光弾塑性法による混合U-V切欠きをもる平板の応力解析

概要

論文の詳細を見る
In this paper, an experimental stress analysis is reported on flat plates with mixed U-V notches by the photoelasto-plastic method. The model material used is nitro-cellulose. As the preliminary experiment the yield condition of the material and its mechanical and optical properties in the plastic as well as in the elastic region were investigated. From the experimental result of the tension-torsion test using thin-walled pipes cut from the same material, it was found that the yield condition agreed with the Mises' criterion. And the bi-axial tension-tension and tension-compression tests revealed the fact that the stress sensitivity in the plastic region was governed by the equivalent stress. The tensile loads were applied to the specimens with mixed U-V notches in six steps. The first step was the load which produced a primary yielding at the notch root, and the last step the load causing the penetration of plastic region through the minimum cross section. For the stress analysis in the plastic range, the Mises' yield criterion and the Prandtl-Reuβ incremental strain law were adopted. The fringe order increments dN obtained photoelasto-plastically and the principal strain increments dε_3 determined from the electrical analogy method allow the separation of principal stress increments (dσ_1 and dσ_2). From these values the principal strain increments dε_1 and dε_2 may be calculated. The principal stress σ_2 and the principal strain ε_2 in the minimum cross section were much smaller than the other values σ_1 and ε_1. It has been found as the result of this experiment that the plastic regions generated on both sides of the notches are united to a fairly large extent, including several maximum fringe order points on the longitudinal central axis.
社団法人日本材料学会の論文
1970-02-15

光弾塑性法による混合U-V切欠きをもる平板の応力解析

スポンサーリンク

概要

著者

関連論文

スポンサーリンク