of the stresses at failure for three specimens is divided by 1.09, a value close to Wohler fatigue limit, with an error less±3.2%, may be obtained. the testing time can be reduced to one sixth as compared with that of conventional Wohler procedure.
社団法人日本材料学会の論文
1964-04-15