双ロール式ストリップ鋳造における鋳片表面性状とメニスカス形状の関係

概要

論文の詳細を見る
Experiments of laboratory scale twin roll casting to observe strip surface quality and to detect contact point between molten metal and roll by immersing a refractory bar into the molten metal pool have been done using stainless and carbon steels and copper alloy to elucidate the relation between surface quality and meniscus behavior of molten metal. Furthermore, dynamic meniscus profile near the roll surface and critical casting speed controlling surface wrinkles have been theoretically analyzed. With increasing casting speed, the depth of surface wrinkles became shallow and the flat surface was obtained. The observed critical speed for the wrinkle-free surface was roughly 0.45 to 0.6m/s for the cast metals. By the immersion of refractory bar over a depth, the solidification of columnar dendrite zone was delayed and the surface wrinkle was resultantly taken place. With increasing casting speed, the depth of bar to result in surface wrinkles increases and the contact point between molten metal and roll moves downward. It has been theoretically found that the descent of meniscus increases with increasing casting speed and surface tension of molten metal and with decreasing the density. The surface wrinkle does not appear when the descent of meniscus is deeper than a critical value, because vibration of the molten pool surface due to the teeming flow becomes less influential for the contact point. A theoretical equatio of the critical speed for preventing surface wrinkles has been presented to show that it increases with increasing the critical descent of meniscus and the density and with decreasing the surface tension.
社団法人日本鉄鋼協会の論文
1995-06-01

双ロール式ストリップ鋳造における鋳片表面性状とメニスカス形状の関係

スポンサーリンク

概要

著者

関連論文

スポンサーリンク