ホーニング加工における加工物の熱変形(第5報) : 加工物熱容量および砥石種類の影響

概要

論文の詳細を見る
This paper presents the experimental analyses of thermal deformation of cylindrical work-piece. The deformation depends upon the heat capacity of Workpiece and the kind of honing stone applied. Thermal effect due to the heat capacity becomes clear from the measurement of temperature increase of the workpieces with 2.9,5.4,10 and 20mm thickness respectively. In wet honing the temperature of workpiece with small heat capacity increases soon after the honing start. Therefore the thermal deformation is not small even if honing time is short. After several minutes the value of thermal deformation of thin workpiece is nearly the same as one of thick workpiece under wet honing. Temperature increase of workpiece is observed by varying three basic characters of the honing stone ; grain size, stone hardness and filling-up material. The temperature increase is high under the condition with remarkable wear dimen-sion of honing stone. From a viewpoint of thermal deformation, it is better to avoid a honing stone with too fine grain and a too soft honing stone. The thermal deformation in case of honing stone filled-up with sulphur is nearly the same as one of nonfilled stone. In contrast, a honing stone filled-up with paraffin causes a larger thermal deformation in the workpiece.
公益社団法人精密工学会の論文
1985-12-05